The results show that the condensation coefficient decreases with the increase of the temperature.
模拟结果表明，不同模型得到的凝结系数都随温度的升高而减小。
The molecular dynamics simulations for argon at different temperatures show that the condensation coefficient increases with the decrease of the system temperature.
对不同温度条件下的分子动力学模拟表明，氩的凝结系数随系统温度的升高而减小。
A condensation ratio coefficient is introduced to obtain the steam volume under water level in the drum.
引入凝结比例系数，简化了汽包液面下汽容积的求取。
And the increase of the condensation heat transfer coefficient became to be larger when corona discharge happened.
在有电晕放电的情况下，凝结换热系数增加加快。
The theoretical analysis model predicts the mean condensation heat transfer coefficient and the predicted mean condensation heat transfer coefficient is compared with experimental data as wall.
同时，由该模型对冷凝段的传热系数进行了预测，并将预测值与实验值进行了对比分析。
There isn ta general accepted method to calculate the effect of air on the condensation heat transfer coefficient so far.
空气量对蒸汽凝结放热系数影响的计算，目前还没有一个人们普遍公认的计算方法。
Experimental results show that the condensation heat transfer coefficient of thermoexcel-C tube decreases as the saturation vapor temperature increasing.
实验结果表明：随着饱和蒸汽温度的提高，C管的凝结换热系数下降。
The calculated results for steam filmwise condensation indicate that the heat transfer coefficient increases with the contact angle increasing when the contact angle ranged within a certain degree.
计算结果表明，接触角在一定范围内，膜状冷凝传热系数随着接触角的增大而增大；
The fact that different substrate materials require different optimal processing conditions and demonstrate different condensation heat transfer coefficient, can be drawn from the present results.
实验结果也表明冷凝表面基体材料对冷凝传热性能有一定的影响。
Owning to the degradation of the heat transfer coefficient and large amount of condensation heat rejection, the performance of incomplete condensation of M3 has been found at the condenser outlet.
由于混合工质冷凝散热量的增加及传热性能的下降，因此工质M3在冷凝器的出口出现了不完全冷凝现象。
Owning to the degradation of the heat transfer coefficient and large amount of condensation heat rejection, the performance of incomplete condensation of M3 has been found at the condenser outlet.
由于混合工质冷凝散热量的增加及传热性能的下降，因此工质M3在冷凝器的出口出现了不完全冷凝现象。
应用推荐