At last, experiment of open loop and closed loop system are completed, which is in accord with the simulation result. It verified feasibility and advantage of the control scheme.
最后完成了系统的开环和闭环实验，取得了和仿真一致的结果，从而验证了控制方案的可行性和优越性。
It is a closed loop interdependent system.
这是一个相互依存的闭环系统。
After building closed-loop model, we can analyze and evaluate the performances of IFOG in theory, and improve it, which provide evidences for designing system and choosing optical components.
闭环模型建立后，能从理论上分析、评价、改善IFOG性能，为系统设计和选择光学器件提供了依据。
For digitized AC servo system, it needs software to support it's closed-loop control. Its control quality is decided by the program of control computation directly.
数字化的交流伺服系统是靠软件完成控制计算来支持闭环控制的，它的控制计算程序直接决定了系统的控制质量。
By introducing nonlinear damping term, it is proved that all signals in the closed-loop system are globally stable, and the tracking error and the parameter (estimation) error converge to zero.
通过引入非线性阻尼项，保证了闭环系统的所有信号都是全局稳定的，而且跟踪误差及参数估计误差均收敛于零。
It is shown that the stability of the closed-loop system is guaranteed by analysis.
分析表明滑模控制器保证了闭环系统的稳定性。
The controller is robust to the uncertainties of both the parameter and the state of the systems. It can also guarantee the global stability of the closed-loop system.
该控制器对系统的参数和状态的不确定性具有鲁棒性，并且能保证系统闭环全局稳定。
It is proved that the proposed method can not only guarantee the stability of the closed-loop system, but also make the tracking error converge to the origin or its small neighborhood.
该方法不但能保证闭环系统稳定，而且可使跟踪误差收敛于原点或原点的一个小邻域内。
Moreover, this algorithm is carries on under the closed-loop system, it can examine the component signal deviation that controls the object to reduce or correct output error.
另外，该算法是在闭环系统下进行的，它能够检测出信号的偏差，利用偏差信号对受控对象进行控制，以减小或纠正输出量的偏差。
But the good performances of PMSM drive system are based on closed-loop control, it is quite important of how to obtain the rotor position and speed signals in this system.
但是永磁同步电机驱动系统的良好性能都是建立在闭环控制基础之上的，因此如何获取转子位置和速度信号是整个系统中相当重要的一个环节。
It was discussed the check principle structure, the codes' transmitting, closed loop check, reliability of the closed loop Telegraphic codes System with some reference circuit.
对闭环电码化系统检测原理结构、发码过程，闭环检测、可靠性等进行分析阐述，并给出部分参考电路。
It is proved that globally asymptotical stability and convergence of the resulting closed-loop system are guaranteed by the range of the prediction horizon.
从理论上证明了它可保证闭环系统的全局渐近稳定和收敛，并定量给出了预测水平的选择范围。
Because the delayed effects exist in any closed - loop control system, it is more important and significant to study the stability of the control system with delay.
由于任何闭环控制系统都存在滞后效应，所以研究滞后型控制系统的绝对稳定性意义尤为重要。
It is shown that the closed-loop system is globally stable and the tracking er-ror is bounded subject to quite general assumptions.
在相当一般的假设下，证明了所建立的闭环系统是全局稳定的和跟踪误差是有界的。
By the limit probability theory, it is shown that the closed-loop system is almost surely uniformly stable, and the control law is asymptotically optimal.
利用概率极限理论，证明了闭环系统的几乎必然一致稳定性和控制律的渐近最优性。
By using a finite time stability theorem, it is proved that the closed loop system is globally finite time stable.
根据有限时间稳定性定理证明此时闭环系统是全局有限时间稳定的。
This paper introduces the 16-bit MC9S12H256 MCU and describes the design of closed loop asynchronous motor frequency converter control system using it in details.
文章介绍了目前国内应用较少的16位单片机MC9S12H256，并详细阐述了使用该型号单片机实现闭环变频调速系统的设计方案。
It is proved that the closed loop system satisfies the anticipated performance.
证明了闭环系统满足期望的性能。
Finally it is proved that the closed-loop transmission scheme can improve the receiving the energy and the interference ratio and increase the forward-link capacity of the system.
最后证明了采用闭环发送分集方案，可以大大改善接收能干比，提高系统的前向容量。
There are three modes of operation in this system and it functions a 2-level computer controlled closed loop system in combination with LD process computer SCC.
该系统具有三种工作方式，能与车间过程机s CC构成二级计算机闭环控制系统。
This measure system is suitable to measure linear and Angle displacement during manufacturing process of NC machine tool, and it can constitute closed loop control system with CNC system.
该测量系统适用于测量数控机床加工过程中的直线位移和角位移，可以和CNC系统组成闭环控制系统。
The laser signal combined with a closed - loop control system can be used in automatic level flatting of the ground. It is a dynamic application of laser beacon.
自准水平激光仪的激光信号与闭环控制系统的结合，实现地面的水平平整，它是自准水平激光仪的一种动态应用。
It creates the premise for intelligent shift control which based on human-vehicle-road closed-loop system.
为实现基于人-车-路闭环系统的智能换档控制创造前提。
It improves on the MSP's registration control with a closed loop system which takes readings at each print station for rapid re-adjustment of registration, greatly reducing waste.
它提高了中型的注册控制的闭环系统，在每个需要重新印刷的快速站登记的调整读数，大大减少了浪费。
The part of timing is a double closed loop DC timing system, and it is composed of rev loop (internal loop) and current loop (external), which are series-wound.
调速部分为双闭环直流调速系统，由转速环(内环)和电流环(外环)串联组成。
It includes the function of the control system, the fundamental theory of microcomputer control of a filament winding machine, the construction of open-loop and closed-loop systems and conclusions.
计算机控制纤维缠绕的基本原理；开环系统和闭环系统的组成以及研究的结论。
It includes the function of the control system, the fundamental theory of microcomputer control of a filament winding machine, the construction of open-loop and closed-loop systems and conclusions.
计算机控制纤维缠绕的基本原理；开环系统和闭环系统的组成以及研究的结论。
应用推荐