In the structure of a resin coating section such as the motor drive circuit, the amount of resin placed is significantly reduced and the entire compressor is reduced in weight and cost.
能提供一种逆变器一体型的电动压缩机，对于电动机驱动电路等树脂覆盖部的构造而言，能大幅度减少填充树脂量，实现压缩机整体的轻量化、成本下降。
The surface preparation as described in Section 4 shall apply if the additional layer is applied outside the manufacturer's recommended maximum over coating period.
如果额外涂层的涂敷时间超出厂商推荐的最大涂敷期限的话，应进行第4部分提到的表面预处理。
The oxidation kinetics curve was drawn. The surface morphology and cross section micrograph of the Al-Si coating were studied by using SEM.
绘制了氧化动力学曲线，用带能谱分析的扫描电镜观察了涂层的表面氧化形貌和横截面组织形貌。
The surface and cross-section of the pock flaws which appeared on the hot-dip galvanized coating were observed and analyzed by using SEM and energy spectroscopy.
通过扫描电子显微镜对热镀锌钢板镀层表面麻点缺陷的表面和断面形貌进行了观察，并对其进行了能谱分析。
Mistakes in the original design of the pretreating process section of the color coating line caused certain quality defects on the product.
彩板生产线预处理工艺段原设计缺陷造成彩板质量问题。
While under the same test conditions, samples without coating have undergone severe damages on both the surface and the fracture section.
而在同等条件下未涂层试样不论是表面还是断口处都已遭受了较为严重的破坏。
The zinc coating at the outside of the bent or formed section is visible at 25 power magnification.
或成型区在25 倍放大时可看见镀锌层片状材料脱落或裂化，认为锌镀层已损坏。
Radar Cross Section (RCS) is efficiently controlled by coating material (RAM) for metal objects.
金属目标表面涂覆吸波材料可以有效地抑制雷达散射截面(RCS)。
The electrodepositing composite copper coating with liquid microcapsule had been confirmed by surface and section micrograph and composition analysis.
通过对这种镀层的表面、断面形貌和表面成分分析，这种含有液体微胶囊的复合镀铜层得到了证实和确认。
Pore distribution was investigated by observing surface morphology and cross-section. Accumulating model of steel balls was used to simulate the pore distribution in the coating.
通过观察机械镀锌镀层的表面形貌和断口结构，分析了镀层中的孔隙分布，并用钢球堆积模型模拟了镀层中孔隙的分布情况。
Pore distribution was investigated by observing surface morphology and cross-section. Accumulating model of steel balls was used to simulate the pore distribution in the coating.
通过观察机械镀锌镀层的表面形貌和断口结构，分析了镀层中的孔隙分布，并用钢球堆积模型模拟了镀层中孔隙的分布情况。
应用推荐