It becomes higher as humidity, power and length of discharge electrode (Le)increase;
放电电极长度的增加有利于脱硫，但应与功率匹配；
The relation between relative light crosstalk and driving voltage, gap of discharge electrode, width of electrode, as well as the effect to restrain crosstalk with barrier ribs are also discussed.
着重讨论了相对光串扰与驱动电压、放电电极间距、电极宽度之间的关系。
The researchers found that their electrode can charge and discharge up to 100 times faster than existing devices while holding the same amount of energy.
研究人员发现他们制作的电极充放电速度可以达到现有器件的100倍以上，同时保持同样多的能量。
Corona discharge: this is a non-thermal discharge generated by the application of high voltage to sharp electrode tips.
电晕放电：这是一个非热放电产生的应用高电压急剧电极秘诀。
In this paper the author details two kinds of discharge form, compares bubble efficiency of four electrode structures and offers some curves and empirical formulae.
本文对两种放电形式作了详细的论述，对四种电极结构的气泡效率作了对比，得出了一些曲线和经验公式。
The experiments of glow discharge plasma conversion of methane to C2 hydrocarbons were conducted by a novel reactor with rotary electrode at room temperature and atmospheric pressure.
采用新型的旋转电极辉光放电反应器，在常温常压下对辉光等离子体作用下的甲烷转化制C2+烃进行了研究。
Plasma was created by dielectric barrier discharge (DBD) system, which consisted of home-made middle frequency power supply and parallel plane electrode configurations.
等离子体的产生采用了自制中频电源和平行板电极结构组成的介质阻挡放电系统。
The effect of the rotating grounding electrode on dielectric barrier discharge is determined.
首次确定了接地电极转动对介质阻挡放电的影响。
The paper discusses high frequency discharge with dielectric electrode, emphasizing on the basic issues relating to the influence of frequency, dielectric constant on discharge and impedance match.
本文对具有介质电极的高频放电进行了讨论，对频率、介电常数对放电的影响，阻抗匹配等基本问题进行了探讨。
The marine electric spark uses two kinds of discharge form and multiple electrode structures.
海洋电火花震源采用两种放电形式和多种电极结构。
The influence of laser sampling, auxiliary spark discharge voltage, and electrode point gap on analytical results was examined.
考察了激光取样、辅助火花放电电压、电极尖端距离等条件变化时对分析结果的影响。
The average value of hydrogen diffusion coefficient in metal hydride(MH) electrode was measured by constant current discharge method.
利用恒流放电法测定了金属氢化物（MH）电极中氢原子扩散系数的平均值。
The experimental results indicate that the dielectric barrier discharge will show different forms and discharge current waveforms by fixing or rotating the grounding electrode.
实验的结果表明：接地电极静止或转动介质阻挡放电将呈现不同的放电形式和电流波形。
In this paper, some new points were put forward based on theoretical analysis of the discharge gap of Electric discharge Generating machining based on wire electrode.
针对基于线电极展成加工的放电间隙进行了理论分析，提出了一些新的研究观点。
A faint glow enveloping the high-field electrode in a corona discharge, often accompanied by streamers directed toward the low-field electrode.
电晕在电晕放电中在高压电极出现的一种微弱光辉，常伴随有朝向低压电极的电流。
The test results shown that it evidently raises the discharge performance of the fuel cells by adding proper amount of new electrode additives of cationic polyelectrolyte.
实验结果表明在电极中加入适量的新型电极添加剂可显著地提高燃料电池的放电性能。
Wire Electrical Discharge Machining Milling (wire EDM-Milling) is a novel kind of EDM-Milling method that has the distinct advantage of electrode compensation via the wire electrode slow traveling.
线电极放电铣削加工是一种新型电火花铣削技术，它的最大优点是可通过线电极的缓慢移动来补偿加工中的电极损耗。
The electro-pulse discharge process was verified by a set of pin-plane-pin electrode device.
通过“针—板—针”电极放电实验证实了上述串联脉冲放电过程。
The polarization of electrode decreased and the heavy load discharge performance of battery were improved by using foamed nickel.
使用发泡镍可降低电极的极化，改善电池的大电流放电性能。
The capacity of this electrode is much larger than that of the negative electrode to limit its depth of discharge.
这种电极的容量远大于负极的，成为限制放电深度的电极。
The results shows that the discharge potential plateau of metal hydride electrode is very lower and the polarization is larger at low temperature.
实验结果表明，氢化物电极低温放电电位平台很低，电极极化大。
The dimensional accuracy of electrical discharge machining(EDM) is greatly influenced by the overcut resulting from the discharge gap and electrode wear.
电火花加工工件的尺寸精度受过切量影响，而过切量的大小主要取决于放电间隙和电机损耗。
The results shown that the relative small charge current is favorable to improve electrode properties including capacity, circle life and discharge stability.
结果表明：小电流活化有利于提高电池的容量、循环寿命和放电性能的稳定性。
The experimental results showed this electrode can improve reversibility of the battery and increase its charge discharge capacity, cycle life.
实验结果表明，使用这种电极可使电池的可逆性明显改善，提高其循环寿命和充放电容量。
In the case of electrode surface imperfections, the discharge inception voltage can also be calculated provided a suitable electrode surface profile model is chosen.
对于电极表面有缺陷的情况，只要选取适当的电极表面轮廓模型，其起始放电电压也是可计算的。
In electric discharge milling machining (EDMM) process, the rotation of the tool electrode makes tool wear be axial symmetrical distribution, so it is possible to be compensated.
在电火花铣削加工中，由于工具电极作旋转运动，其损耗呈轴对称分布，使工具电极的补偿成为可能。
In electric discharge milling machining (EDMM) process, the rotation of the tool electrode makes tool wear be axial symmetrical distribution, so it is possible to be compensated.
在电火花铣削加工中，由于工具电极作旋转运动，其损耗呈轴对称分布，使工具电极的补偿成为可能。
应用推荐