X-ray diffraction and transmission electron microscope experiments indicate the powder sample is amorphous and also show the average particle size and crystallization products.
射线衍射和透射电子显微镜实验不但证实它的非晶性，而且给出它的平均颗粒度大小和晶化产物。
The morphology and crystal structure of solvent induced crystalline PET were studied by X-ray diffraction and scanning electron microscope.
应用X射线衍射和扫描电子显微镜研究了溶剂诱导结晶PET的形态和结晶结构。
The structure of Li Ca complex grease was studied through IR spectroscopy, X ray diffraction, DTA and electron microscope.
利用红外、X射线衍射、差热和电子显微镜等手段研究了复合锂钙基脂的结构。
A method of identification for low content chrysotile, crocidolite and amosite in brake rubber of bicycle by the united way of polarized light microscope and X-ray diffraction had been established.
本文提出了采用偏光显微镜和X射线衍射仪联合方法鉴定自行车闸皮中低含量的温石棉、铁石棉及青石棉等三种石棉的方法。
The structural and magnetic properties of the granular film are studied by atomic force microscope, energy dispersion X-ray spectrum, X-ray diffraction, and alternating gradient magnetometer.
利用原子力显微镜、能量散射X射线谱、X射线衍射和交变梯度磁强计研究了该颗粒膜材料的结构和磁学性质。
Optical metallographic microscope, micro-hardness tester, electron microprobe and X-ray diffraction analysis were applied to explore the process of intermediate temperature tempering transformation.
利用光学金相显微镜、显微硬度计、电子探针及X射线衍射分析仪初步探索其中温回火转变过程。
The structure of the copolymer was identified by DTA, IR, MS, X-ray diffraction and polarizing microscope and the copolymer prepared is a block one mainly.
用DTA、IR、MS、X射线衍射和偏光显微镜初步研究了共聚物的结构，证明所得产物主要是嵌段共聚物。
They have been characterized respectively by transition electronic microscope (TEM), X-ray powder diffraction (XRD), field induced surface photovoltage spectrum (FISPS).
对其进行了透射电镜(tem)、X射线粉末衍射(XRD)，场诱导表面光电压谱表征(FISPS)。
The morphology, structure, and photoluminescence(PL) of the phosphors were investigated by transmission electron microscope(TEM), X-ray diffraction(XRD), emission spectra, and decay time.
以X射线衍射（XRD）、透射电子显微镜（TEM）、发射光谱和衰减时间谱等手段表征材料性能。
The surface layers are characterized by means of the optical microscope, X ray diffraction, transmission electronic microscope, and micro hardness testing machine.
用X射线衍射、光镜和透射电镜对表层变形层金相组织、晶粒尺寸、显微硬度进行分析。
From the theory of light diffraction and geometrical optics, aperture diffraction near the focal plane of microscope objectives and imaging on the image plane are studied.
从光的衍射理论和几何成象理论出发，分析研究了显微物镜焦平面附近小孔光栏的衍射和象平面位置上的成象。
The coating composition, microstructure and phases were investigated by energy dispersive X ray analysis (EDXA), X ray diffraction(XRD), scanning electron microscope(SEM)and image analyzer.
运用能谱技术（EDXA）、X射线衍射仪（XRD）、扫描电子显微镜（SEM）和图像分析仪对涂层成分、显微组织、涂层相结构和组成进行了分析。
The high-resolution images and corresponding electron diffraction patterns of YBCO films were obtained with the aid of high-resolution transmission electron microscope(HRTEM).
在高分辨透射电子显微镜（HRTEM）下获得了薄膜的高分辨图像及电子衍射花样。
And polarizing microscope, wide-angle X-ray diffraction (WAXD) and differential scanning calorimeter (DSC) were used to study the crystalline of PLA membranes prepared at different conditions.
并且借助于偏光显微镜、广角X-射线衍射仪（WAXD）和差式扫描量热仪（DSC）研究了不同成膜条件下膜的结晶情况。
The grain size and lattice constant of Boron carbide was determined by method of X ray diffraction and scanning electron microscope (SEM).
采用X射线衍射和扫描电子显微镜测定了碳化硼粉的粒度和点阵数。
The microstructure of multilayers was characterized by high-resolution transmission electron microscopy, X-ray diffraction, scanning electron microscope and energy dispersive spectrometer.
利用透射电子显微镜、X射线衍射仪、扫描电子显微镜和X射线能量色散谱仪分析了多层膜的微结构。
The samples were characterized by X-ray diffraction (XRD), Scanning electronic microscope (SEM), photoluminescence (PL) and X-ray excited luminescence (XEL) spectra.
分别以X-射线衍射（XRD）、扫描电子显微镜（SEM）、光致发光（PL）光谱及X-射线激发的发光（XEL）光谱对样品进行了表征。
The nematic thermotropic liquid crystalline behaviour of ten kinds of PEAs obtained was studied by polarizing microscope, DSC and X-ray diffraction.
用热台偏光显微镜，DSC和X光衍射方法研究了热致液晶的相转变行为，确认了这十种聚酯酰胺均为向列型热致液晶。
Transmission electron microscope (TEM), Raman spectroscopy and X ray diffraction (XRD) were used to investigate the lattice structures, phonon properties of the samples.
通过透射电境、X光衍射和拉曼散射对纳米晶的晶格结构和声子特性进行了研究。
X-ray diffraction (XRD) and scanning electronic microscope (SEM) have been used to characterize the phase, orientation and surface morphology.
射线衍射和扫描电镜分别用于表征膜的物相、取向和表面形貌。
Scanning electron microscope (SEM) and X-ray diffraction (XRD) were used to measure the surface morphology, the crystal microstructure and the distribution of diamond grain in the film.
用扫描电镜(sem)和X射线衍射(XRD)方法检测了复合膜的表面形貌、晶体显微结构和复合膜中金刚石颗粒的分布情况。
The sample crystalline phase and shapes were analyzed with X-ray diffraction (XRD) and scanning electron microscope (SEM).
采用X射线衍射(XRD)和扫描电子显微镜(SEM)对样品的晶相和形状进行了分析。
The effects of acid counteranions on the mesophases were investigated by X-ray diffraction and high-resolution transmission electron microscope.
采用小角X射线衍射和高分辨率透射电镜研究了不同酸根离子对产物介孔结构的影响。
Employed by optical microscope, scanning electron microscope, microhardness tester and X ray diffraction instrument, the isothermal decomposition process of high nitrogen austenite was investigated.
利用光学显微镜、扫描电镜、显微硬度计及X射线衍射仪分析了高氮奥氏体的等温分解过程。
The crystalline morphology and lattice constants of silica bricks in several status were investigated by the optic microscope, scanning electron microscope and X-ray diffraction.
利用光学显微镜、扫描电镜和X射线衍射仪研究了几种不同状态硅砖的晶体形貌和晶格常数。
The phase structure and microstructure of samples under different heating rates were investigated by X-ray diffraction (XRD) and scanning electron microscope (SEM) etc.
用X射线衍射仪（XRD）以及扫描电镜（SEM）等研究了试样在不同预设升温速度下的相结构和显微组织。
The microstructure? Element distribution and phase after hot-corrosion were analysed by means of X-ray diffraction (XRD) and scanning electron microscope (SEM).
利用X射线衍射(XRD)和扫描电镜(sem)等手段，对高温熔盐热腐蚀后的组织形貌、元素分布及物相进行了分析。
The structure of the film was characterized by Raman scattering, X-ray diffraction and scanning electron microscope.
用拉曼散射，X射线衍射、电子显微镜等方法进行了结构表征。
The X ray diffraction and scanning electron microscope analyses show that the product possesses crystal structure, and the crystallized grain is rectangular and fusiform.
射线衍射和电镜扫描分析表明碳酸稀土产品属晶型结构，为长方体和纺锤形状结晶。
The X ray diffraction and scanning electron microscope analyses show that the product possesses crystal structure, and the crystallized grain is rectangular and fusiform.
射线衍射和电镜扫描分析表明碳酸稀土产品属晶型结构，为长方体和纺锤形状结晶。
应用推荐