This interface uses a peer-to-peer architecture in which peripherals negotiate bus conflicts to determine which device can best control a data transfer.
这种接口采用点对点架构，外周设备协商解决总线冲突问题，以确定哪个设备控制数据传输最佳。
Under control of the CPU, a data source device and data destination device are "enabled" onto (equivalent to being connected to) the bus wires for a short transmission.
CPU的控制下，数据源器件和数据目的地器件被“使能”(等价于将其连接)至总线用于短暂的传输。
Each controller on a bus can be individually addressed by the CPU, this is why the software device driver can write to its registers and thus control it.
在总线上的每个控制器可以被CPU所单独寻址，这是软件设备驱动程序能写入寄存器并能控制这些控制器的原因。
The push articulating device is special for the rear engine articulated bus. It possesses particular structure, working principle and electric control system.
推式铰接装置是可以应用于发动机后置铰接式客车的专用铰接装置，其具有独特的结构、工作原理及电气控制系统。
An intelligent control system of high temperature environmental test for SOI device is introduced, which is based on the technology of bus integration.
本文介绍了基于总线集成控制技术设计的SOI器件高温环境实验装置的智能控制系统。
A single hardware control unit will recognize a request and grant access to the bus to a requesting device.
用一个控制器硬件去识别总线请求并允许请求设备去访问总线。
The new arc suppression coil control system consists of line selection device and automatic tuning device which communicate by CAN bus.
新型消弧线圈控制系统采用选线装置和调谐装置两套装置共同组成，两套装置通过CAN 总线进行通信。
The USB Bus device driver takes charge of control and communicates with hardware.
USB总线驱动程序负责控制实际的硬件，实现与底层的通信。
Intelligent measure and control device based on CAN bus is used in testing the temperature and humidity of position. MCU P80C592 with CAN controller is used as core circuit of hardware.
基于CAN总线的阵地环境温湿度智能测控装置，以片带CAN控制器的微控制器P 80c592为核心硬件电路。
The paper briefly introduces the PC104 bus standard and presents the design of software and hardware of an embedded DC control and monitoring device which is used in transformer station.
在简要介绍PC10 4总线标准的基础上，讨论了基于该标准的嵌入式变电站直流监控装置的软硬件设计。
The paper briefly introduces the PC104 bus standard and presents the design of software and hardware of an embedded DC control and monitoring device which is used in transformer station.
在简要介绍PC10 4总线标准的基础上，讨论了基于该标准的嵌入式变电站直流监控装置的软硬件设计。
应用推荐