It is also indicated that the QS1 Schering bridge is not applicable for the said test and the use of converter bridges suggested;
并指出：QS1西林电桥不适于测试膜纸复合绝缘电容器的介质损耗因数，推荐采用变频电桥；
In this paper, a resistance - to - frequency converter consisting of a Wheatstone bridge followed by an integrator and a comparator is described.
文中给出了一个由惠斯登电桥、积分器、过零检测器等组成的电阻-频率转换器。
Full-Bridge converter is the main circuit topology of the inverter.
论文选取全桥变换器作为主电路拓扑。
The full bridge converter operation is described in detail.
本文详细介绍了全桥转换器的工作情况。
This paper presents a novel zero voltage switching full bridge three level converter.
提出了一种新型的零电压开关全桥三电平直流变换器。
This paper introduces a novel topology about single-stage PFC converter based on bridge inverter and analyzes its theory of operation.
提出了一种基于桥式逆变电路的新型单级功率因数校正变换器的电路拓扑。
Phase - shifted converter realizes zero - voltage - switching with the use of leakage inductor of the main transformer, however, the realization of ZVS for lagging bridge leg is difficult.
移相控制全桥变换器能够实现开关管的零电压开关，但滞后桥臂难度很大。
Phase shifted converter realizes zero voltage switching (ZVS) with the use of leakage inductance of the main transformer, however, the realization of ZVS for lagging bridge leg is difficult.
移相控制全桥变换器能够实现开关管的零电压开关，但滞后桥臂难度很大。
The DSP sends out the phase shifting control signal and then that amplified by IR2110 chip. It can realize ZVS of the full bridge converter main power switch by the phase shifting drive control.
由DSP发出移相控制信号并经芯片IR 2110驱动放大，在移相驱动信号的控制下可以实现全桥变换器主功率开关的ZVS。
The system adopts asymmetry half bridge structure, which makes the main power converter fault tolerant.
由于设计采用了不对称半桥结构，提高了系统主功率电路的容错性。
A novel full bridge (FB)-phase shift (PS)-zero voltage zero current switching (ZVZCS) converter is proposed.
提出了一种新型的全桥移相零电压零电流变换器拓扑结构。
The static frequency converter used in pumped storage units generally adopts common thyristor as the rectifying inverting bridge.
用于抽水蓄能机组起动的静止变频器，其整流逆变桥通常采用普通晶闸管。
SMVSC is firstly applied to H-model bridge DC-DC converter, three-phase rectifier and three-phase inverter in this paper.
本文首次将滑模变结构控制应用于H型桥式DC-DC变换器、三相整流器和三相逆变器中。
Full-Bridge converter is selected as the main circuit topology in this paper.
论文选取全桥变换器作为主电路拓扑。
In this paper, the transfer characteristic of loosely coupled inductive power transfer full-bridge resonant converter is studied.
本文对基于非接触式感应电能传输技术的全桥谐振变换器的传输特性进行了研究。
The paper discussed a half-bridge converter of single-stage PFC with ZVZCS.
文章讨论了一种带有ZVZCS的单级PFC半桥变换器。
The modified bridge rectifiers are connected by series or parallel, to compose the double converter, that can be used to high power rectifying load.
将改进型桥式整流器串接或并接构成双重化变流电路，可用于大功率整流负载。
For isolated-type symmetry half-bridge bidirectional converter with phase-shifted control, a simplified circuit under 4 modes using the primary windings of transformer as reference object is built.
以隔离型对称半桥双向变换器为对象，建立了以原边为参考的4种模式下的简化电路，提出了结合开关函数的状态空间平均模型的建立方法。
This paper introduces application of monolithic computer AT90S1200 to single-phase bridge-type frequency converter PWM.
文章介绍了AT 90s1200单片机在单相桥式变频器系统中的硬件和软件设计。
This paper will study the principle of depressing the ripple of full-bridge phase-shift converter by coupled inductor filter.
本文将研究采用互感滤波器来降低全桥移相开关变换器纹波的原理。
This paper presents the studies of Fuzzy-Neural Network (FNN) control methods in the application of the full-bridge series type resonant DC-DC converter.
本论文研究的是模糊神经网络在全桥串联共振型DC - DC变换器控制中的应用。
The harmonic endanger was serious, which was engendered by double bridge cascade connection sequential control SCR converter.
双桥串联顺序控制的晶闸管变流器给电网带来不容忽视的谐波危害。
This paper discusses the operating mechanism of the inverse transforming bridge of the frequency converter in the process of regenerative braking of induction motors.
分析在感应电动机再生制动过程中变频器逆变桥的运作机理。
On the structure of system, the three-level converter of three phase bridge of the equipment in main circuit is built with IPM module based on IGBT, and its controller is made up of double CPU.
在系统结构的实现上，该装置的主电路采用基于IGBT的智能模块IPM构成三相桥三电平变流器；
By studying the theory and method of realizing inductive power transfer for moving electrical apparatus in detail, this paper designs the phase-shifting full-bridge series resonance converter.
文中详细分析了感应电能传输技术的理论和方法，进而设计出用于感应电能传输系统的移相全桥串联谐振逆变器。
This paper proposes an input-paralleled output-series half-bridge converter based on single half-bridge converter, it is suitable for the high output voltage and large power application.
为此，以半桥变换器为基本单元，提出了一种适合于高输出电压、大功率应用场合的输入并联输出的串联半桥组合式变换器。
A general design of digital twin-wire welding power supply was selected firstly, and two side-by-side IGBT full bridge converter main circuit structures were designed.
本文首先确定了双丝焊数字化电源的总体方案，设计了两台并行的IGBT全桥逆变主电路的拓扑结构。
Based on the practical situations of current construction equipment maintenance, the fault of master clutch, hydraulic torque converter, driving bridge, steering clutch and brake are discussed.
结合当前工程机械维修工作的实际情况，对主离合器、液力变矩器、驱动桥、转向离合器和转向制动器等部位的故障现象进行了深入的探讨。
Based on the practical situations of current construction equipment maintenance, the fault of master clutch, hydraulic torque converter, driving bridge, steering clutch and brake are discussed.
结合当前工程机械维修工作的实际情况，对主离合器、液力变矩器、驱动桥、转向离合器和转向制动器等部位的故障现象进行了深入的探讨。
应用推荐