The symmetric ternary current-mode CMOS circuits designed by using this theory not only have simpler circuit structures and correct logic functions, but also can process two-way signal.
应用该理论设计的对称三值电流型CMOS电路不仅具有简单的电路结构和正确的逻辑功能，而且能处理具有双向特性的信号。
The conditions of voltage between contactors and current in main circuit under different using types are analyzed in detail, then designed the control sequences with working mode AC1-AC4.
详细分析了交流接触器在不同使用条件下的闭合与分断时触点两端电压与回路电流情况，并研究了AC1～AC4工作制下的控制时序。
This paper introduces the theory of slope compensation and presents a piecewise linear slope compensation circuit for peak current mode boost DC-DC converter.
结合一款升压型直流-直流变换器，介绍了峰值电流模式中的斜坡补偿基本原理，提出了一种分段线性斜坡补偿电路。
A current mode high pass filter based on a differential circuit having simple and leap frog structure with excellent performance is proposed.
给出了一种结构简单、性能优良的微分电路，并提出了用该电路实现的电流模式跳耦结构高通滤波器。
Simultaneously, the sensing mode for spot welding current was chosed and an structure of integral circuit and system circuit was designed.
同时，进行了点焊焊接电流方式的选择，积分电路和系统电路的设计。
In this paper, by the use of dual-current control mode and intelligent UC3842 chip as the core, a single-chip switching power supply circuit are presented.
本文使用双电流控制模式，以智能芯片uc 3842为核心，设计了单片开关电源的实用电路。
Two main problems in designing the main circuit of switching mode excitation controller are peek voltage and over current of switching device.
开关式励磁调节器主回路设计中需要考虑的两个主要问题是开关器件的尖峰电压和冲击电流。
UC3846 of current mode control is used so that circuit for current limited function is removed and flux imbalance that can cause accident is been avoided.
采用基于UC 3846电流型控制芯片，简化了电流保护电路，避免了推挽变换器工作时磁芯偏磁导致的事故发生。
A method of stepping motor driver circuit was given, composed by a chopper type current mode switch regulator and a monolithic stepping motor driver TA8435H.
提出采用斩波式电流型开关电源结合单片式步进电机驱动器TA8435H，构成一种电机驱动电路的方案。
A low voltage current mode bandgap voltage reference circuit with a novel start-up circuit is designed.
介绍了一种低压电流模带隙电压基准电路，并提出了一种新颖的启动电路结构。
An APFC circuit based on average current mode control is designed and tested. It is indicated that the average current mode control has many advantages.
用平均电流型控制原理设计一个APFC电路，并进行了实际测试，证明该平均电流型控制的优越性。
In this paper, the methods of power factor correction are discussed, and the principal of boost active power factor correction circuit operated in critical inductor current mode is analyzed in detail.
本文讨论了功率因数校正的方法，分析了电感电流工作于临界模式的升压式有源功率因数校正电路的原理。
The protect range is relational to short circuit type and phase when phase differential current connection mode is adopted.
当采用两相电流差接线方式时，保护范围与短路类型和短路相别有关。
Current mode theory enables design of super wide frequency band, super high speed analog switches by introducing circuit structures and principles.
采用电流模理论和电流模电路设计超宽频带、超高速度模拟开关。
Designs on motor field and structure, controller main circuit current commuting mode design, TMS320F240 least system and system program consider system normal operation under fault condition fully.
电机场路结构设计、控制器主回路换流模式设计、TMS320F 240最小系统设计、程序设计充分考虑了故障应急状态下系统正常运行必要条件。
The principle of active power factor correction circuit operated in critical inductor current mode is analyzed in this paper in detail.
文中详细分析了电感电流准连续模式的有源功率因数预校正电路的工作原理。
This paper proposed a new current-mode OTA-C network configuration, the high-order current transfer function are realised on the circuit.
提出了一种新的电流模式OTA-C网络结构，由此实现了高阶电流传递函数。
An adaptive slope compensation circuit used in current mode DC-DC converters is presented.
提出了一种应用于电流型DC - DC转换器的自适应斜坡补偿电路。
In this paper, we studied on critical current mode active Power Factor Correction technology, and did a detailed analysis and design on voltage reference circuit and analog multiplier circuit.
本文研究了有源功率因数校正技术中的临界导通模式的基本原理，并对其中的电压基准源和模拟乘法器做了详细的分析和设计。
In order to measure accurately the load of electric locomotives and short circuit current, the secondary side of CTs connected with catenary and feeder should be connected in differential mode.
为了准确反映电力机车的负载电流或短路电流，应将接触导线和正馈线上的电流互感器次边差接。
This paper introduces the theory of slope compensation and presents a piecewise linear slope compensation circuit for peak current mode boost DC-DC converter.
为了防止亚谐波振荡以及提高系统的稳定性和带载能力，设计了一种全区间分段线性斜坡补偿电路。
Based on a current-mode integrator and proportion circuit multiple outputs by AOA, multifunctional second-order current-mode filter was proposed.
以AOA电流模式多路输出积分器和AOA电流模多路输出比例电路为基础，设计了多功能二阶电流模式滤波器。
For the use of off-line switching mode power supply IC, an internal power supply circuit combining with a high voltage startup current source is proposed.
结合高压启动恒流源设计了一种用于离线式开关电源的内部电源电路。
Near the critical point of the RLC-circuit, the residual voltage waveform changes form non-oscillating attenuation mode to distinct across zero oscillating mode when the peak current increases.
在RLC回路临界点附近，随着冲击电流峰值的增大，残压波波尾从非振荡衰减过渡到大幅度的过零振荡；
This thesis makes detailed analysis about the performance of 2010 Shandong Power Grid operation mode, pointing out that the main problems of this operation mode is the short-circuit current exceeding.
最后对山东电网2010年基础运行方式下电网性能进行细致浅析浅析，指出此运行方式存在的主要不足为短路电流超标。
This paper describes its advantages, introduces the current - mode control integrated device for switching power supply, and gives a experimental circuit.
本文就其优点作了叙述；对开关电源电流型控制集成器件作了简介；并给出试验电路。
Type of circuit Breaker, pole number, rated current of tripping device, reference temperature of ambient air mode of connection, kind of accessories and their working voltage ratings.
断路器型号、级数、脱扣器额定电流、周围空气参考温度、接线方式、附件种类和附件额定工作电压。
The high precision and large current controller are used widely. But in the situation where there is high common-mode voltage, the detection circuit of the output current is very complex.
高精度大电流控制器有着广泛的应用，但在高共模电压情况下输出电流的检测电路比较复杂。
A comparator circuit based on current-mode control used in PWM controller is presented that is able to compare 3-data at a time and latch output signals.
文中提出了一种用于PWM控制器的比较器输出电路的设计，该电路基于电流模式控制，能够同时对三路输入信号进行比较输出并对输出信号进行锁存。
A comparator circuit based on current-mode control used in PWM controller is presented that is able to compare 3-data at a time and latch output signals.
文中提出了一种用于PWM控制器的比较器输出电路的设计，该电路基于电流模式控制，能够同时对三路输入信号进行比较输出并对输出信号进行锁存。
应用推荐