In this paper, a design of digital stored oscillograph display system based on DSP is presented.
本文提出了一种基于DSP的数字存储示波器显示系统的设计方案。
At last, PCI9052 read the spectrum data stored in DSP and display in computer, too.
最后，dsp中的频谱数据经pci9052读入计算机并显示出实时频谱。
At first, hardware circuit of the system has been designed, including minimum system of DSP, sampling pretreatment, dead zone formation, constant amplitude control and display circuit.
本文首先设计了系统的硬件电路，包括DSP的最小系统电路、采样预处理电路、输出信号死区形成电路、恒幅控制电路和显示电路。
The system is composed of DSP, MPU and front channel modules to perform signal collection, data processing, output display, danger alarming and other functions.
系统由dsp、MPU和前向通道等模块组成，完成信号采集、数据处理、显示输出、报警提示等功能。
The DSP is the video processing core unit; And the video capture unit, the video pre-processing unit, the video display unit are implemented in the FPGA.
系统中dsp承担核心的视频图像处理任务，而FPGA则作为视频采集单元，预处理单元以及视频显示单元。
It is introduced that a design method of DSP controller which is applied to control Chinese characters and graphics display in a LCD based on inner T6963C controller.
介绍了一种DSP控制器的设计方法，用于对内藏t 6963 C控制器液晶模块进行汉字图形显示控制。
Circuitry involve LED drive circuit, signal modulation circuit, DSP circuit and display circuit.
硬件电路系统包括LED光源驱动电路、信号调制电路、DSP硬件电路、显示电路。
This scheme can fully display the strengths of DSP and FPGA respectively.
这样的方案可以充分发挥DSP和FPGA各自的优势。
Using CCD camera, video decoding chip, DSP to set up a hardware, embodied the software, it can examine the volume, display the result and auto alarm.
使用CCD摄像机、视频解码芯片、DSP搭建硬件平台，并嵌入软件识别检测容量算法，可实时显示容量值，并有自动报警功能。
This paper presents a system consisting of DSP and IBMPC for a 2 D image sonar data acquisition, processing and display.
介绍了一种由DSP和IBMPC计算机构成的二维图像声呐的数据采集、处理与显示系统。
Hardware includes receiving and amplification of signal, data acquisition, memory, display and DSP processor.
硬件包括信号接收与放大，数据采集、存储、显示和DSP处理器系统。
The form of smell sensor arrays and collected data were investigated, as well as the circuit of sensor and DSP and the circuit of video display interface.
研究气味传感器阵列的组成形式以及其采集到的数据，设计了传感器与DSP的接口数据采集电路以及视频显示接口电路。
TMS320LF2407A DSP drives the liner CCD to collect interference pattern signal, complete A/D conversion, compute 2048 point FFT, and drive LCD to display the result.
该光谱仪通过DSP来驱动线阵CCD、采集干涉信号、完成模数转换、实现2048点FFT计算、并驱动LCD显示器显示测量结果。
The system circuits are based on DSP and single chip computer, and can calculate the target's position information by using received acoustic signal, and display its moving curve timely on PC.
系统硬件以DSP和单片机为核心，能够通过接收到水下目标发射的合作声信号，实时准确的解算出水下目标的方位参数，并能在PC机上显示目标的运动曲线。
We use the serial display module LCD module is connected through the RS232 interface and DSP to achieve real-time display of measured data.
显示模块采用串行的液晶模块通过RS232接口和DSP相连，实现测量数据的实时显示。
A display program that LCD display module controled by DSP has been adopted, and the system's hardware and software are analyzed.
采用了一种DSP控制LCD模块的显示方案，并对系统的硬件和软件进行了分析。
A display program of LCD display module controlled by DSP has been adopted, and the systems hardware and software are analyzed.
采用了一种DSP控制LCD模块的显示方案，并对系统的硬件和软件进行了分析。
A display program of LCD display module controlled by DSP has been adopted, and the systems hardware and software are analyzed.
采用了一种DSP控制LCD模块的显示方案，并对系统的硬件和软件进行了分析。
应用推荐