Displacement control mode demonstration by LVDT.
用位移传感器验证位移控制。
The results show that the displacement control effects of passive zone improvement are significant.
研究结果表明，被动区加固对变形的控制效果是非常显著的。
The thesis puts forward the pile-top displacement control method, and it can account the least force of the anchor wire on anti-slide pile.
本文提出了锚拉抗滑桩锚拉力计算的桩顶位移控制法，计算控制桩顶位移所需的最小锚拉力。
Throttle displacement sensor will deliver the throttle opening signal to throttle control unit, forms the displacement control in closed loop.
节气门位置传感器则把节气门的开度信号反馈给节气门控制单元，形成闭环的位置控制。
Load was exerted on the 16 interior nodes by displacement control method, in this way the post buckling behavior of this structure was obtained.
试验对该网壳结构内部16个节点采用位移控制法进行比例加载，得到了结构的屈曲后性能。
Adjusting mechanism is the executive body converts the output of displacement control valve spool and valve seat area change between the flow of the device.
调节机构是将执行机构的输出位移变化转换为控制阀阀芯和阀座间流通面积变化的装置。
According to aforesaid work, uplift displacement mechanism is in research, displacement model and calculation means of uplift displacement control design is advanced.
在上述研究基础上，对上拔位移机理进行了分析研究，提出了上拔位移计算模型和上拔位移控制的分析计算方法。
In combining cantilever control with angular measurement and using the measured angular values as feedback, a closed-loop displacement control system is formed together with a step motor.
将弦臂控制和角度测量结合在一起，以测得的角度值作为反馈，和步进电机组成闭环位移控制系统。
Modeling accurately the hydrostatic unit is the key of simulation of stepless steering performance of vehicle. The dynamic analysis of displacement control mechanism of variable pump affected by c…
本文通过试验和仿真两个方面，分析了排量控制阻尼孔对排量控制机构响应特性的影响。
Electrical power pulse signal will be entered into angular displacement or displacement of the Central Line control components.
步进电机是将电脉冲信号转变为角位移或线位移的开环控制元件。
We hypothesized that fascial displacement in experimental compartments with impaired PP would be significantly greater than that in control compartments with normal baseline PP.
我们假设灌注压受损的实验组筋膜间室的筋膜移位程度明显大于灌注压保持正常基线状态的对照组筋膜间室。
To avoid this from happening, we have to study the axial displacement motor rotor and how to measure it to better control it.
为了避免这种情况的发生，我们要研究电机转子的轴向位移以及如何测量它以更好的控制它。
As a result the data of the18th group moisture is out of control and found5continuous data of ash content from the10th group had the tendency of displacement.
发现第18组水分数据失控，发现灰分数据从第10组起连续5个数据有位移的倾向。
The design control conditions are uplift displacement or uplift load to spread foundation of bearing uplift load.
承受上拔荷载的扩展基础，可以用上拔位移或上拔荷载作为设计控制条件。
This paper investigated the possibility of measuring the surface roughness of wood by the laser displacement sensor of the computer control.
介绍了一种采用计算机控制激光位移传感器在线检测木材机械加工表面粗糙度的新方法。
The lower system is responsible for the control of operation cycle and displacement of electromechanical system.
最后，由底层系统来实现对机电系统的运行周期和位移的控制。
Taking the displacement and stress increase as safety control indexes of the existing tunnel, the effects of each counting parameter to results was analyzed, and some useful conclusions were educed.
以位移和应力增加值为既有隧道安全控制指标，计算分析了各个计算参数对结果的影响，得出一些有益的结论。
The results show that the variance of displacement response of the disk's center with the control strategy is only 16.7% of that without the control strategy.
结果表明，该控制策略作用下转子圆盘中心的位移响应方差仅为没有控制策略作用下对应位移响应方差的16.7%。
Consider now the same test carried out with servo control based on crosshead travel or displacement of the grips.
现在我们来研究用十字夹头位移或位移夹头伺服控制来完成相同的试验。
A two-dimensional fuzzy controller using displacement as feedback variable is developed to control the cutting chatter.
并以颤振位移作为反馈变量，建立了基于二维模糊控制器的颤振控制系统。
Servo motor control system Imported from Japan Panasonic, provide accurate displacement and speed control.
进口松下电机伺服控制系统，提供精确位移及速度控制。
Through improving the displacement loading control method based on the tangent stiffness, this paper has presented displacement loading control method based on the secant stiffness.
在基于切线刚度的位移加载控制法基础上进行改进，采用基于割线刚度的位移加载控制方法，并绘制了相应框图。
The modeling and displacement tracking control of a piezoceramic actuator with complex nonlinear hysteresis was studied.
研究了压电陶瓷驱动器的复杂非线性滞回动力学系统建模及其位移跟踪控制问题。
A displacement threshold was used to control DC upset butt welding process, and constant pressure and varied pressure tests were carried out on Q235 a steel strips.
采用位移门槛电压控制焊接过程，对Q 235 - A钢进行了变压式和等压式扁钢带直流电阻对焊试验。
Based on the structural displacement response control, the displacement transfer function is formulated for the structure with an MTMD under four types of excitations.
基于结构的位移响应控制，导出了四种类型激励下设置MTMD结构的位移传递函数。
This paper presents the consideration of establishing the bench marks, working bench marks, marks nets properly for the survey control net of vertical displacement in observation design.
本文介绍了在设计时，为设立完整而合理的垂直位移测控系统，对基准点、工作基点、标志和测控网布设的考虑。
In order to effectively control the piston displacement of a linear refrigerator compressor, a new fuzzy control system based on self-adjusting was proposed.
为了有效地控制直线冰箱压缩机的活塞位移，提出了一种以活塞上死点位移为控制目标的可自调整规则的模糊控制系统。
The loading frame can work in either load-control or displacement-control mode, and signals from the load sensor are digitalized with the control computer.
通过计算机控制，加力机构可以对微小试件按力或位移控制方式加载，载荷大小通过传感器直接由计算机数字化。
The loading frame can work in either load-control or displacement-control mode, and signals from the load sensor are digitalized with the control computer.
通过计算机控制，加力机构可以对微小试件按力或位移控制方式加载，载荷大小通过传感器直接由计算机数字化。
应用推荐