It is also found that the most important factors that influence the frost growth are the temperature of cold plate and relative humidity of air.
实验还发现,对霜层生长初期影响最大的两个因素是冷表面的温度和空气的相对湿度。
Experimental study shows that the heat pipe cold plate equipment possesses excellent heat transfer performance and temperature evenness, and satisfies design requirements.
试验结果表明,所提出的热管冷板传热性能和壁面均温性能良好,满足设计要求。
The control functions and features of the cold plate leveler in baosteel heavy plate mill are introduced.
主要介绍了冷矫直机的控制方式和控制特性,并对其中重要的控制功能进行了详述。
At the same time, the average heat exchange coefficient and the pressure loss of the cold plate have been tested.
同时对冷板的散热性能进行了测试,得到了冷板的平均换热系数和压力损失。
Studying how to improve the thickness control precision of cold plate is a hotspot-forefront topic in the rolling field.
如何提高在复杂工况下的冷带板厚控制精度是当今该领域的前沿热点问题。
The cold plate cooling system with an external finned heat sink for the drive system in ring spinning frames is described.
描述了最近开发的用于环锭细纱机传动系统的一套带有外部散热器的冷却盘冷却系统。
To deal with multi-heat-source and high-heat-flux heat transfer problem of array antennas, a heat pipe cold plate equipment is developed.
为了有效解决阵列行波管的多热源、高热流散热问题,研制了基于其安装空间尺寸的热管冷板散热装置。
The numerical solution shows that temperature distribution rule on every cross-section of cold plate agree with conclusions of theory analysis.
数值计算结果表明,均热板底板各截面的温度分布规律符合理论分析的结论。
The article introduces a modified automatic hooking device for cold plate mills with which the hooking operation can be preformed on the ground.
介绍一种可在地面上操作即可摘钩的冷轧机支承辊换辊自动撞钩装置。
Because of the influences of such factors as machining tolerance etc., the contact thermal resistance between chip and cold plate can't be controlled effectively.
由于表贴器件制造公差的影响,器件与冷板间的接触热阻无法有效控制。
The experimental results demonstrate that this coating could restrain the frost growth in the condition of lower relative humidity and higher cold plate temperature.
结果表明在环境相对湿度较小、冷壁温度不太低的条件下,这种涂层能够较好地抑制霜层的生长。
The article describes the automatic gauge control, cause of thickness deviation, setup of control models and thickness control and adjustment of the single stand cold plate mills.
介绍单机架冷轧机厚度控制系统、产生厚差的原因、控制模型的建立及厚度的控制和调节。
This paper introduces the design method that USES cold plate technique to cooling of hermetically sealed transmitter. It gives the calculation process of the design method deduced from theory.
介绍了一种运用冷板散热技术对全密封发射机进行散热的设计方法,并从理论分析上给出了这种设计方法的计算过程。
The cooling problem of solid state active phased array radar is discussed in this paper. And the type of a high efficient cold plate with plate fin that is suitable for T /R module is introduced .
对固态有源相控阵雷达的冷却问题进行了探讨,并且介绍了一种适合于T/R组件用的高效率板翅式冷板。
This paper introduces the processing technology of microchannel cold-plate briefly.
对微通道冷板的制造工艺技术作了简要阐述。
This paper introduces the processing technology of microchannel cold-plate briefly.
对微通道冷板的制造工艺技术作了简要阐述。
应用推荐