The pit then grows through the compressive layer, and the change in residual stress state and the pit geometry initiate stress corrosion cracking.
随后斑点穿过压缩层继续扩展，剩余应力发生改变，斑点最终导致应力腐蚀裂纹。
These larger ions take up more room and are pressed together when the glass cools, producing a layer of compressive stress on the surface of the glass.
这些钾离子占据更大的空间，当玻璃冷却下来的时候，钾离子便挤压在一起，从而在玻璃表面生产一层压应力层。
Restoration of the shot-peened layer during overhaul is important to ensure that the shot-peen compressive residual stresses are maintained or restored.
大修中喷丸层的恢复相当重要，确保喷丸压缩层的剩余应力大修或应力恢复。
Test shows that the depth of residual compressive after chemical heat treatment is correspondent with that of diffusion layer.
试验表明，化学热处理后残余压应力的深度往往与渗层深度相一致。
According to the settlement in different depth, major compressive deformation develops in area nearby stabilized layer bottom.
分层沉降观测结果表明，复合地基的主要压缩变形发生在加固区底部和下卧层顶部的一定范围。
Due to the distinct difference in tensile and compressive properties, the position and deformation curvature of curved neutral layer will change with time for the! Strata in a creep state.
由于岩石材料抗拉与抗压性能的明显差异，使岩层受蠕变作用时，其弯曲中性层位置及变形曲率都将随时间变化。
This kind of nanostructured surface layer with compressive stress could significantly increase the fatigue strength of butt welded joint.
这种压应力纳米强化层可以明显地提高对接接头的疲劳性能。
The dependence relations among compressive strength, splitting tensile strength and axial tensile strength of RCC with layer surface have been obtained.
试验给出有层面碾压混凝土抗压强度、层面劈拉强度、层面轴拉强度间相关关系。
The results indicate that it's possible that both tensile stress and compressive stress exist in the same layer of the unsymmetrical laminates due to the existence of residual bending stress.
指出非对称型层合材料由于弯曲应力的存在，可产生残余弯曲变形并使残余应力沿厚度方向交替变化。
The existence of the compressive stress in the surface layer is the main reason for the strengthening of ceramics.
表层压应力的存在是瓷体增强的一个主要原因。
The results show that the stress in ceramic layer is mainly for lateral compressive one, and its maximal stress occurs in the place that is at the distance of 1/3 thickness from coating surface;
结果表明，陶瓷层内的残余应力主要表现为横向压缩应力，且最大值位于距陶瓷层表面1/3厚度处；
The results show that the stress in ceramic layer is mainly for lateral compressive one, and its maximal stress occurs in the place that is at the distance of 1/3 thickness from coating surface;
结果表明，陶瓷层内的残余应力主要表现为横向压缩应力，且最大值位于距陶瓷层表面1/3厚度处；
应用推荐