Custom-modified shaft designs, mounting configurations, speed variations, and various DC input voltages are available.
定制改性的轴的设计，安装配置，速度的变化，以及各种直流输入电压是可用的。
It is recommended that AC input motor and driver systems, which are compatible over a wider range of operating conditions than DC input systems, be considered for your application.
我们建议，交流电机和驱动系统的输入，这是在一个比直流电输入系统的工作条件更广泛兼容，可为您的应用考虑。
The CTR series offers UL approved AC output ratings of 25 amps per channel at 600 VAC, AC or DC input control, zero voltage or random turn on, and IP20 touch safe construction with integral heat sink.
该CTR系列产品提供具有UL认证的交流额定输出功率为每通道25安培，在600伏交流电，交流或直流输入控制下，零电压或随机打开，具有IP20触摸安全构造和内部散热器。
As the frequency of the AC component increases, the DC meter response decreases, until at some frequency only the average input voltage will be displayed.
当交流分量的频率增加时，直流仪表的响应就会变得不够快，直到在某一频率时，仪表只能显示出输入电压的平均值。
If the AC voltage at the input is large, part of this signal is rectified, producing an error in the DC signal being measured.
如果输入端的交流电压很大，其一部分信号被整流，于是在被测的直流信号中产生了误差。
A new type of DC switch power which is possessed a DC voltage input and three DC voltage output, and is able to reach higher efficiency has been introduced in this paper.
本文介绍一种新型的直流开关电源，该电源是一种直流电压输入，三种直流电压输出，并能够达到相当高的效率。
A reading offset may be caused by input amplifier overload or DC rectification at the input.
读数偏置可能由输入放大器过载或输入端的直流整流效应所引起。
MPS700 series dc voltage constant-current power supply, is designed by using linear series MOSFET control mode of the ac input dc output power.
MPS700系列直流稳压稳流电源，是采用MOSFE T线性串联调整方式设计的交流输入直流输出电源。
The lamp dimming can be done through this feedback loop or, by setting the reference DC level of the input of error amplifier.
灯管的亮度能够通过反馈回路，或者设置误差放大器输入端的参考端直流电平来调整。
Fast Fourier transform (FFT) is the main algorithm for harmonic analysis in electric power system, but when there is the decaying DC component in input signal, FFT algorithm will have higher error.
快速傅里叶变换(FFT)是电力系统进行谐波分析的主要算法，但当输入信号中含有衰减直流分量时，FFT算法会产生较大的误差。
This paper analyzes the effects of the input and output decoupling capacitances on the grounding current EMI in DC motor drives.
本文针对直流电机调速装置输入和输出侧退耦电容对地电流干扰的影响进行研究。
Both theoretical analysis and experimental results show that the AC DC converter has high efficiency over a wide range of input voltage.
理论分析和实验结果表明，该转换器可以在较宽的输入电压范围内获得较高的转换效率。
The paper detailed the relationship of input resonant voltage, modulation voltage and output sinusoidal voltage of single phase resonant DC link inverter(RDCLI).
详细研究了谐振直流环节单相逆变器的输入谐振电压与逆变器输出调制电压、输出正弦电压的关系；
The single AC power input voltage frequency, the internal AC to DC after; DC converter rectifier exchange conversion, self-produced - very stable, pure sine wave.
该电源输入单一交流电压和频率，内部经过交流对直流；直流对交流的变流整流转换后，自行产生-非常稳定纯净的正弦波。
It can achieve a fixed output of DC voltage in the universal input range of ac 80 ~ 265 V. It owns the advantages of high efficiency, low total harmonic distortion, PF near to 1.
该方案能在80 ~ 265V宽输入电压范围内得到稳定直流电压输出，具有效率高、总谐波畸变率低、功率因数接近为1等特点。
And the load sharing control of the input stage is also analyzed by the AC and DC hybrid parallel system with several EPTs.
并以多台ept交直流母线混合并联系统为基础分析了并联ept的输入级控制策略。
The error of inductosyn Angle measurement system will cause ripple of speed in DC motor control system. This error is equal to adding a disturbance to the input.
由于感应同步器测角系统的误差的存在，相当于在系统的输入端加入了一个干扰，从而在电机控制系统中引起电机速率的波动。
These inverters use an AC to controlled DC converter on the input side.
这些换流器使用在输入一边接通到可控直流换流器的交流电。
The main circuit parameters mainly contain AC-side input inductor, DC-side output capacitor, given output voltage of the DC-side.
主电路参数主要有交流输入侧电感值、直流输出侧电容值、给定的直流输出侧电压等。
In a dc-dc converter with a given input voltage, the average output voltage is controlled by controlling the switch on and off durations (ton and toff).
在一个给定了输入电压的直流-直流变流器中，输出的平均电压是通过控制开关的导通和关断时间来控制的。
The input video is now fixed at a stable DC level where the blank level is set to a known ADC code.
现在，输入视频固定在稳定的直流电平，消隐电平则设定为已知的ADC代码。
The motor drive circuit further includes a coupling system coupled to the input device, to the first energy storage device, and to the bi-directional DC-to-DC voltage converter.
该电机驱动电路还包括耦合到输入装置、第一能量存储装置、双向DC-DC电压变换器的耦合系统。
Continuous input current is ensured, which mitigates the impact on DC source and improves DC voltage utilization.
同时该拓扑还保证了输入电流连续，减小了对直流源使用寿命的影响，提高了直流侧电压利用率。
In this case, because the gain and input are at the same frequency content, a dc component, which a lowpass filter can easily detect, is present at the amplifier's output.
像这样，因为增益和输入是同样频率，低通放大器容易探测到的直流器件，呈现放大器输出。
The paper gives two kinds of approaches to measure the ripple current in input current of DC-DC converter or DC-AC inverter.
文中叙述了直流—直流变换器或直流—交流逆变器输入电流中纹波电流的二种测量方法。
Figure 50 shows the recommended dc return for a transformer-coupled input.
图50示出了输入端变压器耦合的直流回路。
In dc-dc converts, the average dc output voltage must be controlled to equal a desired level, though the input voltage and the output load may fluctuate.
对于直流-直流变流器，虽然输入电压和输出负载会波动，直流输出电压必须控制在一个希望的水平。
The improved power output control circuit includes a detector circuit for rectifying an input signal to produce a DC output representing power level of the input signal.
该改进的功率输出控制电路包括检波器电路，用于将输入信号整流产生代表输入信号功率电平的DC输出。
Input out-phase, Output out-phase, input under-voltage, DC over-voltage, over-current, over-load, current stall, over-heat, external disturbance.
输入缺相，输入欠电压，直流过电压，过电流，过载，电流失速，过热，外部干扰等。
Input out-phase, Output out-phase, input under-voltage, DC over-voltage, over-current, over-load, current stall, over-heat, external disturbance.
输入缺相，输入欠电压，直流过电压，过电流，过载，电流失速，过热，外部干扰等。
应用推荐