Due to compression process influence the air dew point of compressed air in the pipeline, run it will gradually decrease temperature, so the compressed air system always have liquid water.
由于压缩过程影响空气的露点，压缩空气在管线中运行时温度会逐渐降低，所以压缩空气系统中总是有液体水存在。
Increase the compression degree can make arc of high temperature plasma jet extended, form more uniform high temperature area, and increase the speed of the jet, can reduce the width of the poor.
增加电弧的压缩程度可以使高温等离子射流延长，形成更为均匀的高温区域，同时加大射流的速度，可以减小切口上下的宽度差。
The relationship between temperature, carbon loss rate and compression strength of coke in the lumpish section of blast furnace was investigated.
重点研究焦炭在高炉块状带内的抗压强度与温度和反应程度的关系。
Compressor internal high temperature compression part will lead to oil evaporation, produce oil steam.
压缩机内部的高温将导致压缩机油部分蒸发，产生油蒸气。
Excellent resistance to oil, high temperature resistance, weather resistance are good, but the mechanical strength, compression deformation rate and water resistance is slightly worse.
对油品有极佳的抵抗力，耐高温、耐候性均佳，但机械强度、压缩变形率及耐水性稍差。
As two means to get a low temperature, two-stage compression cycle and cascade cycle have their advantages of economical performance in different temperature range.
对于获取低温的两种手段—双级压缩循环和复叠循环来说，它们分别在不同的温区具有经济性优势。
Measurements have been made to determine the relation of the tension, the compression and the shearing of PUR foam at low temperature with its density, direction and temperature.
测定了低温下聚氨酯硬泡沫塑料拉伸、剪切和压缩弹性模量与泡沫密度、方向以及温度的关系。
The kinetic curves properties response aging time and temperature were obtained with the coefficient of compression stress relaxation as index of aging property change.
用压缩应力松弛系数作为老化性能变化指标，得出了性能随老化时间和温度变化的动力学曲线。
Shock pressure, internal energy and shock temperature were calculated as function of compression.
冲击压力、内能和冲击温度被计算为压缩度的函数。
When the rock get damage caused by temperature stress, the evidently change of rock compression strength will happen, which seriously influences the stability of engineering.
当岩体受到温度应力作用引起损伤，岩石的抗压强度发生显著的变化，严重影响着工程的稳定性。
The front impact roller causes transverse plastic compression strain in the weld which is in the brittle temperature range, which counteracts the tensile strain which leads to hot cracking.
前轮对处于脆性温度区间的焊缝金属施加一个横向挤压塑性应变，减小甚至抵消致裂的拉伸应变，防止了焊接热裂纹的产生。
The temperature fields in combustion Chambers of simulated engine compression process have been measured.
测量出了模拟内燃机压缩过程的缸内温度场。
The grain fracture of energetic particle bed as a result of dynamic impact and dynamic compression at different temperature was measured by using a high-low pressure launch set.
利用高低压发射装置，测定了含能颗粒床在不同环境温度下动态撞击与动态挤压的破碎程度；
In high temperature zone, as the temperature rising wood bending strength was reduced, and compression strength perpendicular to grain had gained in strength.
在高温区域，随着温度的升高，抗弯强度被明显削弱，而横纹抗压强度则得到增强。
The high temperature compression strength was researched using a high temperature compressive testing machine with adjustable atmosphere.
采用可调气氛高温抗压试验机研究焦炭的高温抗压强度。
In addition, from a design perspective, this kind of compressor design for level 1 compression, pressure than too big, easy cause exhaust temperature is too high, cause cylinder coke, cause accidents.
另外，从设计角度看，这种压缩机设计为一级压缩，压比太大，易引起排气温度过高，造成气缸积炭，导致事故发生。
The hot compression test was performed, and the effects of the deformation rate, the deformation temperature, and the preparation process on mechanical property of the as–sintered alloys were studied.
对放电等离子烧结合金进行高温压缩试验，研究了变形速率、变形温度和试样制备工艺对合金力学性能的影响。
When the pressure becomes very high and temperature very low, the compression factor of the real gas should be considered in the engineering design.
当压力很高、温度很低时工程设计中常引入压缩因子。
The relationship between the compression strength and temperature could also be described by straight line.
抗压强度与温度的关系也可以用直线来进行描述。
The influences of the intake charge temperature, fuel air equivalence ratio, compression ratio, CO2 to combustion and pollution are studied.
分析了进气温度、燃空当量比、压缩比、CO2对燃烧和排放的影响。
The influence of the dry degree of wet steam and water droplet diameter on the discharge temperature and compression power is discussed.
分析了湿蒸气进气干度及水滴微粒直径对排气温度、排气压力和压缩功率的影响。
The compression pressure and temperature had a smaller influence on contact resistance compared with contacting pressure and PF content.
模压压力对接触电阻已有一定程度的影响，但其影响幅度不如接触压力和树脂含量那么大。
But there are some shortage of ordinary single-stage heat pump in low-temperature environment, such as high compression ratio, devoid heating power and low efficiency.
但普通单级空气源热泵热水器在低温环境下运行中存在压缩比过大、制热量不足和制热效率太低等问题。
The temperature rise near explosive welding interface is caused by explosive adiabatic compression and abnormal energy deposition.
爆炸焊接界面附近温升是由爆炸绝热压缩和畸形变形能沉积两者造成的。
Deformation twinning of cast magnesium alloy AM60 was investigated by compression at room temperature with various deformation degrees from 3.
在电子万能试验机上对铸态am 60镁合金进行室温压缩试验，研究了在变形量分别为3。
The high temperature compression strength of coke was studied using a high temperature compression testing machine with adjustable atmosphere.
采用可调气氛高温抗压试验机研究了焦炭的高温抗压强度。
Thought water is a good refrigerant, it is difficult to be used directly in a common compression refrigeration system due to its very low pressure and vapor density at the evaporation temperature.
由于水的蒸发压力低、比容大使得水作为制冷剂直接用于压缩式制冷系统还有很大的困难。
The effects of the contents of KH-550 and ester titanate coupling agent and that of glass bead on the compression strength and Martin heat resistant temperature of bismaleimide(BMI)were investigate.
研究了处理剂用量与玻璃微珠加入量对改性双马来酰亚胺树脂压缩强度及马丁耐热温度的影响。
The effects of deformation temperature and the strain rates on deformation behavior and microstructure of the semi-solid LY11 alloy were investigated in the condition of isothermal compression.
研究了变形温度和应变速率对半固态LY11合金变形行为和微观组织的影响。
The effects of deformation temperature and the strain rates on deformation behavior and microstructure of the semi-solid LY11 alloy were investigated in the condition of isothermal compression.
研究了变形温度和应变速率对半固态LY11合金变形行为和微观组织的影响。
应用推荐