Although input bias current is a common source of this type of error, currents generated by external circuits can also result in errors due to voltage drops across the source resistance.
虽然输入偏置电流是这种误差的常见来源，但是外电路产生的电流在源电阻上形成的电压降也能引起误差。
The metering error considers the non linear effect of the voltage coil and current coil in watt hour meter under different order of harmonics and different distortion degree of input waveform.
计量误差考虑了电度表电压线圈和电流线圈在不同的谐波次数以及谐波大小时的非线性效应。
As shown in Figure 2-2, the input bias current (IBIAS) develops an error voltage across the source resistance (RS).
如图2 - 2所示，输入偏置电流(IBIAS)在源电阻(RS)上产生了误差电压。
Leakage current is an error current that flows through insulators when a voltage is applied.
漏泄电流是在施加电压时通过绝缘的误差电流。
If the load resistor was connected directly across the voltmeter input terminals, the current through the relay contacts would cause a voltage drop and the measured cell voltage would be in error.
如果负载电阻被直接连接到伏特计的输入端子，通过继电器触点的电流会产生电压降，测得的电池电压将存在误差。
With voltage measurements, the input current is ideally zero; thus, any input current represents an error.
对电压测量来说，理想的输入电流应为零，所以，一切输入电流都代表误差。
Secondly, the DC voltage loop and inner current closed-loop control method, both to ensure zero static error of the inverter output, but also to ensure that the inverter output waveform.
其次，本文采用直流电压外环、电流内环的双闭环控制方法，既保证了逆变器输出的静态误差为零，又保证了逆变器良好的输出波形。
The problem of neutral-point balance is resolved by changing the amplitude of current reference according to the voltage error of two capacitors.
通过两输出电容电压的偏差改变电流参考给定来实现整流器输出中点平衡。
Use of programmable logic devices to overcome voltage and current signals by the time of measurement error, and also provided a data storage space.
利用可编程逻辑器件克服电压信号和电流信号分时测量所带来的误差，同时也提供了数据存储空间。
The calculating voltage error when the non-liner models is simplified as the linear ones is analyzed with the given current density range.
分析了在给定的电流密度范围内，非线性模型简化为线性模型时的相对误差。
Various errors of an operational amplifier can be substituted by equivalent error voltage or current sources.
运算放大器的各种误差都可以用等值的电压源或电流源来代替。
The principle of transforming current to voltage is analyzed, and it is pointed out that the error factors mainly consist in the bias current and offset voltage of the operational amplifier.
分析了电流—电压转换原理，指出转换误差主要来源于偏置电流及失调电压。
The principle of transforming current to voltage is analyzed, and it is pointed out that the error factors mainly consist in the bias current and offset voltage of the operational amplifier.
分析了电流—电压转换原理，指出转换误差主要来源于偏置电流及失调电压。
应用推荐