The corrected flow stress is generally higher than the uncorrected at the same strain rates and strain.
在相同应变速率、相同应变下，修正的应力要高于未修正的应力。
As compared with the original data, the average relative errors of the corrected flow and efficiency obtained from the model are 0.675% and 0.534% respectively.
与原节点数据相比，流量和效率特性拟合回代值的平均相对误差分别为0.675%和0.534%。
In some cases they may be corrected to resume the normal flow of events, in others they will make it impossible to meet the goal.
在某些情况下，他们可以被纠正以重新开始正常的事件流，在其他情况下，他们则达不到目标。
In addition, the constitutive models included in FLAC-3D are deep into research, and the stress increments are corrected in terms of the plastic strain increment while occurrence of plasticity flow.
此外，还对FLAC - 3d内嵌的本构模型深入研究，塑性流动发生时塑性应变增量对应力增量的修正。
Applying the correction coefficient of heat load, the formula on supply and return water temperature in variable temperature control with varied flow is corrected.
应用热负荷修正系数，对变流量质调节供回水温度公式进行了修正。
In region of larger relief, the observed value of geothermal flow must be corrected for terrain.
在地形起伏较大地区，热流的实例值必须校正。
A dynamic simulation model for non-homogeneous flow in wet steam turbine was developed and was corrected by a time step method, and then could be applied to dynamic simulation.
建立了透平湿蒸汽非平衡流动动态仿真模型，并进行了时间步长修正，模型可以用于蒸汽轮机的动态仿真计算。
As for the corrected models, the maximal relative error, the average relative error, the accumulate flow error are 5.93%, 0.93%, 0.13% respectively.
对该模型进行修正后得到气相流量最大相对误差5.93%，平均相对误差0.93%，累计流量相对误差0.13%。
The flow stress was corrected by the constitutive equation and the power dissipation map was obtained using the corrected stress.
由试验得出变形过程中的真应力真应变曲线，并利用本构方程对流变应力值进行修正，进而根据修正后的应力值绘制功率耗散图。
Finally, this similar water flow is corrected by the assessing hydrologic analogy and the water flow of object sample is worked out.
最后，用水文比拟法对相似流量进行修正，得出目标样本的流量。
Finally, this similar water flow is corrected by the assessing hydrologic analogy and the water flow of object sample is worked out.
最后，用水文比拟法对相似流量进行修正，得出目标样本的流量。
应用推荐