DCEP (Direct Current Electrode Positive) is used for most stainless-steel welding.
直流反接用于大多数不锈钢的焊接。
The new material has such high energy density because it can operate at a higher voltage than current electrode materials and also store more lithium ions.
这种新材料具有高能量密度，因为它能够以比目前更高的电压的电极材料储存更多的锂离子个单一的百分比数字。
This forces the freed electrons to travel to the second electrode through a wire, creating an electric current.
而自由电子则通过一条导线移动至第二电极，从而产生电流。
First the current distribution on the electrode polarization: do not exist on the electrode surface, the current distribution.
初次电流分布：在电极极化不存在时，电流在电极表面上的分布。
Note the top electrode is guarded, so that only current flowing across the insulator is measured by the picoammeter.
注意，顶部的电极接保护，所以只有流经绝缘体表面的电流才为皮安计所测量。
Analysis on influence of ground electrode current in HVDC on AC power network.
直流输电系统接地极电流对交流电网的影响分析。
Otherwise, the current drawn from the cell electrodes will cause a voltage drop across the internal resistance of the electrode and may polarize the cell.
否则，从电池电极吸取的电流将会在电极的内阻上产生电压降并可能使电池极化。
Doubling hf-current results in a doubling of current density and a fourfold heat provided that the area of effective contact between the tissue ang the electrode remains constant.
如果人体组织和电极之间的有效接触面积保持不变，那么高频电流强度扩大一倍将会使电流密度增大一倍，并产生四倍的热量。
Current was the result of oxidation and reduction reaction were carried out in two electrode results.
电流的产生是由于氧化反应和还原反应分别在两个电极上进行的结果。
Through a combination of upper and lower engines, the electrode current in the smelting process is controlled to achieve the purpose of controlling the temperature of smelting furnace.
对铅锌矿冶炼厂生产作业进行自动化技术改造，通过上位机与下位机的有机结合，对精矿冶炼过程中的电极电流进行控制，实现熔炉温度控制，解决了传统手法可测不可控的难题。
Reducing welding current and weld time were found to reduce electrode sticking.
电极粘附力随点焊电流和点焊时间的减小而下降。
A rotating disc electrode system was designed to recover Cd and the current efficiency was over 90%.
设计出新型旋转圆盘电极体系回收金属镉，电流效率达到90%以上。
The polarization curves of copper physical development (CuPD) system were obtained by transient constant current step method on copper plated platinum electrode.
本文采用镀铜铂电极和暂态恒电流阶跃的方法测得了铜物显（铜物理显影）体系的极化曲线。
The experimental results indicate that the dielectric barrier discharge will show different forms and discharge current waveforms by fixing or rotating the grounding electrode.
实验的结果表明：接地电极静止或转动介质阻挡放电将呈现不同的放电形式和电流波形。
The response current of the enzyme electrode containing AgNPs photo-induced at different time was characterized by chronoamperometry.
利用计时电流法对不同光照时间纳米银颗粒组装的酶电极响应电流进行了表征。
The effects of electrode activation condition, current density, electrolyte temperature on electrolytic reduction are discussed.
讨论了电极活化条件、电流密度、电解液温度等因素对电解还原反应的影响。
The welding current can be reduced, which produces lower electrode temperature and enhances the electrode life.
可降低焊接电流，导致较低的电极温度从而提高了电极寿命。
Effects of PTFE content in electrode, current density, temperature of electrolyte and electric quantity on pinacol yield was discussed.
探讨了复合电极中PTFE含量、阴极电流密度、电解液温度、电解电量对频那醇产率的影响。
Surfacing process test is made on Q235 steel substrate by shielded metal arc welding process using electrode CHR322 at different welding current condition.
前言：采用焊条电弧焊工艺方法，选用C HR322堆焊焊条在Q235钢基体上以不同的焊接电流进行了堆焊试验。
The current character, the reversibility and the mechanism of electrode reaction etc. were also studied.
文中对体系的电流特性，电极反应过程的可逆性，电极反应机理等也进行了研究。
All sorts of random influence factor for welding quality is contained in the change of current, voltage, electrode displacement, etc. signals.
对于电阻焊过程，影响焊接质量的各种随机因素，均直接或间接地蕴涵在焊接电流、电压、电极位移等信号的动态变化之中。
The enzyme electrode based blood glucose meter is developed by the technology of immobilizing enzyme on pole and detecting resultant electrical current.
酶电极法血糖仪是采用酶的固化技术以及电检测的方法研制而成的。
At least one current source electrode is disposed on the sonde.
至少一个电流源电极布置在所述探测器上。
In this paper, the electrode structure and single electrode current exciting mode are deeply analyzed and optimized by the fundamental study of ERT technology.
本论文从ERT技术的原理性研究出发，针对该技术中电极结构设计进行了分析与优化，并对单电极电流激励模式做了深入的研究和优化。
The melting consistency of two cores is influenced by electrode type, welding current etc.
研究表明，双电极焊条两焊芯熔化的一致性受焊条类型、接电流等因素的影响。
The two kinds of preparation methods of the counter electrode (platinum) were discussed: electrochemical (constant current law) and thermal decomposition.
讨论了反电极铂的两种制备方法：电化学法（恒电流法）和热分解法；
Mechanical sensitivity and relation between the tunneling current and the distance of electrode are discussed.
讨论了系统的机械灵敏度及隧道电流与隧道电极间隙的关系。
Mechanical sensitivity and relation between the tunneling current and the distance of electrode are discussed.
讨论了系统的机械灵敏度及隧道电流与隧道电极间隙的关系。
应用推荐