The new reformed system has been put into operation since 1998 and played irreplaceable role for the attainment of design yield in 170 Seamless Steel Tube Company.
新系统改造后于1998年投入使用，为170无缝钢管公司达到设计产量，起到了不可替代的作用。
Those yield a more effective means for the evaluation of strength and stiffness design of gun breech mechanism.
为火炮炮尾炮闩设计提供了一个更有效实用的结构校核手段。
Mathematic models between yield and N fertilizer and plant density for two peanut variety types were set up by using quadratic saturation D-optimization design under single-seed planting.
采用二次饱和D—最优设计建立了精播条件下不同类型花生品种N肥用量和密度与产量的数学模型，探讨肥料与密度的产量效应及优化配置。
In optimization design for hollow fiber membrane module by using hydraulic calculation, it was found that the geometric dimension has great effect on water yield.
采用水力计算方法对中空纤维膜组件进行优化设计，发现膜的几何尺寸对产水量的影响很大。
Based on the energy design measures for base-isolation structure, the formula applicable to the optimal yield level of the bilinear isolator is derived.
基于基础隔震结构的能量设计方法，推导出适用于双线性隔震器最佳屈服平台的应用公式。
Finally, a full design flow was provided for controlling offset and improving yield.
最后，给出了一种整体设计流程来控制零点输出与提高成品率。
Research the application of Monte Carlo method for tolerance design, display the calculate formula of estimated stack-up yield and the analysis method of sensitivity to tolerance.
研究了蒙特卡洛法在公差优化中的应用，给出了装配成功率的计算公式以及精度灵敏性分析的方法。
The maximum problem of parametric yield in VLSI is always an important issue in design for manufacturing (DFM).
超大规模集成电路(VLSI)中的参数成品率最优化问题一直是集成电路可制造性设计的重点研究问题。
Actuator disk theory yields equation (a) above for turbine maximum power, however, actuator disk theory does not yield the rotor geometry without further design theory.
促动盘理论符合上述涡轮机最大功率的方程序(a)，然而，没有进一步设计理论的情况下促动盘理论不符合转予几何学。
MethodsThe extraction process was studied by orthogonal design with L9 (34). The extract yield and the total flavonoids content were evaluated as markers for the purpose.
方法以浸膏得率和总黄酮含量为评价指标，利用正交实验l9(34)考察料液比、提取时间、提取温度、提取次数4个因素对提取工艺的影响。
MethodsThe extraction process was studied by orthogonal design with L9 (34). The extract yield and the total flavonoids content were evaluated as markers for the purpose.
方法以浸膏得率和总黄酮含量为评价指标，利用正交实验l9(34)考察料液比、提取时间、提取温度、提取次数4个因素对提取工艺的影响。
应用推荐