Then, warm the dry air back up to the desired temperature.
最后，将干燥的空气再加热回理想温度。
Audible signal alerts you when a desired temperature has been reached.
声响信号，提醒您已达到所需的温度。
Set the desired temperature in the cabinet by operating the temperature controller.
通过操作温度控制器，设定您所须要的箱内温度。
Usual practice is to heat the steel to the desired temperature and hold it there only long enough to have it uniformly heated.
通常的做法是将钢加热到所需温度并且仅保温到正好使其均匀受热。
Cold salt water or cooling water can be poured into the jacket. The liquor is stirred and cooled evenly, thereby obtain desired temperature for ethanol precipitat …
筒体夹套内可通入冷冻盐水或冷却水，通过搅拌，使料液均匀冷却，控制醇沉所需温度。
Cold salt water or cooling water can be poured into the jacket. The liquor is stirred and cooled evenly, thereby obtain desired temperature for ethanol precipitation.
筒体夹套内可通入冷冻盐水或冷却水，通过搅拌，使料液均匀冷却，控制醇沉所需温度。
The invention provides a contour resonator having a desired resonance frequency and a desired temperature characteristic, and a method for adjusting this contour resonator.
本发明提供了一种具有期望谐振频率和期望温度特性的轮廓振子、以及该轮廓振子的调节方法。
If, for example, it's cold and overcast outside and its building's internal temperature is below a given desired temperature, the device would generate its effort to heating the building.
例如，天气冷阴，其建筑物的内部温度低于某一特定需要的温度时，设备会提高功率加大产热效能来提高建筑物的温度。
Sous vide, or cryovacking, where food is vacuum packed in plastic and then cooked in warm, temperature-controlled water to a desired doneness
真空调理食物，或真空包装食物，是将食品用塑料真空包装而后用温度受控的温水烹调以达到期望熟度。
If the sensor detects temperatures that are below the desired pasteurization temperature, the valve diverts flow to the entrance point for unpasteurized product.
如果传感器觉察到温度处在指定巴氏杀菌温度之下，那么阀门将流向改变到为未经巴氏杀菌产品而设的人口。
Since the temperature system of humidifier is a large time-delay nonlinear system, the normal PID control can not achieve the desired performance.
然而加湿器的温度系统是一个大时滞非线性系统，采用常规的PID控制无法实现有效的控制。
The thermostat generates signals, usually electrical, to activate relays, valves, switches, and so on when the temperature rises above or falls Below the desired value.
恒温器包括继电器、阀门、电门等，当恒温器高于或低于所需的数值时，恒温器就发出信号，通常为电信号。
Used in ordinary construction works and in making block concrete for which a low hydration temperature is desired.
适用于水化温度低的普通建筑施工和制混凝土砖。
The temperature of cooled water could not be maintained in a desired range by a fan running at constant-speed in a cooling tower under different loads and environmental temperatures.
在不同负荷、不同季节和不同环境温度下，制冷机组的冷却塔风机恒速运行无法使冷却水温度控制在需要范围内。
One way to accomplish this objective is by first measuring the temperature T(t), then comparing it to its desired value, and based on this comparison, deciding what to do to correct for any deviation.
完成这个目标的一个方法是首先测量温度，然后将其与期望值比较，在比较的基础上再决定如何去做以消除偏差。
If low charging rate is desired, you should use the BREAK-IN mode. Charging in that mode is terminated by only time (1.6 times battery capacity) and temperature.
如果你想用很低的充电电流进行充电，应该使用BREAK -IN模式。此充电模式只会因为时间(1.6倍电池容量)和温度终止充电。
In this paper, by analyzing the influence of temperature on the performance and service life of batteries, the desired function of a BTMS was outlined, a procedure for designing BTMS was introduced.
本文分析了温度对电池组性能和寿命的影响，概括了电池组热管理系统的功能，介绍了电池组热管理系统设计的一般流程，并对设计热管理系统提出了建议。
Sol Gel method is a new method with which desired chemical compounds can be obtained at lower temperature.
溶胶—凝胶法是一种在较低温度下即可得到希望的化合物的新方法。
Many air conditioners work something like this. First, cool the air to well below the desired room temperature.
很多空调制商都在制产下面这样的产品：首先，将空气冷却到低于理想室温的程度。
A difference between the actual and expected values for refrigerant pressures and temperature outside a desired range provides indication of a fault in the system.
制冷剂压力和温度的实际与预期值之间的差值超出理想范围，则表明系统出现故障。
To lower temperature sintering is desired for the fabrication of multiplayer microwave ceramics.
为满足多层微波元件低温烧结的需求，必须降低微波介质陶瓷的烧结温度。
As a result, the temperature of a desired position of the bearing can be measured.
因此，可测量该轴承的所需位置的温度。
The discharge temperature can be controlled by providing the compressor with a pressure ratio selected to provide a desired discharge temperature.
所述排出温度可以通过提供具有一定压缩比的压缩机而控制，所述压缩比选择成提供所需排出温度。
The product is then quickly cooled or quenched to the desired extrusion temperature to prevent new precipitation of these phases in the alloy structure. Between the temperatures of 800. degree.
产品然后被快速冷却或淬火到期望的挤压温度，以防止这些相在合金组织中的新析出。
The desired input parameters were soil physical constants, crop 's developmental date, initial soil water content and daily air temperature, relative humidity and precipitation.
模式所需的输入为初始土壤含水量、土壤物理常数、作物播种期、逐日平均气温、相对湿度和降水量。
TEMPER : Process of re-heating hardened steel to a temperature below critical temperature followed by a desired rate of cooling;
回火：将已经淬硬的钢材再加热到低于临界点以下的某一温度，保温一定时间然后根据要求冷却到一定温度的工艺；
Degradation triggers can be temperature or chemical reactants, with optional accelerators or retarders to provide the desired timing for plug removal.
降解引发要素可以是温度或化学反应物，以及任选的加速剂或缓速剂以提供所需的封堵去除时间。
When the temperature rises to the desired level, the indicator light will be off.
当温度升到所需的温度时，指示灯灭。
Microprocessor control offers sophisticated keypad operation and accurate digital display of temperature and CO2. Control is automatic after desired level is set.
微处理器控制系统允许复杂的键盘操作以及准确的数字显示温度和二氧化碳浓度，设置相应级别后系统自动控制内部工作。
Microprocessor control offers sophisticated keypad operation and accurate digital display of temperature and CO2. Control is automatic after desired level is set.
微处理器控制系统允许复杂的键盘操作以及准确的数字显示温度和二氧化碳浓度，设置相应级别后系统自动控制内部工作。
应用推荐