The influence of loading distribution stress path and nonlinear deformation on foundation behaviour are studied in this paper. A new settlement formula for foUndations is proposed.
本文研究了荷载分布、应力路径和非线性变形对地基性状影响。提出了一个新的基础沉降量计算公式。
Sculptures must, for example, be stable, which requires an understanding of the properties of mass, weight distribution, and stress.
例如，雕塑必须是稳定的，这就需要理解质量、重量分布和压力的特性。
The problem of distribution, on which all the stress is being put today, is after all more easily solved the more there is to distribute.
今天人们极力强调的分配问题，如果有更多的产品可供分配，终归是更容易得到解决。
This paper discusses the common problems in the design of frame calculation sketch and stress distribution at corner of the jetted plate.
本文试对框架的计算简图和悬挑板转角处应力分布两个设计中常见的问题作一探讨。
The interaction between casting and mold has a significant effect on the distribution of thermal stress during solidification.
铸件-铸型之间的相互作用对铸件凝固过程中热应力的分布有很大的影响。
This method differs greatly from the present general calculation method in the stress distribution of controlled section.
此法与一般的计算方法相比在控制截面的应力分布方面有大的差别。
The problem of distribution on which all the stress is being put today, is after all more easily solved the more there is to distribute.
今天人们极力强调的分配问题，如果有更多的产品可供分配，终归是更容易得到解决。
Only if this short crack extends long enough and blunted wide enough, can it affect the principal crack extension and the distribution of stress and plastic strain.
只有小裂纹扩展到足够长并钝化到足够宽，才能够影响主裂纹的扩展及其前端应力、应变的分布。
And reach a conclusion in the tunnel and stability of the surrounding rock, rock deformation, stress distribution, economic and technical aspects of security.
并且分别从隧道围岩稳定性方面、围岩变形方面、应力分布方面、经济和技术方面以及安全方面得出结论。
This results in uneven distribution of stress transmission to deeper layers of cartilage and to the underlying subchondral bone.
这导致应力分布不均匀地传导至深层软骨及其下面的软骨下骨。
Through a large amount of calculation, the stress distribution Pattern of beam axle is obtained for some main load cases.
通过大量计算，对应于几种主要的载荷工况，得到了车桥横梁的应力分布规律。
The result of an engineering example shows that solution is effective and convergence is stable, and stress distribution of dam body tends to uniformity after optimization.
计算实例表明，该方法求解效率高，结果的收敛性稳定，优化后的坝体应力分布更趋于均匀。
The whole bond slip curve and bond stress distribution along embedded length were measured by continuous automatic collection.
采用了连续自动的采集方式，测出了较完整的粘结滑移曲线以及粘结应力沿埋长的分布。
The effect of the recessing on the strength and stress distribution of adhesively bonded single-lap joints is discussed.
研究单搭接接头胶缝中预留间隙对接头拉剪强度和应力分布的影响。
For the plates with finite dimensions, the finite element method is used to obtain the stress distribution and stress concentration around the ovaloid opening.
对于有限尺寸板内开孔的情形，文中用有限单元法来分析腰圆形孔口的应力分布和应力集中。
As an example, the human carotid with local cosine form expansion was analyzed and the effects of local expansion on the distribution of wall shear stress and its gradient were discussed in detail.
文章以人体颈动脉余弦扩张为例进行分析，详细讨论了局部扩张对血管壁切应力及其梯度分布的影响。
The computed results show that the presence of an interphase can have an important influence on the effective property and local stress distribution of the composites.
还将上述方法与均匀界面层模型进行了比较，计算结果表明，界面层的性质对复合材料有效性质和局部应力的分布有着重要影响。
The stress characteristic of the interface, deformation rule under the action of load and the stress distribution rule were discussed by adopting the experimental research method.
采用实验研究的方法，探讨锚固体界面力学特征、在荷载作用下变形规律以及界面上的应力分布规律。
And the distribution of thermal stress is one of the primary factors.
而其热应力分布问题是其中的主要因素。
The more attention was paid for the effects of matrix, interface and fiber orientation on stress transfer and stress distribution in composite.
研究中主要讨论了基体、纤维和界面的力学性能以及纤维位向的变化对应力传递和应力分布的影响。
The distribution model of bond stress over the splice length is developed.
建立了粘结应力沿锚固长度的分布模式。
Under the condition of three kinds of nonlinearity the stress and strain distribution of the road wheel is calculated with finite element analysis software ANSYS.
建立了负重轮的三种三维有限元力学模型，在考虑三重非线性的情况下，用ANSYS有限元分析软件计算了负重轮的应力应变分布。
The results indicate that under standard load, the installation has good stress distribution, and good bearing capacity because of rational structural design.
结果表明在标准载荷下，该装置应力分布情况良好。同时该装置结构设计合理，承载力大。
The last two factors induce borehole instability both by affecting stress distribution around wellbore and material properties of rock.
但后两者都是影响井壁应力分布和岩石力学性能而造成井壁不稳定。
The expressions of load, displacement, stress and residual stress distribution for hole cold_extrusion process are established by using elastic_plastic theory.
利用弹塑性理论建立了孔冷挤压的载荷、位移、应力以及残余应力分布表达式；
The stress distribution curve can be obtained directly by a pen recorder with a given scaling.
被测玻璃应力的分布曲线可以直接用记录仪记录。
According to the regulation of axial stress distribution, a way to design the rational end construction is given.
根据端部所呈现的应力分布规律，提出了确定端部合理结构型式的方法。
According to the regulation of axial stress distribution, a way to design the rational end construction is given.
根据端部所呈现的应力分布规律，提出了确定端部合理结构型式的方法。
应用推荐