The deflection value reckoned in its effect in construction wit…
此项挠度值在施工中以实测的温度变形速度计入其影响。
The deformations (deflection value) of the patterns with different coatings were measured under different loads.
测试涂挂不同涂料的模样在变载荷下的挠度值。
The deflection value can increase 44.7% when considering shear deformation. So shear deformation can not be ignored in the actual design.
考虑剪切变形能增大44.7%的挠度值,因此在实际中不可忽略。
Research results: This paper puts forward the analysis and calculation methods, structural requirements, displacement and deflection value and passenger comfort requirements for elevated station.
研究结果:提出高架车站的分析计算方法、构造要求、位移与挠度限值及旅客舒适度要求等。
The temperature value obviously depends upon the conditions of the test and the allowed deflection and for this reason, the test values are only really useful for comparing different polymers.
其温度值明显取决于试验条件和允许偏差,因此对比较不同的聚合物而言只有试验数据是真正有用的。
For any C. G. position, an increase in trim speed from any initial value to a larger one requires a downward deflection of the elevator.
对于任意一个重心位置,平衡速度由它的初始值变化到较大的值时要求升降舵向下偏转。
Put the material in a known test hole on the aperture, and then through a small aperture will load imposed on the fabric, for reads deflection scale pointer value.
将待测材料夹在已知孔径的测试孔上,然后通过较小孔径将一定负荷施加于织物上,于刻度指针上读取挠曲度值。
Find the value of the bending stress and the deflection at the center if the ribs are omitted.
如果略去肋条,求中心处的弯曲应力和挠度之值。
Based on meeting the requirements of flexural strength, the effects made by ratio of longitudinal reinforcement on deflection and maximum value of crack width are analyzed.
在满足正截面承载力要求的基础上,分析了纵向配筋率的变化对挠度及最大裂缝宽度的影响。
It is set forth that the limit value of lateral deflection is remained to be discussed further.
阐述了高层钢结构水平位移指标设计限值有待于进一步探讨。
Semi-rigid base can't reach the designed strength just after its finished, so the checking value of construction deflection can't be calculated by designed age strength.
刚完工的半刚性基层材料不能达到设计龄期时的强度,以致于半刚性基层顶面施工弯沉检验值不能按设计龄期的强度计算。
Used the deflection calculation method proposed by the paper, calculated the deflection under various load of the cracked prestressed concrete beam, and compared with experimental value.
采用本文提出的挠度计算方法计算了各级荷载下开裂预应力混凝土梁的挠度,并与试验值进行对比。
Building the mechanical models of seat foundation based on the basic principles of mechanics to analyze the deflection of main supporting components for finding the Max deflection point and its value.
应用力学分析基本原理,建立了座椅底架力学模型,对主要承载件进行挠度分析,找出最大挠度点及数值。
This method was used on the Maogang River Bridge construction, resulting in a final deflection differing by 2cm from the design value.
泖港大桥应用此法进行控制,其最终挠度与设计值仅差2厘米。
This paper puts forth the calculating formula of the deflection caused by shear distortion, which has a reference value to the design of the main shaft of the machine tool.
本文给出了考虑剪切变形引起的挠度计算公式,对现代机床的主轴设计具有一定的指导意义。
The paper discusses how to implement dynamic optic theory to analyze the extremal value of image deflection and the off-axis.
本论文论述了应用动态光学理论分析棱镜的像偏转与光轴偏。
The main reason of the main beam down deflection was that the most complex stress exceeded the admissible value and achieved the yield limit value.
主梁下挠变形的主要原因是受热引起的最大复合应力超过许用值,达到了屈服极限值,强度不满足要求。
The deflection upwards exceeding reasonable value will bring difficulty for high speed running and increase the impact effect, causing the intensive shake of the bridge.
过度的起拱会导致高速行车困难,加大车辆的冲击作用,引起桥梁的剧烈震动。
The girder board and wall of a teaching floor have crazed, its girder board deflection is over criterion value, its stiffness is insufficiency. The building can not be used ordinarily.
某教学楼钢筋混凝土现浇梁板、承重墙体严重开裂,梁板挠度大幅度超过规范允许值、刚度严重不足,致使建筑物不能正常使用。
The equation used to calculate deflection ductility of columns was obtained, which based on the axial compression ratio and hoop characteristic value of a column.
确认分析效果后,对试件进行了计算机模拟的参数分析,得到基于配箍特征值和轴压比的位移延性计算公式。
The equation used to calculate deflection ductility of columns was obtained, which based on the axial compression ratio and hoop characteristic value of a column.
确认分析效果后,对试件进行了计算机模拟的参数分析,得到基于配箍特征值和轴压比的位移延性计算公式。
应用推荐