And the barrier functions have been constructed at a boundary point which satisfies an exterior cone condition.
同时，又在满足外部准条件时，给出了闸函数的具体形式。
We defined the new quasi-cone condition, established the homotopy equation and proved the global convergence of this homotopy method.
通过对可行域定义新的拟锥条件，给出相应同伦方程，并证明此同伦算法在此拟锥条件下具有全局收敛性。
In this paper, the strong extremal principles have been proved for second or der linear elliptic equations on the domain which satisfies an interior cone condition.
本文对一般的二阶线性椭圆型方程，在满足内部锥条件时，证明了其强极值原理。
In this paper we construct a new interior-point homotopy method for solving fixed-point problem in nonconvex set, and prove the convergence under the weak normal cone condition see Definition 2.
本文构造了一个新的求解非凸区域上不动点问题的内点同伦算法，并在弱法锥见定义2。
The completeness condition for 3d cone beam exact reconstruction is analysed and derived theoretically, and discussion about some source orbits follows.
本文从理论上分析推导了3d锥束精确重建的完全条件，并结合一些具体的源点轨迹进行了讨论。
The tensile strength, zinc coat mass and service life of die of galvanized steel wire after drawing are compared on the condition of different work cone angle.
在不同的工作锥角度下，比较镀锌钢丝拉拔后的抗拉强度、锌层质量、模子寿命。
In this paper, the concept of strong acute cone is introduced, and the necessary and sufficient condition for existing such cone in a infinite dimensional space is obtained.
本文提出了强锐角锥的概念，并就无限维空间证明了一个凸锥为强锐角锥的必要充分条件。
Through indoor simulated test, the influence of boundary condition, size effect, radius ratio, stress state and relative density on cone resistance be determined.
通过分析影响室内模拟试验的影响因素，得到室内试验修正系数与侧向边界条件、半径比、初始应力状态以及相对密度的关系曲线。
The hydraulic cartridge cone valve is chosen for the study of possibility to explore its effects of geometry parameters and boundary condition on flow field and cavitation of cone valve.
以插装型液压锥阀为研究对象，研究了几何结构参数及边界条件对锥阀流场及气穴现象的影响。
There is also a relatively rare condition called keratoconus where the cornea becomes progressively thinner and cone shaped.
当然，在极少数情况下，角膜会逐渐地变地很薄，形成圆锥形角膜。
Saturation gain increases and polarization sensitivity decreases in condition of longer cone length remaining the same cone degree.
在同一锥度下，长锥形长度能提高饱和增益，降低偏振灵敏度。
TIGHT IN CENTER : Condition of inner diameter of cone; inner diameter is not straight.
中心偏紧：出现在内圈的内径里，内径不是直的。
TIGHT IN CENTER : Condition of inner diameter of cone; inner diameter is not straight.
中心偏紧：出现在内圈的内径里，内径不是直的。
应用推荐