A simple and efficient PI controller tuning method for large dead-time processes is presented.
提出一种简单而有效的大滞后过程PI控制器整定方法。
A method for the fixed-parameter PID controller tuning is proposed by taking into account of the nonlinearity and structural stiffness.
提出一种对固定增益PID调节器进行参数整定的有效方法。
Secondly, this algorithm is applied to the PID controller tuning and the industrial design with restrictions. The results are fairly well.
第二，将本文所提改进粒子群算法应用于工业PID控制器的参数整定，以及带约束优化的工业设计中，均取得了非常理想的效果。
LAB users often report that, even when gains have changed by one hundred percent or more, they have not needed to change controller tuning.
LAB用户时常报告说，即使当增益改变百分之一百或更多，他们也不需要改变控制调节。
The internal mode compensation controller is designed for the delay performance of TCP network system. The controller tuning method is presented based on the gain and phase margin.
本文针对TCP网络系统的时滞特性，设计基于内模补偿控制器，提出了基于幅值与相位稳定裕度的控制参数整定方法。
PI controller is used to control queue length of active queue management. But its trial method of controller tuning is aimlessness, the instant performance of algorithm is not enough satisfied.
I控制器常用于主动队列管理中，但参数整定上的试凑法具有盲目性，算法的瞬态性能也不够理想。
Based on the field investigation, the paper summarizes the engineering tuning range of the parameters of controller.
在现场调查的基础上，本文归纳出了调节器参数的工程整定范围。
On the basis self tuning predictor (STP) and self tuning controller (STC) are designed.
在此基础上设计了它们的自校正预报器(STP)和自校正控制器(STC)。
Combine blur control with general PID control, on line self-adjusting PID parameters according to different error and error variety-rate, which is called PID parameters self-tuning blur controller.
将模糊控制与常规pid控制相结合，根据不同的误差、误差变化率对PID的参数进行在线自动调整，这就是PID参数自整定模糊控制器。
This paper designed a kind of PID parameters self-tuning controller based upon blur control.
本论文设计了一种基于模糊控制的PID参数自整定控制器。
In this paper, a new multivariable self-tuning feedforward controller is presented.
本文提出了一种新的多变量自校正前馈控制器。
The recommended algorithm can also be employed as some kind of pre-tuning controller for high performance control system at the starting point in their complicated auto-tuning process.
对于更复杂自整定控制器，继电反馈方法可以作为一种理想并且适用的预整定器，在系统运行的初始阶段调节系统参数。
PID controller is widely used in the industry control process, but the parameters tuning is still a problem that people concerned.
PID控制器在当前的工业过程控制中仍有着广泛的应用，但其控制参数整定一直是难点问题之一。
This method efficiently makes use of expert experience in PID parameter tuning, and the controller has the merits of both fuzzy control and PID control.
此整定方法有效地把专家经验应用于PID参数调节中，控制器集模糊控制器和PID控制器的优点于一身。
Tuning a real controller - modeling, process identification, fine tuning.
调节一个实际控制器-建模，过程确认，微调。
Because of large scale variance of parameters and nonlinearity of the object, there are many difficulties in tuning of the controller.
由于对象存在着非线性特性及参数变化范围大等特点，给控制器参数的工程整定带来很大困难。
To reduce the influence of disturbance, raise the positioning accuracy, a LQG optimum self tuning controller with integral is designed.
为了减少干扰的影响，提高定位精度，设计带积分的LQG最优自校正控制器。
The experimental result shows that the designed self tuning controller can ensure the accuracy of gauge control system, the quality of products has been improved evidently.
实验结果表明，所设计的自校正控制器确保了系统的控制精度，明显地提高了产品质量。
The design of PID parameter controller based on fuzzy self tuning is introduced.
提出了一种模糊自整定PID参数控制器的设计方法。
In this paper we design a fuzzy self-tuning controller which can be used in motion control of oceanic dynamic positioning systems.
本文设计了一个用于海洋动力定位系统运动控制的模糊自适应控制器。
This defect seriously affects the tuning of temperature controller and causes bad temperature control results when the load change command varies very often.
这一缺点严重影响到温度调节器的整定，当负荷变化指令变动频繁时温度控制效果也不会好。
Feedback control is a parameter self tuning fuzzy controller and the burn through point is calculated by quadratic curve method.
反馈部分为参数自调整模糊控制器，终点的计算采用二次曲线拟合法。
Therefore, research on the method of system modeling and controller parameters tuning is very important.
因此，研究基于现代优化技术的系统建模方法和控制器参数整定技术具有重要的意义。
Characteristics and control process of a sampling controller is analyzed and methods of design for controller parameters and engineering tuning are described.
分析一种采样控制器特性及控制过程，给出控制器参数设计及工程整定方法。
A method is proposed for parameters tuning of normalized PID controller with chaos variables.
提出了一种基于混沌优化的PID控制器参数整定方法。
In this paper, a new automatic tuning method of PID controller based on dynamic neural network is proposed and an online parameter tuning algorithm is given out.
提出一种基于动态神经网络的PID控制器，给出pid参数在线自整定学习控制算法，并进行了算法仿真研究。
Baed on the Robust tuning method of conventional PID controller, a new on-line PID self tuning method is put forward.
在常规pid控制器的控制参数的鲁棒整定法基础上，提出了一种新的PID在线整定改进方案。
A new tuning method for PID controller design is proposed as a class of stable and minimum phase plants.
该文为一类稳定的最小相位控制对象提出一种新的PID控制器的参数整定方法。
This paper presents a new generalized predictive self-tuning controller and its successful application on the machine direction distribution control of a polyster film spread line.
本文给出了一种新型的广义预测自校正控制器及其在涤纶薄膜拉伸生产线上的纵向分布控制中的成功应用。
This paper presents a new multivariable pole - assignment self-tuning dynamic decoupling controller for a class of multivariable processes.
本文针对一类多变量系统提出了一种新的极点配置自校正动态解耦控制器。
应用推荐