The load forecast is used as set point of heat supply system, and model error is used as corrected value of predictive control.
负荷预报作为供热系统的设定值，模型误差作为预测控制的校正量。
The linear relationship between the corrected value and measured value is used to balance the rotor in the influence coefficient method.
影响系数法是利用线性系统中校正量和被测量之间的线性关系进行转子动平衡。
Through to the massive samples measured that the value result with USES the corrected value contrastive analysis which this article method obtains, may determine this method the validity.
通过对大量样本测值结果与采用文中方法所得到的修正值的对比分析，可以确定该方法的有效性。
The formulas for the transformation of sound levels between linear spectrum and multiplex frequency band, or among various multiplex frequency bands, are derived and the corrected value is calculated.
推导线性谱声压级、倍频带声压级以及各倍频带声压级之间的转换公式，计算出修正值。
Corrected estimate: the corrected estimate of the work item, if the contributor doesn't set value to this data field, we believe its value is 0.
校正估计时间：工作项的校正估计时间，如果操作者没有设置该数据区域的值，那么我们相信该值为0。
Key Performance Metrics defined for each part of the value chain are visibly monitored. Deviations are quickly detected, corrected and improved.
为价值链上的每一环节界定的主要表现尺度是可监测的。偏差将迅速地被探测、纠正及改进。
The value of current sampling was corrected by the subsection interpolation method, and temperature was corrected by the linear correction.
对电流采样值进行了分段插值方法校正，并对温度进行了直线校正。
The exact results of the diffractive angle and coordinate value for imaging point can be obtained if corrected coefficient is used in these formulas to correct.
由校正后的公式计算的成象点，其衍射角及坐标值可获得精确的结果。
An agreed and known value, such as the elevation of a benchmark or sea level, to which other measurements are corrected.
一个经公认的已知值，如基点或海平面的高程，其它点的测量值根据该点的值进行校正。
We have discovered that the camera we use for micrography also includes a value of 96 dpi in our images, which has to be corrected.
我们发现显微镜上的相机拍摄的图像其dpi值为96，这需要进行修正。
In region of larger relief, the observed value of geothermal flow must be corrected for terrain.
在地形起伏较大地区，热流的实例值必须校正。
For design calculations, it is usually adequate to use the theoretical value for the approximate mixture ratio, corrected by a typical combustion efficiency factor.
对于设计计算，采用相应混合比的理论值，并用典型的燃烧效率系数来修正，通常这样做是恰当的。
For design calculations, it is usually adequate to use the theoretical value for the approximate mixture ratio, corrected by a typical combustion efficiency factor.
对于设计计算，采用相应混合比的理论值，并用典型的燃烧效率系数来修正，通常这样做是恰当的。
应用推荐