Tensions have steadily increased over Jerusalem's refusal to meet Ankara's demands for an apology and compensation to the families of the dead.
由于耶路撒冷拒绝满足安卡拉提出的向死者家属道歉并进行赔偿的要求，两国的紧张关系稳步升温。
A modified dead time compensation method was used to obtain better output voltage waveforms.
采用了改进的死区效应补偿方法以获得理想的输出波形。
Dead-time compensation and minimum pulse-width limitations lead to losses in the linear modulation region of space vector modulation.
死区补偿和最小脉宽限制减小了空间矢量脉宽调制的线性调制区。
This paper puts forward the method of intelligent compensation of dead zone in electrohydraulic proportional directional valve.
本文提出了电液比例方向阀死区的一种智能补偿方法。
So with the wide I/O linearization method of nonlinear reverse function, the generalized prediction control algorithm with dead area nonlinear compensation is suggested.
因此我们针对死区非线性特性，采用非线性逆函数的全局I/O线性化方法，提出了具有非线性补偿的广义预测控制算法。
If the employee is dead or get injured while performing duties on line, the employee or his family will get compensation according to the labor insurance.
第六十二条员工因公致残或死亡时，依劳动保险有关规定予以补偿。
Aimed at dead time effect of voltage-fed space vector pulse width modulation (SVPWM) inverter, a novel compensation method detecting current polarities from the current vector was presented.
针对电压源型空间矢量脉宽调制逆变器的死区效应，提出了一种根据电流矢量判断电流极性的死区补偿方法。
AS the topology and operating principles of the system analyzed, its steady compensation characteristic and dead effect compensation are discussed in detail.
文中分析了其拓扑结构和工作原理，详细讨论了该系统的稳态补偿特性和死区补偿方法。
This paper analyzed the influence of the dead-time effect acting on the output voltage of SVPWM inverter, and proposed a solution to dead time compensation.
本文在分析死区效应对空间电压矢量调制输出电压影响的基础上，给出了一种对死区效应进行补偿的方案。
Aimed at the influence on the inverter output voltage caused by the PWM inverter dead-time, one dead time compensation strategy is proposed.
针对PW M电压型变频器死区时间对输出电压的影响，提出了一种死区时间补偿方案。
The compensation methods of the dead-time effect are studied.
并对死区效应的补偿策略进行了研究。
The survey has been made on three sub areas, they are PWM basic technique, PWM technique combined with current control, and PWM dead time compensation technique.
方法在常规复合控制结合死区补偿方法的基础上，设计了死区和自调节前馈补偿的综合控制方法。
Based on the analysis of traditional compensation methods, a method compensating the dead-time in a synchronous rotating reference frame is proposed, which fits for general-purpose inverters.
在分析了传统死区时间补偿方法的缺点之后，提出了适合于通用变频器的基于旋转坐标变换的死区时间补偿方法。
A basic control method for direct torque control system is introduced, the theory gist of this method is proved. A new method of dead time compensation is also put forward.
介绍了一种直接转矩控制系统的基本控制方法，推导了这种控制方法的理论依据，同时提出了死区补偿的新方法。
The Brushless DC Motor, important part of the system is well controlled including two-closed-loop control method, compensation for dead-time and analysis of fluctuation about swapping phases.
同时针对系统中的关键部分无刷直流电机采取了全面优良的控制策略，包括转速外环电流内环双闭环调速控制，死区补偿，换相脉动分析等。
But it may cause unjust compensation and the hospital may hide imperfect medical events in reports, becoming a supervision dead angel of health administrative department.
但是也可能存在赔偿不公平，医院对卫生行政部门瞒报医疗不良事件的现象，成为卫生行政部门监管的死角。
But it may cause unjust compensation and the hospital may hide imperfect medical events in reports, becoming a supervision dead angel of health administrative department.
但是也可能存在赔偿不公平，医院对卫生行政部门瞒报医疗不良事件的现象，成为卫生行政部门监管的死角。
应用推荐