The damping circuit may already be built into the electrometer or may be an external circuit.
衰减电路可以装在静电计的内部，也可以是一个外部电路。
The DSP circuit of synthetic impedance is adopted instead of piezoelectric shunting damping circuit.
采用DSP构建合成阻抗电路替代传统的压电分流阻尼电路进行振动控制。
A damping circuit is a type of low pass filter that reduces the electrometer's ac response so the low DC current can be measured accurately.
该衰减电路是一种降低静电计交流响应的低通滤波器，使我们可以准确地进行直流弱电流的测量。
The inverter has the advantages of lower noise, lower loss, less volume, lighter weight, better output waveforms and without damping circuit.
这种逆变器具有噪音低、损耗小、重量轻、体积小，输出波形好且不需要吸收电路等优点。
This article introduced driving circuit and damping circuit of the printing driver of the feedback printing system of the XD 106 1 channel electrocardiograph.
本文叙述了对XD - 106单导心电图机中的速度反馈式直线描记系统的表头板驱动电路及阻尼电路的成功设计。
This article introduces the driving circuit and damping circuit for the printing driver of the feedback printing system of the XD106 1channel electrocardiography.
介绍XD-106单导心电图机中的速度反馈式直线描记系统的表头板驱动电路及阻尼电路。
However, it may be necessary to increase the damping with an external circuit.
然而有的时候，可能需要使用外部电路来增加衰减作用。
Be directed to damp winding damp bar is calculated though multi circuit method, and a way to transfer data is offence to monitor damping winding.
同时针对阻尼绕组提出了用多回路法计算阻尼条电流，并提出一种数据传递方式实施对阻尼绕组的监测。
A multi circuit calculation method is suggested for calculation of the current of the damping winding bar and a method of data transfering is offered to monitor damping winding.
同时针对阻尼绕组提出了用多回路法计算阻尼条电流的方法，并提出一种数据传递方式实施对阻尼绕组的监测。
Often in ac circuit by air damping model time relay, it is to use the principle of air through orifices throttling to obtain delay action.
在交流电路中常采用空气阻尼型时间继电器，它是利用空气通过小孔节流的原理来获得延时动作的。
Early in the circuit often USES air damping model time relay, it is to use the principle of air through orifices throttling to obtain delay action.
早期在交流电路中常采用空气阻尼型时间继电器，它是利用空气通过小孔节流的原理来获得延时动作的。
All of this explained that the structure damping control technique of RL shunted circuit is feasible and effective.
进一步说明了具有RL分支电路的半主动悬臂梁结构阻尼控制技术的可行性和有效性。
The pulse forming unit is designed based on the critical-damping characteristics of RLC series-resonant circuit.
同时，基于RLC串联谐振电路的临界阻尼特性，设计了脉冲成形单元。
A circuit topology of a combined compensation system for power factor correction, harmonic mitigation and harmonic resonance damping is proposed.
提出了一种具有功率因数校正、滤除谐波电流和抑制谐波谐振的电力系统综合补偿系统电路结构并将其成功应用于实际工程。
A circuit topology of a combined compensation system for power factor correction, harmonic mitigation and harmonic resonance damping is proposed.
提出了一种具有功率因数校正、滤除谐波电流和抑制谐波谐振的电力系统综合补偿系统电路结构并将其成功应用于实际工程。
应用推荐