This paper presents the three dimensional stress analysis method of slabs on elastic foundation.
本文提出了弹性地基上板的三维应力分析方法。
Sandwiched rock between twin closely spaced tunnels is in complicated and three-dimensional stress state.
小净距隧道的中间夹岩处于复杂的三维受力状态。
It is of important significance to study the ultimate bearing capacity of foundation in three-dimensional stress.
研究三向应力状态下条形地基极限承载力问题具有重要的理论和实际意义。
This paper analyses three-dimensional stress distributions of the stud anchor chain by the theory of finite element and boundary element.
本文应用三维边界元法和三维有限元法对有挡锚链进行了三维应力分析，并将其结果与电测实验数据作了比较，吻合得很好。
Some conclusions of the explosive stress field at the end are discussed according to the optical law of the dynamic two dimensional stress.
根据动态二维应力光性定律，得出了端部应力场分布的定性结论。
The in-situ rheological test under three-dimensional stress is a very useful way to reflect the actual rheological properties of filed rock mass.
岩体三向应力状态下的三轴流变试验是真实反映工程岩体流变特性的重要手段。
The model satisfies the two dimensional stress equilibrium, Mohr's cricular strain compatibility and softened biaxial constitutive laws of concrete.
这种模型满足二维应力平衡条件、莫尔应变协调条件和混凝土双轴软化本构关系。
A distribution function of two dimensional threshold is given for fatigue crack propagation. A two dimensional stress threshold interference model is set up.
本文给出二维疲劳裂纹扩展门槛值分布函数，建立二维应力—门槛值干涉模型。
In order to approach the failure criterion of sand, an experiment of independent control three-dimensional stress of sand has been performed with some simpler device.
为了探索砂土的破坏条件，曾利用比较简单的设备进行了一种砂土的控制三向压力试验。
Under the width to thickness ratio 625 of strip, this paper studies the 3-dimensional stress distributions of cold strip rolling by cubic spline function finite strip method.
本文在轧件宽厚比为625的条件下，用三次样条函数有限条法研究了冷轧带材三维应力的分布问题。
The traditional non-destructive method of pipe piles and concrete plates is impact-echo technique based on one-dimensional stress wave theory, and it can detect the big defects.
对管桩和混凝土板的传统无损检测方法则是基于一维波动理论的冲击回波方法，这种方法只能检测比较大的缺陷。
According to the numerical results, the ultimate bearing capacity of foundation with consideration of three-dimensional stress is improved, which is of important significance for engineering.
根据算例表明当考虑三向应力状态时条形地基的极限承载力将提高，这对实际工程具有重要理论和现实意义。
Based on the failure analysis of the fracturing pump valve chamber, a model for calculating its reliability under three-dimensional stress is established, and a computing program is worked out.
基于压裂泵阀箱的失效分析，建立了在三向应力作用下计算阀箱可靠性的模型，设计了计算程序。
The stress fields of such structure around the opening were predicted using a three-dimensional, higher-order fast multipole boundary element method.
为精确模拟该结构的应力状况，该文提出一种三维高阶快速多极边界元法。
In this paper, the interlaminar stress distributions of symmetric composite laminates with a hole are predicted by the three-dimensional elastoplastic finite element method.
本文用三维弹塑性有限元法计算了含圆孔对称复合材料层板的层间应力分布。
For a two-dimensional infinite medium containing an elliptical inclusion of different material, elastic stress distribution formulas are derived.
本文推导了二维无限介质内嵌异性介质椭圆的弹性应力场分布。
In this master thesis, the stress-strain relationships of thin films were measured by nanoindentation combined with dimensional analysis and finite element method.
本文以纳米压痕法结合量纲分析及有限元方法来测量薄膜材料的应力-应变关系。
Three-dimensional finite element analysis of the stress of the mandible premolar under loading on its traumatic occlusal spots.
下颌前磨牙创伤咬合点加载的三维有限元应力分析。
Because of the complexity in mathematics and the physics, solving the three-dimensional dynamic stress intensity factors is certainly limit.
三维裂纹在动态断裂力学中由于其数学和物理上的复杂性，求解其动态应力强度因子受到一定的限制。
Metbods: a two dimensional finite element model was built up to analyse the stress within the periodontal tissue of the first molar, with a reduced tooth eruption-resistant force.
方法：用二维有限元法分析阻萌力减少前后下第一磨牙牙周组织内应力分布的变化。
Based on the Reynolds Stress Model, the three-dimensional flow field was numerically simulated using the Reynolds averaged N-S system equations.
从雷诺应力模型出发，通过求解雷诺平均N - S方程组获得三维湍流流场的数值解。
Model parameters have the important effects on three-dimensional distinct element code (3dec) modeling of the stress wave propagation and attenuation in jointed rock masses as well as other codes.
与其他数值软件一样，用三维离散元程序(3dec)模拟应力波在节理岩体中的传播和衰减时，模型参数对模拟结果有很重要的影响。
A three-dimensional numerical model with free water surface and wall shear stress was used to analyze the water flow affected by piers.
该文采用具有自由水面和河床切应力计算的三维数学模型分析了桥墩群对河道水流的影响。
Two dimensional dynamical finite element and effective stress method were used to analyze dynamical response of Qifenghu Lake earth-rock dam during earthquake.
采用二维动力有限元方法并结合有效应力法对栖凤湖土石坝受地震作用的动力响应进行了分析。
Objective To study artificial lumbar intervertebral disc three-dimensional finite element model and its stress state.
目的研究人工腰椎间盘三维有限元模型的建立及其应力分布。
It showed that a fast cooling after drawing was of benefit to dimensional stability, straightness, environmental stress cracking resistance, and strength of the drawn tubes.
拉伸时的自然冷却会产生不均匀的产品，快速水冷却拉伸工艺能显著改善管的耐环境应力开裂性，成倍提高其强度。
In this paper we turn out the coherent-state expression of energy-momentum stress tensor in two dimensional Schwarzschild black holes. The results have been discussed as well.
讨论了一个二维黑洞的能量应力张量的相干态表示，并将这样得到的结果与已有的结果进行比较和讨论。
Being a kind of integrated structural parts, different thickness of WC cemented carbide layer has great effect on distribution of internal stress and dimensional stability.
作为一种整体结构件，在实际应用中碳化钨硬质合金层的厚度对部件的内应力分布以及尺寸稳定性有着重要的影响。
Through visualization, the three-dimensional deformation surface in whole stress field was drawn.
通过可视化，绘出了整个应力场中的三维变形曲面。
Firstly, the actual stress history of the projecting beam's maximal stress area is acquired by integrating the three-dimensional FEM analysis calculation and the dynamic stress test at field.
本文通过三维有限单元法分析计算与现场动态应力检测相结合，得到各工况下主梁最大应力部位的实际应力—时间历程。
应用推荐