The cored wire injection process was used to produce vermicular cast iron.
应用喂丝工艺生产蠕墨铸铁。
Cored wire injection is a new technology for the production of ductile iron.
包芯线喂线处理生产球墨铸铁是一种新的球铁生产工艺。
The formula of element original content in the cored wire has been proposed.
提出了药芯焊中合金元素总原始含量的计算公式。
Basic flux-cored wire for backing weld to T91 tube was studied in this paper.
研究了用于T91钢管打底焊的碱性渣系药芯焊丝。
A new type of maraging steel metal powder-cored wire for die TIG surfacing is developed.
研制了一种用于TIG模具堆焊的马氏体时效钢金属粉芯焊丝。
A new type of age hardening alloy metal powder-cored wire for TIG surfacing is developed.
研制了一种用于TIG堆焊的时效硬化工具合金金属粉芯焊丝。
Abstract: Gas shielded flux cored wire is used in the domestic railway freight car industry.
摘要：气体保护药芯焊丝在国内铁路货车行业应用较少，目前主要采用气体保护实心焊丝。
This paper has expounded the importance and urgency of self shielded flux cored wire (SSFCW) study.
介绍了自保护药芯焊丝的特点，并指出加快自保护药芯焊丝研制的重要性和紧迫性。
On average, metal-cored wires cost more per pound than other filler metals, particularly solid wire.
一般来讲，金属粉芯焊丝花费要高于常规焊材，尤其是实心焊丝。
However, in most cases, only the use of welding method, cored wire solder in the pin-hole-shaped tail.
但多数情况下，只能采用焊接的方法，将芯线焊在孔形插针的尾部。
The drawing process of tubular flux-cored wire is different from common steel pipe because of flux core.
由于药芯的存在，管状药芯焊丝的拉拔不同于普通的钢管拉拔。
At the special request of the flux-cored wire welding underwater, the welding arc control system is developed.
根据药芯焊丝水下焊接的要求，研制了一套水下焊接电弧控制系统。
The experiments on desulphurization with Mg-bearing cored wire feeding in ladle are carried out in this paper.
本文介绍了钢包喂含镁包芯线脱硫工艺研究的结果。
A type of metal powder-cored wire with high hardness, wear-resistance and high toughness is studied in this paper.
本文研究了一种高硬度高韧性耐磨埋弧堆焊用金属粉型药芯焊丝。
Using high speed photography and ANALYSATOR HANNOVER, metal transfer modes of flux-cored wire were observed and analyzed.
采用焊接过程的高速摄影技术和汉诺威焊接质量分析系统对药芯焊丝的熔滴过渡形态进行观察分析。
The transition coefficients of alloying from cored wire to deposited metal during CO2 GMAW have been studied in this paper.
研究了药芯焊丝在CO2保护电弧堆焊过程中合金元素的过渡系数。
The producing methods of CG cast iron were discussed and pure magnesium and cored wire will be used as a main way to treat cost iron.
在列述蠕墨铸铁生产技术时，认为用纯镁及喂线法进行蠕化是今后获得蠕墨铸铁的主要方法。
The results showed that increasing the feeding speed, the amount of Ca-Fe cored wire and the diameter of the tundish nozzle can prevent blockage.
结果表明，提高喂线速度、加大喂线量和增加水口内径可避免水口的堵塞。
The percentages of the flux composition in YJ657 basic flux cored wire which affected the welding technology of basic flux cored wires had been studied.
研究了YJ657碱性药芯焊丝药芯粉的成分配比对焊接工艺性能的影响。
Compared with cored wire, the solid wires have not so good welding usability showing oxidized and crinkled weld appearance as the welding parameters are greater.
而对于实心焊丝，在较大焊接工艺规范下，很容易出现焊缝表面的氧化起皱，焊缝成型不良。
Technological process of CO2 gas shielded metal arc welding with stainless flux cored wire used for stainless steel tank construction is presented in this paper.
介绍了采用不锈钢药芯焊丝CO2气体保护焊焊接不锈钢储罐的工艺过程。
The result suggests that the coating of Al-based cored wire prepared by arc spraying has excellent high-temperature oxidation resistance and corrosion resistance.
研究结果表明：电弧喷涂铝基粉芯丝材制备的涂层具有优良的抗高温氧化和耐腐蚀性能。
Introduced the result of nodularization-inoculation treatment for iron melt by using cored wire injection process in the Tenth Branch Company of Inner Mongolia no.
介绍了在内蒙一机集团第十分公司用喂线法对铁液进行球化-孕育处理的结果。
The hardfacing alloy was deposited onto a low carbon steel substrate by self-shielded arc welding using nitrogen alloying self-shielded hardfacing flux-cored wire.
硬面合金是利用研制的氮合金自保护硬面药芯焊丝在低碳钢板上堆焊得到。
With austenitic welding material, solid wire, flux-cored wire and electrode, welded joint mechanical property of TCS ferritic stainless steel all can meet usability.
T CS铁素体不锈钢采用奥氏体型焊材，实芯焊丝、药芯焊丝和电焊条方法，焊接接头力学性能可以满足使用要求。
Flux-cored wire is applied to the austenitic stainless steel pipe by back weld, MAG for the filling and cosmetic weld, at horizontal fixed round welding vertically up.
采用药芯焊丝对奥氏体不锈钢管道进行打底焊接，MAG焊填充及盖面焊，立向上的水平固定全位置焊接。
A set of electromagnetic vibration powder feeding apparatus of the flux cored wire production line and its single chip controlling system have been designed in this paper.
研制了一套药芯焊丝生产线电磁振动送粉机构及其单片机控制系统。
As a new material of the thermal spraying, the metal cored wire has the advantages of adjusting the composition easily, the low price and the convenience to develop a new material.
金属粉芯线材在热喷涂领域中具有调节成分范围宽、价格低、研制新材料方便等特点。
Reducing content of hydrogen effect of fluoride, carbonate, active chide and rare earth oxide in weld by self-shielded flux-cored wire with CaF2-TiO2 MgO slag system is investigated.
探讨氟化物、大理石、高价氧化物和稀土氧化物在氟钙钛渣系自保护药芯焊丝中的降氢机理。
In the present study, the microstructure and properties of iron aluminide intermetallic coatings in situ synthesized by cored wire and high velocity arc spraying (HVAS) were investigated.
采用粉芯丝材和高速电弧喷涂技术(HVAS)原位合成了铁铝金属间化合物涂层，并研究了涂层的显微组织和性能。
应用推荐