Proficient in PLC programming (Siemens), human-machine interface touch screen, frequency converter, servo driver, stepper motor.
精通PLC编程（西门子、三菱），人机接口触摸屏、变频器、伺服驱动器、步进电机。
What we can see here is the metal sheet, this time connected to a sound driver, and being fed by a frequency generator.
在这里所看到的是金属板，这次是连接到一个声音驱动装置，由频率产生器送出振动。
The system bandwidth of conventional voltage-control-mode motor driver circuits is limited by the intrinsic frequency of the load, and its phase lag is also load-dependent.
传统电压控制模式的电机驱动电路系统频率都受电机的本征频率制约，其相位延迟会随负载的变化而变化。
Meanwhile, the driver had the functions of constant current chopper, index movements frequency and sine wave equal-breadth even subdivision.
驱动器具有恒流斩波、指数升降频和正弦波等幅均匀细分的功能。
The experiment for the noise at the area around the driver' s ears is conducted, the results show that this model can predict very well the interior noise around particular point in frequency domain.
并针对驾驶员耳旁噪声进行了实验研究，结果表明：基于神经网络的单一工况车内噪声预测模型，可在频域内很好地预测出特定点的车内噪声。
In order to meet the needs of variable pulse width, frequency and power for laser fuze, a model of the LD driver circuit is built up based on its principle.
为了满足引信用脉冲式半导体激光器驱动电路的脉冲宽度可调、频率可调、功率可调的需要，根据LD驱动电路的工作原理，建立LD驱动电路的一般模型，并进行了仿真分析。
Its character is that the DDFS is linked to a microcomputer bus through buffer driver to control frequency and phase. The necessary hardware and software are designed.
重点讨论了微机控制部分，其特点是把DDFS经缓冲驱动器直接挂到微机总线上，以实现频率与相位控制，设计了全部硬件和软件。
The paper mainly put forward a new control method of stepping motor which character-, ized by equal-stepped fine division, and then design a constant frequency PWM driver circuit.
提出一种等步距角的细分控制方法，并据此设计了恒频脉宽调制细分电路。
The driver operates in the pulse mode, and can generate drive signal whose repeat frequency and pulse interval is tunable.
驱动器工作在脉冲模式下，产生重复频率和脉冲间隔可调的驱动信号。
The result is smoother frequency response, greater driver efficiency, and improved vocal and instrument reproduction.
其结果是平滑的频率响应，更大的驱动效率，提高声乐和手段复制。
The SA4828 used as SPWM signal generator controls the IPM via driver circuits to produce variable frequency power supply.
它以SA 4828作为SPWM信号发生器，经过驱动电路控制IPM模块，产生三相变频电源。
Purpose: Audio frequency amplifier, driver stage amplifier applications.
用途：用于音频一般放大，驱动级放大。
The noise power, sound intensity, sound pressure, vibration acceleration and corresponding time-frequency spectrum of 6480 driver axle surface were measured and analysed.
通过对6480型驱动桥的噪声功率、表面声强、表面声压、表面振动加速度以及相应的时频谱进行了全面、系统的测量和分析。
These modules include the ring detection module, call filtering module, dual-tone multi-frequency decoder modules, voice prompt module and microprocessor controlled driver module.
这些模块包括振铃检测模块、来电过滤模块、双音多频解码模块、语音提示模块和单片机控制驱动模块。
Firstly, a two-dimensional servo-control driver circuit, which consists of PC and an embedded system, is designed based on the scanning requirement of the dual frequency millimeter wave radiometer.
第一，基于双频毫米波辐射计的扫描要求，设计了基于PC计算机和嵌入式系统道的两维伺服驱动电路，完成了扫描控制、通信协议和伺服驱动控制的软件设计。
Finally, through on-line debugging, the author realized the PMSM servo driver with functions of variable frequency speed regulation, parameter identification and parameters displaying.
最后，作者通过在线软、硬件调试，实现了具有变频调速、参数识别和参数显示等功能的永磁同步电机伺服驱动器的研制。
A spinning machine, especially a ring spinning frame, includes at least one driver started via one frequency converter and one central control unit for starting the frequency converter.
一种纺纱机，特别是一种环锭细纱机，包括至少一个能通过一变频器启动的驱动和一用来启动变频器的机器中央控制单元。
Its internal components available high-frequency and circuit protection with passive divider, high-frequency driver protection circuit to prevent high-overload damage.
其内部部件备有与高频保护电路在一起的无源分频器，高频保护电路可防止高音驱动器过载损坏。
WD-222 is a passive two sub-frequency sound, using a 12-inch long-stroke woofer driver and a 1-inch tweeter drive.
WD-222是一款二分频无源音箱，采用了一只12英寸超长冲程低音单元驱动器和一只1英寸高音单元驱动器。
Low-Frequency General-Purpose Amp, Driver, Muting Circuit Applications.
描述：低频通用放大器，驱动器，静音电路中的应用。
Outfitted with 1.75" compression driver on a 90 x 40 constant-directivity high frequency horn for uniform coverage and one 15" woofer in a 6-ply poplar plywood enclosure.
系统采用一个 1.75吋高音压缩驱动单元配合 90x40 恒定指向覆盖均匀的号角与及一个15 吋低音单元装配在以高硬度6层白杨木夹板为材料的音箱内。
Outfitted with 1.75" compression driver on a 90 x 40 constant-directivity high frequency horn for uniform coverage and one 15" woofer in a 6-ply poplar plywood enclosure.
系统采用一个 1.75吋高音压缩驱动单元配合 90x40 恒定指向覆盖均匀的号角与及一个15 吋低音单元装配在以高硬度6层白杨木夹板为材料的音箱内。
应用推荐