The heating temperature and holding time had distinct effects on the copper diffusion depth in the stainless steel socket.
结果表明：铜在不锈钢衬筒中的扩散深度随着停留时间和加热温度的增加而增加；
The results show that the retardation coefficient is negatively related with transport distance and diffusion depth of these nuclides.
结果表明：在其它条件相同的情况下，迟滞系数与这三种核素的迁移距离、扩散深度成负相关关系。
The ratio of the square of certain concentration gas diffusion depth and diffusion time is constant when it diffuses and reacts through the solids bed.
一定浓度的气体通过固体颗粒层扩散-反应时，其扩散深度的平方与扩散时间的比值为常数。
The diffusion effects of two types of diffusion depth of cooling water, such as the whole water depth and the mixing zone, are calculated by using a two-dimensional mathematical model.
采用平面二维数学模型计算了温排水扩散深度为全水深和掺混层两种情况。
The results indicated that the diffusion and dilution of wastewater jet mainly depended on jet Froude Number, relative depth, and relative velocity.
试验结果表明：污水射流扩散和近区内的稀释度主要决定于射流佛劳德数、相对水深和相对流速。
With increase of heating temperature and duration of heating time, the depth and concentration of phosphorous-enriched layer in uphill diffusion increases continuously.
随着提高加热温度和延长保温时间，“上坡扩散”的富磷层深度和浓度将不断增加。
With the increasing of mining depth and exothermic function and diffusion progress of every kinds of heat source and so on, the heat damage of mines is becoming serious.
随着矿井开采深度的增加，由于各种热源的放热作用、扩散过程和其它原因，矿井热害日趋严重。
The relations among the length of the core region, the diffusion angle and the froude number and the submerged depth were also studied.
对射流核长度、射流扩散角与出口弗劳德数、淹没水深之间的关系进行了探讨。
The results of experiments showed that the Nb can raise the depth of diffusion zone, hardness, wear resistance, strength and toughness of the nitriding layer of the matrix steel.
实验结果表明，铌能增加扩散层深度、硬度及耐磨性，提高渗层的强韧性。
With a fixed camera parameters and through thermal diffusion theory this paper proposed a method that greatly facilitates the depth calculation process and simplifies the division of diffusion region.
文中提出的固定相机内参数并结合热扩散的方法大大方便了深度计算的过程，并且有效简化了扩散区域的划分。
Bacon's famous saying "the knowledge strength is not only decided by its own value, also by the depth and the breadth of knowledge Diffusion."
培根的名言：“知识的力量不仅取决于其自身的价值，更取决于它是否被传播以及被传播的深度与广度。”
It was found that the increasing depth has little impact on the effective junction area when the wall thickness is so thin that the diffusion layers is close to converge.
实验发现，当侧壁厚度薄到两侧的扩散层接近会聚时，孔深的提高对有效结面积影响不大。
Test shows that the depth of residual compressive after chemical heat treatment is correspondent with that of diffusion layer.
试验表明，化学热处理后残余压应力的深度往往与渗层深度相一致。
Comparison of the calculation results shows that it is more rational using the mixing zone depth to control the cooling water diffusion for deeper water.
在对计算结果比较后认为，当水深较大时，采用掺混层的厚度控制温排水扩散更为合理。
Turbulent diffusion coefficient is computed by F-distribution. The model can be used to changeable depth.
计算紊动扩散系数采用F分布，模型可用于变水深情况。
Turbulent diffusion coefficient was computed by F-distribution. The model can be used to changeable depth.
计算紊动扩散系数采用F分布，模型可用于变水深情况。
The depth of diffusion junction(Xj)is one of the most important parameters in wafer Fab.
在半导体芯片制造过程中，结深是重要的工艺参数之一。
There are many factors which affect the mixing of microfluidic, such as the inlet velocity, diffusion coefficient, depth-width ratio, and so on.
影响微流体混合的因素有很多，如入口速度、扩散系数、深宽比等。
The relationship of the process parameters to the depth of diffusion, concentration of titanium in the diffusion layer and the microstructure of titanizing layer are studied.
探讨了工艺参数与渗层厚度的关系，渗钛层组织特征，渗层钛浓度分布。
The relationship of the process parameters to the depth of diffusion, concentration of titanium in the diffusion layer and the microstructure of titanizing layer are studied.
探讨了工艺参数与渗层厚度的关系，渗钛层组织特征，渗层钛浓度分布。
应用推荐