Test results of simulation system show that grid-connected voltage is synchronization with grid phase voltage.
通过对光伏并网系统的测试表明：并网电压与电网相电压同频同相。
Charge and current, and magnetic flux and voltage, are connected through their definitions.
电荷和电流，磁通量和电压，根据它们的解释关联在一起。
The greater the intensity of the light, the more voltage the Arduino sees at the connected pin.
光照越强，Arduino在连接插脚处读取的电压越多。
I have connected a volt meter to our single cell lemon battery. The meter tells us this lemon battery is creating a voltage of 0.906 volts.
我将一个电压计连到了我们的单芯柠檬电池上。电压计显示柠檬电池可以提供0.906伏特的电压。
And these electrodes are then connected to a variable voltage power supply.
这些电极然后，和一个变压电源连接起来了。
If the load resistor was connected directly across the voltmeter input terminals, the current through the relay contacts would cause a voltage drop and the measured cell voltage would be in error.
如果负载电阻被直接连接到伏特计的输入端子，通过继电器触点的电流会产生电压降，测得的电池电压将存在误差。
When the voltage is removed, the separated charges generate a decaying current through circuits connected to the insulator as they recombine.
当撤去电压时，这些分离的电荷在重新组合时会在与绝缘体相连的电路中产生衰减的电流。
The electrical elements connected include circuit breaker disconnector and earthing switch current transformer voltage transformer lightning arrester bus etc.
连接的电气元件有断路器、隔离开关与接地开关、电流互感器、电压互感器、避雷器、母线等。
Because you need both a voltage source and a ground in order to create a complete circuit, you need to have a sourcing input or output connected to a sinking output or input.
因为在一个完整的电路中必须有一对电源和地。
Figure 2-39 shows an electrometer connected to a current source that consists of a voltage source in series with a resistor.
图2 - 39所示为静电计和由电压源及电阻器串联组成的电流源相连接。
This feedback being connected downstream Q1 transistor, the general behavior of this voltage supply is very sensitive to sensor impedance variation.
这个反馈被连接到下游的三极管Q1，此电源电压的特性，对阻抗的变化很敏感。
Similarly, a current transformer is connected with its primary in the high-voltage circuit.
同样，电流互感器是与它的主要的高电压电路。
To monitor the output voltage, a voltmeter is connected in parallel with the load resistance.
为了监测输出电压，将一个伏特计与负载电阻并联在一起。
This process of converting the transducer output into a voltage signal which can be connected to the rest of the system is called signal conditioning.
这种将传感器输出转换成电压信号，并与系统的其它电路相连接的过程，称为信号调理。
A terminal that SOC embedded controller is taken as the core has been designed to be connected with the apparatus of digital voltage detection by RS485 bus.
设计了以SO C嵌入式控制器为核心的终端，通过RS485总线与现场数字电压检测仪连接，建立了用电参数监测管理系统。
The state of the memory element can thereby be detected by a voltage comparator sense amplifier that is connected to the bit line.
因此可通过连接到位线的电压比较器读出放大器来检测存储器元件的状态。
Connected to the other input of the error amp is the midpoint of a voltage divider. We'll come back to this later.
连接误差放大器另一个输入点的是一个电压分压器的中点电压。稍后我们再来讨论。
A driving unit is connected to the first substrate and outputs a common voltage.
驱动单元连接到第一基板，并输出公共电压。
The cable monitoring module is connected to the central unit via the sitras pro baplus dc buffer amplifier and is powered by the contact line voltage .
另一个可选控制功能是对基于测得电压接触线电压及测试电流的剩余区间电阻进行计算。
The high voltage direct current (HVDC) system connected with weak AC system is considered to be one of the causes for voltage instability.
与弱交流系统相连的高压直流系统被认为是引起电压不稳定的一个因素，评价交直流系统电压稳定性的方法相当复杂。
Either AC Voltage or DC Voltage can be connected.
无论交流电压或直流电压均可连接。
The filaments are connected in such a way that they are at zero RF voltage.
细丝被连接在如此的一方法以致于他们是在零的射频电压。
The equipment which connected in the DC bus includes smoothing reactors, capacitors, voltage dividers, optical current transducers and arresters.
连接于极线的输电设备主要有平波电抗器、滤波电容器、直流电压分压器、光学电流传感器、直流避雷器等。
Therefor, it is suggested that a resistor or a capacitor be connected with the relay in parallel to lower the exciting voltage at both ends of the output relay.
为此，提出了在继电器两端并联一个电阻器或者电容器的改进方案，使其起到降低输出继电器两端激励电压的作用。
A power source connected to the two rails normally maintains a voltage between them while they are unoccupied.
当轨道一段没被占据时，连接两个轨道的电源保持两边电压正常。
Carry out all measurements and check all functions dependent on the high-voltage power supply being connected.
测量并检查所有接通高压电应产生的作用；
The low voltage circuit (even with low voltage on it) shall also be connected with protective earth, thus the dangerous voltage can be detected.
低电压电路（即使它们是低电压）必须和保护地连接，这样危险电压才能被检测出来。
Electrodes inside each end of the glass tube are connected to a high-voltage source.
玻璃管两端内侧的电极与一个高压电源相接。
The emitting coil and capacitance are connected in parallel and form a resonant amplitude-modulation circuit, which converts the impedance into output voltage.
利用发射线圈与电容并联的谐振调幅电路，将线圈阻抗变化转换成电压的输出。
The emitting coil and capacitance are connected in parallel and form a resonant amplitude-modulation circuit, which converts the impedance into output voltage.
利用发射线圈与电容并联的谐振调幅电路，将线圈阻抗变化转换成电压的输出。
应用推荐