The collector voltage of the switching transistor is determined by the voltage of the power network.
晶体开关管的集电极与发射极间的电压取决于电网电压。
Using Fourier analysis to calculate the maximum collector voltage of PAs in inverse Class-AB mode, we can calculate the maximum efficiency.
通过对输出波形傅里叶函数的研究可以得到最大输出电压摆幅以及计算最大功率。
Electrospinning works by connecting a needle-like spinneret to a high-voltage power source and releasing a charged liquid from it towards an earthed collector plate.
电纺的工作方式是将一根针状喷丝头连上高压电源并从中对一个接地的收集器释放出一股带电液体。
The waveforms of the collector current and collector-emitter voltage are also determined under the optimum operation condition.
在最佳工作条件下，给出了集电极电流和集电极——发射极电压波形。
The best design method of high voltage and low saturation voltage GTR presented in this paper shows that the collector region through design is better than non-through design.
本文提出了高压低饱和压降gtr的最佳设计方法。分析表明，高压低饱和压降晶体管采用集电区穿通性设计比非穿通性设计有利。
Features: High voltage, small collector output capacitance.
特点：耐压高，集电极输出电容小。
The base current and the junction leakage current increase, while the collector current and the breakdown voltage decrease for SiGe HBTs after radiation.
辐照后基极电流、结漏电流增大，集电极电流、击穿电压减小。
Features: Low collector-emitter saturation voltage, fast switching speed.
特点：饱和压降低，开关速度快。
Features: High voltage low saturation, low collector output capacitance, complementary pair with MPSA92 (3cg92).
特点：耐压高，饱和压降低，集电极输出电容低，与MPSA92 (3cg92)互补。
Features: Low saturation voltage, large collector current.
特点：低饱和，大电流。
Features: High voltage, low saturation voltage, low collector capacitance output, complementary pair with MMBTA92 (3cg92m).
特点：耐压高，饱和压降低，集电极输出电容低，与MMBTA92 (3cg92m)互补。
The low voltage reactive compensation collector-distributor control system in ferromanganese-silicon furnace is developed.
论述了锰硅电炉无功补偿方式的优缺点，开发了锰硅电炉低压无功补偿集散控制系统。
If another voltage or current source is present, you could replace S1 with an open-collector switch that sinks current only.
如果另外有个电压或电流源存在，用仅有减小电流作用的集电极开路开关代替s1。
In this design, the collector-to-emitter voltage is sensed to determine the directions of the output currents for the 4-step commutation strategy.
该文检测器件集射极电压确定输出电流方向，并据此实现四步换流。
In this design, the collector-to-emitter voltage is sensed to determine the directions of the output currents for the 4-step commutation strategy.
该文检测器件集射极电压确定输出电流方向，并据此实现四步换流。
应用推荐