Using the system to draw piping figure, can enhance far and away drawing velocity .
使用本系统绘制配管图，可以极大地提高绘图速度。
Data of drawing velocity that is automatically measured by precise extrusion were analyzed.
对精密挤出控制系统自动测量的牵引速度数据进行了分析。
The results show that the maximum temperature of the die has a nearly linear increase with the increase of drawing velocity or the increase of friction coefficient.
结果表明，模具最高温度随拉拔速度的增加和摩擦系数的增加都是近似线性的增加；
In addition, the decline of the temperature, the raise of the drawing velocity, the raise of the friction coefficient all could lead to the increase of the maximum stroke force.
另外，拉深温度的降低，冲压速度的增加，摩擦系数的增大都会使拉深时的最大冲程力增大。
The effects of spinning temperature, spinning pressure and drawing velocity on the degree of profile and effective diameter of the fibers were studied and the preparation technology was determined.
研究了纺丝温度、压力、牵伸速度对纤维异形度和当量直径的影响，确立了异型截面碳化硅纤维的制备工艺。
In this paper, the method for drawing grid-based terrain, contour, and velocity field and wave surface are studied.
本文研究了计算网格地形、波高等值线、速度场和波面的可视化。
The practice shows that the flow velocity of bulk ore rock at the stope drawpoint and the dimensions of drawpoint have remarkable influence on the drawing effect.
实践证明，采场放出口矿岩散体速度分布和放出口尺寸对放矿结果有显著影响。
A kinematically admissible continuous velocity field is established and applied to the plane strain due to drawing, and the upper-bound analytical solution is obtained.
对平面变形拉拔问题建立了运动许可的连续速度扬并获得上限解析解。
A general dynamically permissible velocity field for plane flow is set up in the paper. The force and energy parameters for extrusion (or drawing) are analyzed, and the optimum draw Angle is obtained.
本文建立了平面流动较为一般化的动可容速度场，分析了平面挤压(拉拔)的力能参数，获得了最佳凹模锥角。
The fairly good structure of PGA fiber can be obtained at low spinning velocity and high after-drawing ratio.
采用低速纺丝高倍后拉伸的工艺路线可以得到具有较好结构的PGA纤维。
In this paper, flange area of sheet metal was the research object, influence curves and data of each stamping parameters to the forming velocity were obtained through the simulations of deep drawing.
本文以板料法兰区为研究对象，通过对拉深成形过程进行仿真得到各冲压参数对成形速度的影响曲线及数据。
In this paper, flange area of sheet metal was the research object, influence curves and data of each stamping parameters to the forming velocity were obtained through the simulations of deep drawing.
本文以板料法兰区为研究对象，通过对拉深成形过程进行仿真得到各冲压参数对成形速度的影响曲线及数据。
应用推荐