The laser optical beam deflection method is one of the noncontact sensing technique.
激光光束偏转法是一种非接触的探测技术。
The beam deflection method was employed to determine the temporal response and position sensitive properties of the PSD.
采用光束偏转法对其时间响应特性和位置敏感特性进行测定。
Tested the joint stiffness based on "deflection method", and analyzed the factors that affect joint stiffness according to the test results.
基于“挠度法”，对节点刚度进行了测试。根据测试结果，分析了影响节点刚性的各种因素。
Calculating the continuous beam, frame of single-span and multi-story by deflection method, the stiffness matrix is symmetrical three-diagonal.
用位移法计算连续梁、对称性荷载作用下的单跨多层刚架，总刚度阵为对称三对角阵。
In this paper, the physical base of the mean square deflection method extracting information of multi-parameter earthquake precursors has been studied.
本文研究了提取多参数无量纲地震前兆信息的均方差方法的物理基础。
The pace analyzes the current pre-arched calculation and installation method based on the relative deflections, and proposes a new absolute deflection method.
本文在对现行的基于相对挠度的预拱度计算设置方法进行分析后，进而提出了新的绝对挠度法。
For this status, this paper proposes a new load ratio deflection method for making monthly trade schedule of directly dispatched thermal power generation units.
针对此现状，提出了一种负荷率偏差法，用于解决直调火力发电单元月度电能交易计划编制问题。
The thermal lenses in operating copper vapor lasers and in the fused silica Windows were measured by using of the deflection method and the interferometer method respectively.
本文用光束偏转法和干涉法分别测量了以熔石英为窗口材料的铜蒸气激光器及其窗口的热透镜效应。
The method to measure the refraction rate of liquids by using the least deflection angle is introduced and analyzed in this paper.
介绍一种利用分光计及自制盛液“三棱杯” ，采用最小偏向角法测量液体折射率的方法，并对该法进行了分析和讨。
Numerical results show that present method is an effective one for solving the flow around wing body configuration with control surface deflection.
数值算例表明本文方法是求解带操纵面偏转的翼身组合体绕流的有效方法。
Using nonlinear finite element method, the compression load deflection of the seal was analyzed and cross sectional shape of the seal was optimized.
利用非线性有限元法分析了密封条的压缩受力变形特性，根据结构力学原理对密封条横截面形状进行了优化。
Numerical results show that the present method is effective one for solving the flow around wing with control surface deflection.
数值算例表明本方法是求解带操纵面偏转的机翼绕流的有效方法。
Numerical results show that the present method is effective for solving the flow around a wing with control surface deflection.
数值算例表明该方法是求解带操纵面偏转的机翼绕流的有效方法。
Numerical results show that the present method is effective one for solving the flow around a wing body combination with control surface deflection.
数值算例表明该方法是求解带操纵面偏转的翼身组合体绕流的有效方法。
In this paper, the method of signal flow graphs is applied to path enumeration and deflection routing performance analysis in multihop networks.
本文将信号流图的方法应用于多级跳跃网中的路径枚举和折射路由性能分析。
A simplified analytical method for the elastoplastic dynamic large deflection response of portal frames under impact loading is reported in this paper.
本文报道一种求解门式刚架在冲击载荷作用下动态弹塑性大变形响应的简便分析方法。
This paper gives an account of the method of deflection test of large-span steel roof truss and analyses the test result by using element calculation.
本文介绍了大跨度钢屋架挠度测试法和测试结果，并用有限元计算对测试结果进行比较和分析。
We describe a novel method to enrich isotopes and isomers via magnetic deflection of optically polarized atomic beam.
本文描述一种通过极化原子束的磁偏转实现同位素和同质异能素浓缩的新方法。
An optics method for measurement of beam section deflection of major bridge structure is put forward.
提出了一种大型桥梁结构截面挠度测量的光学方法。
A new linear sensing method of deflection and stress, in which the fiber grating bandwidth is stretched by using bilateral cantilever beam, is reported.
报道一种利用双侧悬臂梁展宽光纤光栅带宽实现对挠度和应力线性传感的新方法。
The method to use new minimum Angle of deflection of measurement has helped the experiment operate, and improved the accuracy measured.
使用新的测量最小偏向角的方法方便了实验操作，提高了测量的准确度。
A new concept on the displacement operator for beam unit is established, and a method of calculating the deflection Angle of beam unit is then provided.
本文建立了一个梁单元位移算子的新概念，并提供一种梁平面弯曲变形的梁单元位移算子求变形的计算方法。
This paper describes the design method of deflection crank slider mechanism of the given stroke velocity rate and slider stroke, which has optimum transmission performance.
探讨了给定行程速比及滑块行程的偏置式曲柄滑块机构具有最佳传动性能的设计方法。
The transition curve is a familiar curve form. And lofting with polar coordinates method can break through localization of deflection Angle method.
缓和曲线是一种常见的曲线形式。使用极坐标法放样可以避免偏角法的局限性。
A method to calculate the deflection of cast-in-situ plate stairs and the comprehensive corrected coefficient based on this method.
提出计算现浇板式楼梯的挠度的方法以及基于该方法的综合修正系数，可供工程设计、教学和科研参考。
And lofting with polar coordinates method can break through localization of deflection Angle method.
使用极坐标法放样可以避免偏角法的局限性。
An optimization method is used to obtain deflection Angle of control surface and the aerodynamic efficiency of airfoil is calculated.
用数值优化方法取得自适应翼型最优的舵面偏角，并计算其气动特性。
An optimization method is used to obtain deflection Angle of control surface and the aerodynamic efficiency of airfoil is calculated.
用数值优化方法取得自适应翼型最优的舵面偏角，并计算其气动特性。
应用推荐