In the low cyanide solution content is too high, the current efficiency drops, and even has cavernous coating.
在低氰镀液中含量太高则电流效率下降，甚至其成海绵状镀层。
Coating antimony content is measured by atomic absorption spectrometry, which is accurate and easy to operate.
镀层中锑含量采用原子吸收光谱法测定，具有准确和方便的优点。
However, the content of the each constituent varies obviously with coating depth owing to changes of composition and crystal parameters.
然而，由于受微区成分和结晶参数变化的影响，涂层中各组成相的含量随层深发生了明显变化。
In some cases, if the salt solution of the metal ion content for simple ion, the coating, therefore, coarse grains to adopt complexation ion of plating solution.
有些情况下﹐若镀液中主盐的金属离子为简单离子时﹐则镀层晶粒粗大﹐因此﹐要采用络合离子的镀液。
Experimental results indicate that the rosin content in the coating and film thickness are the main factors influencing the nutrient release rate of the encapsulated urea.
实验结果表明：涂层中松香的含量及包膜量(膜厚)是影响包膜尿素养份释放速率的主要因素。
If the room USES bright-coloured coating to brush, get multicoloured, the phyletic more of heavy metal, content taller, pollution is more serious also.
假如房间用鲜艳的涂料刷得五颜六色，重金属的种类更多、含量更高、污染也更严重。
However, the water vapor content has only effect on the mass gain of the microcrystalline coating.
对于溅射微晶涂层，水蒸气的含量只影响氧化增重。
The influences of coating condition and the content of pore-forming agent on the porous structure and the vapor permeation were studied.
研究了湿法涂层技术制备聚氨酯多孔膜的工艺条件以及致孔剂含量对多孔膜微孔结构和透湿性能的影响。
It has been discussed that the content and the granularity of SiC absorbent, the thickness of coat influenced the property of. Absorb-wave of the resistance high temperature stealth coating.
探讨了碳化硅吸收剂粒度、含量和涂层厚度对耐高温毫米波隐身涂料的吸波性能影响。
The experimental results showed that the smaller the powder size and higher the chromium content were, the higher corrosion resistance the coating could be.
实验结果表明，随着小粒径锌粉的增多，涂层减薄，铬含量提高，耐蚀性增强。
This paper introduces the analysis method of silver-antimony alloy coating and antimony content.
介绍了银-锑合金镀层和镀液中锑含量的分析方法。
The plating baths with different orthophosphate content were analysed, and the corresponding coating characteristic was tested.
对正磷酸根含量不同的镀液进行了分析，并测试了相应镀层的性能。
An automatic detection system for measuring the surface temperature of solar heat-reflecting coating and the liquid content temperature in the tank covered with the coating.
介绍了用于测量反射太阳热涂层表面温度和涂有反射太阳热涂层贮罐内装液体温度的自动检测系统。
In the electric arc spray coating the oxide content was about 10%.
而且电弧喷涂涂层中具有约10%左右的氧化物含量。
Spectrophotometry was applied to determine coating agent content in porous prilled ammonium nitrate.
多孔硝铵涂层剂含量的测定是生产过程检验的一项重要内容。
Spectrophotometry was applied to determine coating agent content in porous prilled ammonium nitrate.
采用分光光度法对多孔硝酸铵产品中包裹剂含量进行了测量。
The results show that Ni co Mn coating layer has higher comprehensive performance and much lower cobalt content than Ni co and Ni Mn layers.
结果指出，镍钴锰三元合金镀层具有比镍钴或镍锰镀层更高的综合机械性能和低得多的钴含量，更适合于制造电镀金刚石钻头。
The measures to prevent nitrogen blow hole caused by high nitrogen content of resin sand are: adopting low nitrogen resin, adding iron oxide into sand or coating and keeping resin from moisture.
防止树脂砂含氮量高引起的氮气孔的方法是：选用低氮树脂、型砂或涂料中加入氧化铁粉和避免树脂受潮。
The main products are usually used to nap the high solid content, high viscosity elastic coating.
通常用来拉毛的产品主要是高固含量、高粘度的弹性涂料。
The coated glasses were analyzed with U-4100 spectrophotometer. The effect of paint proportion, coating thickness and solid content of suspensions on optical performance were discussed in this paper.
用U-4100紫外、可见、近红外分光光度计对其进行光热性能表征，讨论了隔热涂料的配比，涂膜厚度和浆料固含量对光学参数的影响。
The ceria content of the nanocomposite coating is more than that of the micron composite coating.
纳米复合涂层中氧化铈的含量高于微米复合涂层中的氧化铈含量；
METHODS The orthogonal design method was used to optimize coating material, coating weight, content of the porositymaking agent.
方法：采用正交设计以体外溶出为指标，对包衣材料种类、包衣剂用量、致孔剂用量进行处方筛选。
The results of linear SEM-EDS indicated that the content of iron in the red pottery coating was remarkably higher than that in the inner adobe of pottery.
电子探针线扫描分析的结果表明，红色陶衣中铁的含量明显高于内部坯体。
The effect of SiO_2 nanoparticle content and reaction method on coating film hardness, adhesion, resistance to impact, thermal stability was studied.
研究了纳米粒子的加入量和加入方式对涂料硬度、附着力、抗冲击能力、耐候性、热稳定性能的影响。
The influence factors such as the hydrogen content in weld metal, the hydroscopicity in electrode coating and the toughness of weld metal of basic electrodes are studied.
研究了碱性焊条工艺性的影响因素，探讨了焊缝金属的含氢量、焊条药皮的吸湿性、焊缝金属的强韧化特性等。
The viscosity and yield of the coating increase with increased xanthan gum content.
且随黄原胶加入量的增加，涂料粘度和屈服值增加。
Effect of sulfur content in nickel coating on foamed nickel performances and effect of electroplating parameters on sulfur content in the nickel coating in foamed nickel production were studied.
研究了泡沫镍生产中镀层硫含量对泡沫镍性能的影响以及电镀工艺参数对镀层硫含量的影响。
Effect of sulfur content in nickel coating on foamed nickel performances and effect of electroplating parameters on sulfur content in the nickel coating in foamed nickel production were studied.
研究了泡沫镍生产中镀层硫含量对泡沫镍性能的影响以及电镀工艺参数对镀层硫含量的影响。
应用推荐