For used molds are composed of six panels contains the core, Demoulding Bushing, gear and rack and the thrust piece, bearing and seal set with a square of the cold-side or "b" side.
举例用的模具是由六个板组成的包含型芯、脱模衬套、齿轮和齿条以及止推片、轴瓦和方形密封圈载一起的冷端或“B”面。
The thesis presents a practical die structure with Angle pin and gear shaft and rack for secondary combined inclined down loosing core of die casting hopper bodies.
本文给出了浮子室体铸件斜销-齿轴-齿条二级联合斜下抽芯压铸模实用结构，论述了模具结构特点和工作过程。
The thesis presents a practical die structure with angle pin and gear shaft and rack for secondary combined inclined down loosing core of die casting hopper bodies.
本文给出了拉钩铸件弯销-斜销二级联合斜向抽芯压铸模实用结构，论述了模具分型面的确定、结构特点和工作原理。
At the same time, introduce the principle of side core-pulling mechanism of gear and rack injection mold, and design gist of a rack.
掌握长抽距或斜抽芯塑件的结构工艺分析及抽芯距、抽芯力的计算，齿轮、齿条注射模侧向抽芯机构的原理和齿轮、齿条设计要点尤其关键。
In the structural design, the article emphasis on the points of core-pulling mechanism of gear and rack design. The requirement of mold structures are compact and reasonable.
而在结构设计方面，重点阐述了齿轮齿条抽芯设计要点，模具结构紧凑，合理。
The core cable rack is driven by a single electric motor and a gear wheel as well as a synchronous shaft so as to drive each core cable to rotate.
芯线架子由单个电机，采用齿轮与同步轴传动，带动每根 芯线转动；
The core cable rack is driven by a single electric motor and a gear wheel as well as a synchronous shaft so as to drive each core cable to rotate.
芯线架子由单个电机，采用齿轮与同步轴传动，带动每根 芯线转动；
应用推荐