Based on the constraint matrix method developed by Japanese scholars, a generalized constraint matrix method was proposed for calculation of the temperature stress of RCCDs.
在日本学者提出的约束矩阵法的基础上，提出了用来计算碾压混凝土坝温度应力的广义约束矩阵法。
Excepting that the full stress design is employed for the stress constraint, the uniform derivative criteria are used for the other constraints.
除应力约束采用满应力法外，其他各约束都采用均匀导数准则。
Stress is non - linear distribution, this phenomenon is called constraint bending.
应力呈现非直线分布，这种现象称为约束弯曲。
End constraint has an influence on distribution of stress in rock specimen, failure pattern and pattern of shear zone.
试件端面效应直接影响试件内的应力分布、试件破坏形式和剪切带图案。
By dealing with constraint condition and cell parameter, results of elements' stress and nodal displacement of the keel were obtained under gravity load condition.
对约束条件以及结构单元参数进行了分析，得到了龙骨结构在重力载荷作用下的应力和变形。
The results show that bolts can offer both stress constraint and displacement constraint to rock mass, and provide a basis for support design and stability...
揭示了锚杆对岩体提供应力和位移约束机理。从而为深部不稳定巷道的支护设计与稳定性分析提供了依据。
The general yield load, stress and strain rate ahead of notches of I specimens with larger plastic constraint is larger than that of V specimens with small plastic constraint.
塑性拘束较大的直缺口试样(i)的整体屈服载荷及缺口前的应力、应变和应变率比塑性拘束较小的V缺口试样(V)大。
Owing to the loss of their adjacent material constraint, the residual stress on the cutting edge of the small test block reduces, even changing from compressive stress to tensile stress.
由于失去与原有相邻材料的约束作用，小试块切割的边缘处残余应力减小，甚至由残余压应力转变为残余拉应力。
A set of inequality constraint conditions of the strength parameters is derived from the convexity of the strength criterion, which is expressed in a quadric form in terms of stress components.
本文从一般强度理论出发导出各向异性材料应力形式张量多项式强度理论，根据强度准则的外凸性得到应力二次形式强度准则的强度参数限制条件。
The concrete transfer beam applies laminated beam in construction, and because of the constraint of earlier pouring concrete to later pouring concrete, shear stress is induced in lamination.
混凝土转换梁采用叠合梁的施工方法，由于先浇混凝土对后浇混凝土的约束，使叠合面产生剪应力。
This paper developed a three dimension finite element model to analyze stress distribution on residual limb of crus under lumped loads with different displacement constraint conditions.
通过建立三维线性有限元模型来分析在集中载荷作用下小腿肢体残端的应力分布，且分析了不同边界条件对肢体残端应力分布的影响。
This paper developed a three dimension finite element model to analyze stress distribution on residual limb of crus under lumped loads with different displacement constraint conditions.
通过建立三维线性有限元模型来分析在集中载荷作用下小腿肢体残端的应力分布，且分析了不同边界条件对肢体残端应力分布的影响。
应用推荐