Based on the mathematic model of separately excited DC motor, the control structure of the single - feedback-closed-loop controlled DC velocity modulation system was obtained.
在他励直流电机的数学模型的基础上，得到了单反馈闭环控制的直流调速系统的结构。
A closed loop controlled ignition system with the use of an optical fiber dynamic combustion pressure sensor is presented in this paper.
介绍了一种应用光导纤维动态燃烧压力传感器的点火闭环控制系统。
The mechanical throttle valve is electrically controlled, e. g. the valve position is under closed-loop control to the output of the pressure gauge.
所述机械节流阀受到电控制，例如阀门位置受到根据所述压力表的输出进行的闭环控制。
Based on the estimation of a controlled plant's transfer function model, a method for the self-tuning of PID controllers in closed-loop system is proposed.
基于对被控对象传递函数的估计，提出一种闭环pid参数整定方法。
The rotation speeds of rotor and whirling bcam are controlled accurately with a method of closed loop.
旋翼和旋转大臂转速采用闭环精确控制。
Utilizing the information observed, a new type of slip frequency controlled torque-speed double closed loop system is developed.
基于观测出的状态信息，构成了转差频率控制的转矩速度双闭环新型变频调速系统。
This paper studies a DC double closed loop digital PWM speed adjusting system controlled by 8098 single chip computer to explore the feasibility for the middle or small power motors.
对8098单片机控制的全数字直流双闭环pwm调速系统进行了研究，探讨了该系统在中小型功率直流电机上应有的可行性。
This paper deals with a closed-loop digital control for a hydraulic valve, controlled motor speed system.
研究了用位总线微机构成的液压阀控马达速度闭环数字控制系统。
The oxygen sensor on electrically controlled engine application, has realized the electrically controlled unit to the engine closed-loop control.
氧传感器在电控发动机上的应用，实现了电控单元对发动机的闭环控制。
The water-curtain controlled cooling process after rolling steel plate in Shougang Group is analyzed, then a double closed-loop fuzzy control scheme for flow ratio is proposed.
分析了首钢中厚板轧后处理中的水幕控冷工艺过程，提出了一种双闭环流量比值模糊控制系统方案。
It is difficult to design the closed loop gain shaping controller when the controlled plant is not a square matrix, because it is involved in the pseudo inverse of matrix.
在被控对象为非方阵的系统中，由于求解控制器时涉及到矩阵求伪逆问题，很大程度上增加了闭环增益成形算法的难度。
Each module is controlled by voltage current two closed loops. The common voltage loop controls system output voltage & frequency, and generates a common reference current signal.
三台航空静止变流器模块均为电压、电流双环控制，通过公用电压调节器稳定并联系统的输出电压及频率，同时产生统一的模块电流给定信号。
The theorem has been verified to be very useful in estimating the all parameters of controlled plant in a closed loop via least squares method.
已经证实本定理对解决处于闭环中全部参数同时进行最小二乘估计十分有用。
Each module is controlled by voltage-current two closed-loops. The common voltage loop controls system output voltage & frequency, and generates a common reference current signal.
每台航空静止变流器模块均为电压、电流双环控制，通过公用电压调节器稳定并联系统的输出电压及频率，同时产生统一的模块电流给定信号。
The injection quantity and the injection timing are controlled on the basis of the MAP, and the rail pressure is mainly controlled by using PID of closed loop.
喷油量和喷油定时通过查MAP图计算来实现，共轨压力则主要采用闭环PID控制。
Simulation results indicate that the clutch engaging speed can be accurately controlled by using DC servo motor dual closed loop control system. The start quality of Vehicle was improved.
结果表明：直流伺服电机驱动离合器，能很好地控制离合器的结合速度，提高车辆起步品质。
The Brushless DC Motor, important part of the system is well controlled including two-closed-loop control method, compensation for dead-time and analysis of fluctuation about swapping phases.
同时针对系统中的关键部分无刷直流电机采取了全面优良的控制策略，包括转速外环电流内环双闭环调速控制，死区补偿，换相脉动分析等。
A microcomputer controlled IGBT inverter power source for pulsed MIG welding is developed. It realizes the self adaptive control and closed loop control of arc voltage in pulsed MIG welding process.
建立了微机控制和IGBT逆变式脉冲MIG焊电源系统，实现了MIG焊接过程弧压自适应闭环控制。
The inverter uses full bridge topology and SPWM technique. The inverter voltage is controlled by single closed loop feedback based on PID.
逆变器采用全桥型的拓扑结构，利用了SPWM逆变技术，逆变电压控制通过简单的单环反馈实现，控制方法采用PID算法。
The welding current is controlled in a closed loop to ensure that the current value will be the same at each time.
焊接电流采取闭环控制，所以能保证每次焊接电流都一致。
There are three modes of operation in this system and it functions a 2-level computer controlled closed loop system in combination with LD process computer SCC.
该系统具有三种工作方式，能与车间过程机s CC构成二级计算机闭环控制系统。
Also this closed loop controlled system is modelled and its dynamic behaviors are analyzed by digital simulation. The influence of controller parameters on motion of the rotor and th...
本文还建立了此闭环控制系统的数学模型，通过数字仿真分析了其动态特性，探讨了控制器参数对转子运动的控制效果以及与电磁轴承动刚度之间的变化关系。
Also this closed loop controlled system is modelled and its dynamic behaviors are analyzed by digital simulation. The influence of controller parameters on motion of the rotor and th...
本文还建立了此闭环控制系统的数学模型，通过数字仿真分析了其动态特性，探讨了控制器参数对转子运动的控制效果以及与电磁轴承动刚度之间的变化关系。
应用推荐