Chapter Six makes out the drive and control circuit of IGBT.
第六章着重对IGBT的驱动控制电路进行了说明。
Standing wave ultrasonic motors have many outstanding features for simple drive and control circuit, stationary speed of rotation, smaller undulation, etc.
其中驻波超声波电机具有驱动和控制电路简单，转速平稳，波动较小等突出优点。
The hardware system mainly includes rectifier and filter circuit, regulate voltage and inverter circuit, drive and control circuit, output circuit, protection circuit etc.
电源系统硬件部分主要包括整流滤波电路、调压及逆变电路、驱动及控制电路、输出电路、辅助保护电路等。
Presents the control principle of electromagnetic bearing and the requirements of the power drive circuit.
介绍了电磁浮轴承的控制原理及对功率驱动电路的要求。
This article introduced emphatically the control strategy, position detection and identification, drive technique as well as main circuit of permanent magnet Ac servo system.
重点介绍了永磁交流伺服系统的控制策略，位置检测和辨识、主电路和驱动技术等关键技术。
The third chapter mainly introduces the hardware design of soft starter, including the main circuit, control circuit, drive circuit, and protect circuit and auxiliary switched power design.
第三章详细介绍了软起动控制器的硬件设计，包括主电路、控制电路、驱动保护回路和辅助开关电源电路的分析和设计。
Then discuss the power drive circuit and the logic control circuit in detail.
并详细介绍了功率驱动电路及逻辑控制电路。
To control stepping motors, the balance bridge power drive circuit is made up by TDA1521 integrated audio power amplifier, the pulse allotter is made up by the parallel ports of computer and latches.
双回转机构的步进电机控制电路由TDA1521音频集成功率放大器组成平衡桥式功率驱动电路，由计算机并行口经过锁存器构成脉冲分配器。
The whole of this robot included dynamic system, mechanical system and control system. This control system mainly included PIC single chip, motor drive circuit, and sensor module.
该机器人由动力系统、机械系统和控制系统组成，其控制系统主要由PIC单片机、电动机驱动电路和传感器模块三部分组成。
This is a very big challenge, because gearshift solution needs the drive of more complex nicety and control circuit.
这是个很大的挑战，因为变速解决方案需要更简单慎密的驱动和节制电路。
This robot consists of dynamic system, mechanical system and control system. The control system mainly includes PIC single chip, motor drive circuit and sensor module.
该机器人由动力系统、机械系统和控制系统组成，其控制系统主要由PIC单片机、电机驱动电路和传感器模块三部分组成。
The controller make up of TMS320F2812 DSP chip, detecting circuits include sampling circuit, modulate circuit and phase locked loop and other periphery control and drive circuit.
本文设计的控制器以TMS320F2812DSP芯片为核心，加上检测电路（包括采样电路、调理电路、锁相环等）和其它外围控制和驱动电路构成。
Using PWM to drive motor, and we design a circuit in DC serve control system.
利用PWM驱动方式控制电机的转动，并设计出了直流伺服控制系统硬件电路图。
The control circuit of the probe has been divided into four modules, namely, infrared LED drive circuit module, monolithic processor control module, keys trigger module and data communication module.
光学测棒硬件控制电路划分为：LED驱动电路、单片机控制、按键触发和数据通信四个功能模块。
The design schemes of control circuit and drive circuit for selecting mechanism are described in detail.
并详细叙述了选针机构驱动电路的优化设计方案。
Next, the drive circuit between the control module and the actuator is designed and the driving principle is introduced.
随后又设计了控制模块和执行机构之间的驱动电路并且说明了电路的驱动原理。
This paper studied control system with the center of SPCE061A MCU, including the drive and soft-start circuit of two power supply, the key and distance control of the cleaner.
以SPCE061A单片机位核心，研制了高效、适用的控制系统，包括两个电源的驱动、软启动、净化器的按键及遥控等电路。
A hardware control system based on DSP TMS320F2808 was designed, including DSP base circuit, signal feedback circuit, drive circuit, wire driving circuit and protection circuit.
设计了以TMS320F 2808DSP为核心的硬件控制系统，包括DSP基本电路、信号反馈电路、驱动电路、送丝电路以及保护电路。
Using TMS320F2812 as the core of the control system, drive circuit, sampling circuit, protection circuits, man-machine interface circuit hardware components and control system software were designed.
以TMS320F2812为控制核心，设计了系统的控制驱动电路、采样电路、保护电路、人机接口…更多电路等硬件部分和控制系统软件。
This article presents a design of permanent magnetic brushless DC motor control system and mainly involves the hardware circuit design of speed closed loop and power module drive.
介绍了一种永磁无刷直流电机控制系统的设计方案，主要涉及速度闭环和功率模块驱动的硬件电路设计；并通过实验证明该设计可直接用于小型无刷直流电机的控制。
The basic program is that in the wiper circuit the power transistor and relay are connected in series to perform drive control.
主要方案是，在刮水装置回路中串接功率三极管或继电器实行驱动控制。
This control scheme consists of a modified motor winding and a drive circuit, in which the voltage vector is utilised in a mode similar to that of an AC drive.
这种控制方案包含一个改进的电机线圈和一个简单的驱动电路，在驱动电路中电压矢量的应用形式和交流电机驱动系统类似。
The flyback mode switch power supply is chosen as the main circuit of the high voltage power in the paper with 555 pulse control circuit and flyback drive circuit.
选择了反激式开关电源作为高压电源的主电路，并以555脉冲控制电路和反激式驱动电路作为辅助电路。
The experimental results show that the circuit designed is simple and reliable, the position signals measured match the requirements of the AC drive control system with high performance.
试验结果表明，该电路简单可靠，所测得的位置信号完全满足高性能交流传动控制系统的要求。
The power supply module provides the control circuit, the drive of frequency conversion circuit, transaction circuit and DSP with different power supply.
电源模块为系统控制电路、变频驱动电路、变送电路、DSP芯片提供不同要求的电源。
The circuit of Photoelectricity Weak Signal Detection, preamplifier circuit, difference circuit, modulation circuit, optical source thermal control and current drive circuit etc. are designed.
设计实现了基于差分后谐波检测的微弱信号处理电路、前置放大电路、差分电路、调制电路和光源温度控制电路及电流驱动电路等。
The circuit of Photoelectricity Weak Signal Detection, preamplifier circuit, difference circuit, modulation circuit, optical source thermal control and current drive circuit etc. are designed.
设计实现了基于差分后谐波检测的微弱信号处理电路、前置放大电路、差分电路、调制电路和光源温度控制电路及电流驱动电路等。
应用推荐