The coupling heat transfer was calculated using fluid area and solid area coupling solution.
采用了流体域与固体域耦合求解法计算耦合换热。
It is difficult to confirm the internal boundary condition for the fluid-solid coupling heat transfer system.
固流耦合的办法可以将固、流结合面上比较难确定的外部边界转化为系统的内部边界。
How to confirm the internal boundary condition is a difficulty for above fluid-solid coupling heat transfer system.
确定此系统的内部边界条件成为发动机传热研究的难点。
It is difficult to confirm the internal boundary condition for the above fluid-solid coupling heat transfer system.
确定上述固体、流体耦合传热系统的内部边界条件成为发动机传热研究的难点。
According to the established whole-coupling heat transfer model, the steady-state heat transfer process in the furnace was simulated.
根据所建立的耦合传热模型，对常压加热炉内的稳态传热过程进行模拟。
In this research, a transient microstructure-prediction program was designed on the basis of coupling a previous heat transfer program.
焊接过程瞬态组织预示程序是在先前的焊接热传导程序基础设计而成的。
The cause of turbine stator blades was analyzed on the base of numerical simulation by means of air-thermal coupling for heat transfer and temperature distribution.
在内部流场气-热耦合数值模拟的基础上，研究了某涡轮导向器叶片烧蚀故障的原因。
The heat and mass transfer and coupling effect in wood drying were studied by applying the thermodynamics of irreversible processes.
应用不可逆过程热力学研究木材干燥过程热质迁移及其耦合效应。
The transient heat transfer process of piston set-cylinder liner system in gasoline engine was researched with direct coupling finite element method (FEM).
采用直接耦合的有限元分析方法对一汽油机的活塞组—气缸套系统的瞬态传热过程进行了研究。
Based on an axisymmetric unsteady conduction model by FEM, a numerical analysis model of unsteady heat transfer for the piston-liner coupling system of combustion chamber in an I.
本文在轴对称不稳定热传导有限元分析模型的基础上，提出了一个内燃机燃烧室的活塞与缸套偶合系统的不稳定传热数值分析模型。
The processes of fluid flow, combustion and heat transfer between the flue gas and tube without any simplification in the firebox of atmospheric heater were studied with the whole coupling method.
采用分区耦合的方法研究了常压加热炉辐射段内的流动、燃烧和管内外传热的工艺过程。
The method can evaluate the temperature-dependent heat transfer coefficient with the coupling calculation of temperature and latent heat according to the temperature curve …
在计算过程中，通过有限元法得到工件内部相应位置在相应时间段所产生相变潜热，并将各单元的相变潜热与单元温度场进行耦合计算。
The method can evaluate the temperature-dependent heat transfer coefficient with the coupling calculation of temperature and latent heat according to the temperature curve …
在计算过程中，通过有限元法得到工件内部相应位置在相应时间段所产生相变潜热，并将各单元的相变潜热与单元温度场进行耦合计算。
应用推荐