This is a miniature conveyer system driven by compressed air that transports small components in an endless cycle.
它是一个小型传送系统,由空气压缩机驱动,能将小型元件无休止的循环传送。
MPACT is a pneumatic system that generates the high-pressure, compressed air required to jettison weapons from various military aircraft.
MPACT是一种气动系统,能产生高压,它能压缩空气,用于从各种军用飞机上投放武器。
Indeed, a compressed-air energy storage system would look similar to the U.S. natural gas storage system.
确实压缩空气能源储存系统也与天然气系统有不少相似。
Due to the compressed air pipe internal may produce pollution, so in the air into the powder coating system best filter processing after before.
由于在压缩空气管道内部可能产生污染,所以在空气进入粉末涂装系统之前最好经过过滤处理。
Compressed air system is the most important equipment is perhaps after cooler.
压缩空气系统中最重要的设备也许就是后冷却器。
If the compressed air system problems, need liquid water by condensation water filter or the drainage device to emerge.
如果压缩空气系统中液态水问题突出,则需要采用凝结水过滤器或排水装置加以脱出。
With compressed air temperature drop, the excess oil vapour condenses into liquid oil, to make the powder coating system problems.
随着压缩空气温度降低,多余的油蒸气将凝结成液体油,从而使粉末涂装系统出现问题。
Discharge valve can be will collect the liquid and solid particle emissions, prevent the liquid flow off the downstream, the pollution downstream compressed air system.
排放阀可以将收集的液体和固体微粒排放掉,防止液体流向下游端,污染下游端的压缩空气系统。
We have seen how the mixture of air and fuel is delivered by the fuel system to the engine cylinder, where it is compressed, ignited, and burned.
我们已经了解油气混合燃料是如何通过燃料供给系统输送到发动机气缸,并在气缸中压缩、点火、燃烧的。
This paper will discuss the purpose of efficient compressed air system, component, selection and maintenance.
本文将讨论高效压缩空气系统的目的、组件、选择和维护。
Once the compressed air system problem will cause production line parking, coating quality deterioration.
一旦压缩空气系统发生故障,将造成生产线停车,涂装质量恶化。
After cooling of the compressed air after a stop valve into the gas system.
冷却后的压缩空气经过一个截止阀进入用气系统。
Rotary compressor is most suitable for close to full load operation conditions of the compressor compressed air system.
旋转式压缩机最适用于接近压缩机满负荷工况下运行的压缩空气系统。
Due to compression process influence the air dew point of compressed air in the pipeline, run it will gradually decrease temperature, so the compressed air system always have liquid water.
由于压缩过程影响空气的露点,压缩空气在管线中运行时温度会逐渐降低,所以压缩空气系统中总是有液体水存在。
Air compressor is compressed air system is the most main equipment.
空压机是压缩空气系统中最主要的设备。
Therefore, the compressed air system reliability and the ability to pollution is powder coating system very important factors.
因此,压缩空气系统的可靠性以及去污染的能力是粉末涂装系统十分重要的因素。
Compressed air actual if keep steam condition, won't cause system problems, if want to remove all of the water vapor in the compressed air is not only very expensive, and it is unrealistic.
压缩空气中的水气如果一直保持蒸气状态,就不会造成系统问题,若要驱除压缩空气中的所有水蒸气不仅十分昂贵,而且是不切实际的。
The flocculation filter and is easy to be automatic emissions from compressed air system to remove liquid oil.
采用絮凝过滤器和自动排放器很容易从压缩空气系统中除去液态油。
In order to realize the compressed air system USES must be free from the air pollutants, the pollutants will make powder coating system performance deteriorated.
为了实现压缩空气系统的用途必须除去空气中的污染物,这些污染物将使粉末涂装系统的性能恶化。
To keep compressed air system smoothly running.
确保压缩空气系统平稳运行。
This system provides a sinusoidal and other shape load traces using normal compressed air controlled electronically and is an assembly of commercially available components.
这种系统由电子控制的压缩空气产生正弦和其他形式的荷载,并用很易购得的部件装配而成。
The compressed air drying of water vapor pressure points with any expressed as the air pressure in particular piping system of compressed air does not occur within the lowest temperature setting.
干燥器中压缩空气的水蒸气含量用压力凝露点表示,即在特定压力的空气管线系统内压缩空气不发生凝结的最低温度。
The main purpose of the buffer is to prevent the compressed air system pressure fluctuations, compressed air happened to prevent further cooling, prevent compressor working too much.
缓冲器的主要目的在于防止压缩空气系统的压力发生波动、防止压缩空气进一步降温,避免压缩机工作过度。
Most of the coating factory are the single set of compressed air system, this is a very economic method, it needs to all of the equipments and compressed air compressed air.
绝大多数涂装厂都采用单套压缩空气系统,这是非常经济的方法,它向所有需要压缩空气的设备提供压缩空气。
Liquid water is compressed air in powder coating system to produce a major problem, is the best way of setting out before in liquid water in the compressed air of the excess moisture to rule out.
液态水是压缩空气在粉末涂装系统产生的主要问题,最好的办法是在液态水凝结出来之前将压缩空气中过剩的水气排除掉。
压缩空气系统。
The purpose of the pneumatic system is to supply compressed air for a controlled temperature and pressure environment during all phases of flight and ground operation.
增压系统的作用是为飞行及地面所有阶段的温度和压力控制提供压缩空气。
The compressed air system for atmospheric air, will air inhaled air compressor, after volume compressed pump into the compressed air system.
压缩空气系统的气源为大气,将空气吸入空压机中,经过体积压缩后泵入压缩空气系统。
A constriction in a powder pump that USES compressed air to lift and transport powder from feed system to the spray gun.
在粉末泵中的收缩能够使压缩空气从喂料系统到喷粉枪提升和搬运粉末。
The compressed air system is intended to provide a stable powder coating system, pollution-free high pressure air.
压缩空气系统的目的在于为粉末涂装系统提供稳定、无污染的高压空气。
应用推荐