Opening and closing of the contact points creates induced voltage.
触接点的开启与闭合产生感应电压。
The driving voltage is the major factor for shortening the closing time.
发现影响电磁阀关闭速度的主要因素是驱动电压的大小；
At rated control supply voltage less than 35% under-voltage should prevent breaker from closing.
在额定控制电源电压低于35%时，欠电压脱扣器应防止断路器合闸。
The voltage characteristics upon closing the convertible top result in a mirror image!
关闭活顶时的电压特性将导致镜像！
In case of the operation voltage less than 35% of the rated voltage, the under-voltage should prevent the breaker from closing.
在额定控制电源电压低于35%时，欠电压脱扣器应防止断路器合闸。
These factors including distribution of circuit breakers closing Angle, rated voltage of MOA and the insulation level of transmission line are considered.
同时还研究了断路器合闸相位角分布规律、MOA的额定电压、线路绝缘水平等因素的影响。
The calculation of loaded closing striking current of capacity and opening filter capacity bank voltage is illustrated by a few examples.
本文介绍电容器负载合闸冲击电流和分闸滤波电容器组电压的计算，并通过实例加以说明。
With the much higher operating voltages now in use the projected voltage transients or surges due to switching i. e. the opening and closing of circuit breakers, have become the major consideration.
目前随着更高工作电压的使用，由于断路器分闸、合闸操作所引起的电压暂态过程或过电压．已成为主要考虑的方面。
The experimental results show that the operation is stable and may be used to complete the synchronized-closing of capacitor banks in order to limit the transient over-voltage and inrush current.
结果表明，相控真空断路器动作分散性小，可以有效地完成电容器组的同步关合，大幅度降低系统暂态过电压、减小涌流。
Analyzing and evaluating to the effect caused by loop closing operations in radial medium voltage distribution networks are extraordinary important to the safe operations.
分析和评估合环操作对辐射型中压配电网所造成的影响对配电网的调度和安全运行有着重要的意义。
The equipment ensures automatic closing at current zero, preset test voltage automatically and the effect is fine.
设备自动保证过电流零点合闸，自动预置试验电压，试验效果好。
The contact voltage-drop of counterpart contacts in the closing course of electromagnetism relay is observed and recorded in its failure test using dynamic contact resistance measurement system.
用动态接触电阻测量系统进行了电磁继电器失效检测试验，检测了其触点闭合过程的接触压降。
Synchronous closing is an intelligent control technique. It can make the moving and stationery contact-header of circuit breaker to close on the specified phase angle of the power system voltage wave.
同步关合是指断路器动、静触头在系统电压波形的指定相角处关合，以减小合闸操作的过电流和过电压的一种智能操作技术。
Synchronous closing is an intelligent control technique. It can make the moving and stationery contact-header of circuit breaker to close on the specified phase angle of the power system voltage wave.
同步关合是指断路器动、静触头在系统电压波形的指定相角处关合，以减小合闸操作的过电流和过电压的一种智能操作技术。
应用推荐