Start the listener at the target for the receiver end of the channel from the source by issuing this command.
通过发出这条命令，为从源开始的通道的接收器端启动目标系统的侦听器。
Define a receiver channel at the target queue manager from the source queue manager by entering this command.
通过输入这条命令，在目标队列管理器定义来自源队列管理器的接收端通道。
Define a receiver channel at the source queue manager from the target queue manager by entering this command.
通过输入这条命令，在源队列管理器定义来自目标队列管理器的接收端通道。
On the MQSC command line, enter the following command to define the receiver channel.
在MQSC命令行输入以下命令，以定义接收方通道。
Figure 7. Command-line output of receiver application.
图7.receiver应用程序的命令行输出。
Command-line output of receiver application.
receiver应用程序的命令行输出。
I am learning command design pattern. As far as I know, four terms always associated with the command pattern are command, receiver, invoker and client.
我在学习命令设计模式。据我所知，总是与命令模式相关的四项命令，接收，调用和客户端。
So a command can be reused by many invokers to execute the same action on the receiver.
所以一个命令可以重复使用许多调用接收器上执行相同的动作。
The goal of the command pattern is to decouple the invoker from the receiver.
的目标命令模式是调用从接收者解耦。
As far as I know, four terms always associated with the command pattern are command, receiver, invoker and client.
据我所知，总是与命令模式相关的四项命令，接收，调用和客户端。
When the receiver returns a response, the sequence number of the response and the sequence number of the corresponding command must be the same.
接收方在返回应答时，应答的序列号必须和相对应的命令的序列号相同。
The Invoker makes a request by calling execute() and the Concrete Command carries it out by calling one or more actions on the Receiver.
发送者调用一个操作，接受者接受请求执行相应的动作，发送者无需知道接受者任何接口。
The Invoker makes a request by calling execute() and the Concrete Command carries it out by calling one or more actions on the Receiver.
发送者调用一个操作，接受者接受请求执行相应的动作，发送者无需知道接受者任何接口。
应用推荐