The gears adopt optimum design of fine-depth teeth and shot peening treatment in order to decrease noise if gearing and increase the capacity.
各齿轮副均采用优化细长齿轮，并进行强化喷丸，有效降低啮合噪音、提高承载能力。
The variation of equivalent stress near the hole wall with the depth of the teeth pressed is analyzed.
详细分析了孔眼壁附近的等效应力随牙齿压入深度的变化关系。
The macro characteristics, micro morphology, metallographic structure and carburized layer depth of the fractured teeth were observed and analyzed.
对断齿齿面的宏观特征、微观形貌、显微组织和渗层深度进行了观察、测试与分析。
Gritting his teeth, he broke into a run in spite of the depth of the water.
他咬上了牙，郯着水不管高低深浅的跑起来。
In one technique, called pocket depth reduction, the periodontist folds back the gum tissue, removes the bacteria, and secures the tissue into place so that it fits more tightly around the teeth.
在一种叫做翻瓣术的手术，牙周病医师翻起牙龈组织，清除细菌，保证组织回到原位置，让它和牙齿贴合更紧密。
All filled teeth were used for dye penetration test, and the depth that dye penetrated was measured between the restorations and the tooth structure under the metered microscope.
采用染料渗透实验，用测量显微镜测出染料渗入牙齿的深度。
The modification principle of tooth surface is deduced, and it draws the conclusion that the modificative tooth depth of wave producer, end face gear and oscillating teeth have certain relation.
研究了活齿端面谐波齿轮各啮合副齿面修形的原则，得出了波发生器、活齿前后端和端面齿轮齿面的修形高度之间必须满足的关系。
This paper presents the information of the effect, measured with a tele-strain-meter, of work material, feed, cutting speed, depth of cut, number of teeth and helix Angle etc.
本文在高速滚齿机上，利用遥测应变仪，测定了工件材料，进给量，切削深度，切削速度，齿轮齿数及螺旋角等对力矩的影响，并得出径节为8时的力矩公式。
The gear cutting machines with single tilt mechanism, such as the TAN-A9 machine, are intended only for cutting the spiral bevel and hypoid gears with teeth of constant depth.
诸如TAN-A9这样的单刀倾切齿机床过去仅用于加工等高齿弧齿锥齿轮和准双曲线齿轮。
The gear cutting machines with single tilt mechanism, such as the TAN-A9 machine, are intended only for cutting the spiral bevel and hypoid gears with teeth of constant depth.
诸如TAN-A9这样的单刀倾切齿机床过去仅用于加工等高齿弧齿锥齿轮和准双曲线齿轮。
应用推荐