It introduces display circuit, keyboard circuit and power circuit else.
对显示电路、键盘电路和电源电路的设计也进行了介绍。
The latter makes use of zero sequence voltage detection, alarm and display circuit.
信号报警显示部分由零序电压检测、报警、显示等电路构成。
Theidea of design an automatic display circuit system to the doffing timing is discussed.
叙述了加装落丝计时自动显示电路系统的设计思路，满足实际生产的要求。
Hardware circuit including AT89C52, display circuit, keyboard circuit, 74ls164 registers, etc.
硬件电路包括AT 89 C52单片机、显示电路、键盘电路、74ls164寄存器等。
Circuitry involve LED drive circuit, signal modulation circuit, DSP circuit and display circuit.
硬件电路系统包括LED光源驱动电路、信号调制电路、DSP硬件电路、显示电路。
A laser light power conversion and display circuit we developed will be introduced in this paper.
介绍了激光功率计的变换与显示电路，该电路的主要功能是直接指示激光功率的大小。
Seven-Segment LED dynamic display circuit design, completed in 8 digital tube display different figures.
七段数码管动态显示电路设计，完成在8个数码管上显示不同的数字。
The operating principle of its PWM circuit, current display circuit and sequence timer circuit etc. are described.
论述了PWM电路、电流显示电路、程序时间调节控制电路等的工作原理。
The music by the SCM system is the smallest system and the planned expansion of LED display circuit and voice circuit.
该音乐门铃系统是由单片机最小系统及扩展LED显示电路和语音电路组成。
The music alarm clock from SCM system is the smallest system and the expansion of LED display circuit and voice circuit .
该音乐闹钟系统是由单片机最小系统及扩展LED显示电路和语音电路组成。
This paper introduces the intelligent degree of wave display circuit design in measurement device of engine test instruments.
本文介绍了发动机检测仪检定装置的示波灵敏度电路设计。
The power supply circuit, driving circuit, display circuit, software design and signal collection of the control system are outlined.
概述了控制系统的电源电路、驱动电路、显示电路与软件设计及信号采集的方法。
The intelligent instruments dynamic display circuit and program with moving decimal point and blanking invalid zero were discussed in this paper.
介绍动态显示电路和能够移动小数点、熄灭无效零的显示程序。
The management of card data is done by RISC (Reduced Instruction Set Computer), keyboard circuit and display circuit, all of which are digital circuits.
名片信息的处理由数字电路RISC（精简指令集处理单元），键盘电路和显示电路实现。
The pulse width modulate circuit, drive circuit, sample circuit, protecting circuit and parameters preset and display circuit are respectively analyzed.
研究中讨论了脉宽调制电路、驱动电路、恒值采样反馈电路、保护电路、参数预置与显示电路的组成及工作原理。
Design the CAN bus address encoder, communication terminal digital display circuit, control relay circuit, LNK501 switching power supply chip circuitry.
设计了基于CAN总线的地址编码器，通信总站的数码显示电路，控制继电器电路，LNK501开关电源芯片电路。
In addition, the intelligent controller includes the hardware watchdog circuits, fault detection circuit, a digital display circuit, and power supplies.
除此之外，伶俐地节制器包罗硬件监督者线路，差错发现线路，数传展览线路，和力气补给。
This describes the principles and features of counting and display circuit of LDV to be made and the relationship between this circuit and optical structure.
本文叙述了所研制的激光多普勒测速仪中计数显示电路的原理、特点、以及和光路之间的配合关系。
The entire hardware circuit is composed by ultrasonic transmitter circuit, ultrasonic receiver circuit, the power circuit, display circuit, and other modules.
整个硬件电路由超声波发射电路、超声波接收电路、电源电路、显示电路等模块组成。
The system consists of single chip AT89C2051, ultrasonic transmitter circuit, ultrasonic receiver circuit, temperature collection circuit, and display circuit.
系统由at89c 2051单片机、超声波发射电路、超声波接收放大电路、环境温度采集电路及显示电路组成。
DSP's output circuit, keyboard and display circuit, high precision measure circuit and credibility protect circuit are analyzed, and the software design is given.
对DSP的输出电路、独具特色的键盘显示电路、高精度的检测电路和可靠的保护电路进行了分析，并给出了软件设计。
A minimum SCM system consists of CPU, the temperature acquisition module, the more temperature display circuit etc., completing the collection of temperature data.
该系统由中央处理器、温度采集模块、越温显示电路及显示电路等组成一个单片机最小系统，来完成对温度数据的采集。
Display circuit including the direction of headlights headlamps, front and behind the direction of the light lamp lights, fog lamps, fall in car lights, lamps, etc.
显示电路包括车头大灯、前面的方向灯、后面的方向灯、倒车灯、雾灯、车内灯、驻车灯等。
On the basis of the working principle of digital camera and the frame of display circuit, the display diving circuit of digital camera was designed by using hardware.
根据数码像机的工作原理和显示驱动电路的结构。应用硬件设计出数码像机显示驱动电路。
This design's hardware consists of minimum system circuit in MCU AT89C52, AD convert circuit, LCD display circuit, the monitor and control circuit of current voltages.
控制器由AT89C52单片机，AD转换电路，LCD显示电路，电流电压采集电路以及控制电路等组成。
Based on the characters of organic light emitting display (OLED), an OLED controlled display circuit is designed utilizing decode module and controlling circuit by FPGA.
根据有机发光二极管(OLED)的特性，利用解码模块和FPGA控制模块，设计oled视频动态图像驱动控制电路。
Methods: Computer, opto-electronic sensor, signal processing circuit, digital display circuit and a mechanical gate driven by motor are used with common intavenous drips.
方法：将单片机控制技术和传统的输液器相结合，采用光电传感器、信号处理电路、单片机控制系统、马达伺服电路和机械闸门、数字显示等技术。
The digital display circuit using a figure panel instrument was designed to implement real-time display of the Settings and the voltage and current in the welding process.
设计的数字化显示电路，采用数字面板表进行显示。在参数预置时显示参数预置值，在焊接过程中显示焊接电压与电流。
The control system consists of AT89S52 single chip computer system, autonomous tracing circuit, balance detection circuit, driving circuit of stepping motor and LED display circuit.
该系统包括单片机系统电路、寻迹检测电路、平衡检测电路、步进电机驱动电路、数码显示电路等。
The control system consists of AT89S52 single chip computer system, autonomous tracing circuit, balance detection circuit, driving circuit of stepping motor and LED display circuit.
该系统包括单片机系统电路、寻迹检测电路、平衡检测电路、步进电机驱动电路、数码显示电路等。
应用推荐