• Limit pump diameter and percentage of submergence are derived theoretically. Trial and error method is used to calculate the rational percentage of submergence and pump setting depth.

    从理论上分析导出了极限泵径和极限沉没度,并引用小泵深抽技术采用试算法确定了合理的沉没度和泵挂深度。

    youdao

  • The method has considered the effect of difference in material hardness on the fatigue limit, which causes the shaft diameter design to become different depending on heat treatment difference.

    该方法考虑了材料硬度对疲劳极限的影响,使半轴杆径设计随热处理方法不同而有所差异。

    youdao

  • Base on the concept of image point diameter, formula was obtained to estimate concentration limit when particle-imaging technique was used for measuring particulate flow.

    基于像点直径的概念,推导了颗粒成像法测量颗粒场时的最大极限浓度估算公式。

    youdao

  • The results indicated the arrayed rule, density and diameter of the drawing holes affect the limit drawing height of sheet metal drastically.

    分析结果表明,拉深孔排列规律、密度和孔径变化对板料的极限拉深高度有很大影响。

    youdao

  • It is difficult to scale up conventional spouted bed in diameter because of the limit of its operational principle.

    常规喷动床直径放大因受到喷动原理限制存在一定的困难。

    youdao

  • Because the pipeline diameter in platform is one third of that in tidal channel, so the limit scour length is less.

    而平台区由于设计管径仅为潮汐通道区的三分之一,其极限冲刷长度远小于潮汐通道区。

    youdao

  • A modified three-dimensional plastic limit analysis method is proposed for lateral bearing capacity of the large-diameter pipe pile in the inhomogeneous and anisotropic soft ground.

    对于非均质各向异性软土地基上管桩基础的承载力,基于塑性极限分析理论考虑软土强度的非均质与各向异性效应,提出了一种改进的三维极限分析上限解法。

    youdao

  • If the cable is to remain flexible there exists an upper limit to its overall diameter and hence to conductor size.

    若要使电缆能弯曲,其总直径就有一个上限,从而电缆芯导线直径也有一个上限。

    youdao

  • This paper introduces a new method cutting the profile of tooth of large gear ring, which has no upper limit diameter.

    介绍了一种大型齿圈齿形加工的新方法,并对其加工原理、主要参数的选择计算和切削试验结果进行了分析。

    youdao

  • This paper introduces a new method cutting the profile of tooth of large gear ring, which has no upper limit diameter.

    介绍了一种大型齿圈齿形加工的新方法,并对其加工原理、主要参数的选择计算和切削试验结果进行了分析。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定