You can, indeed have a true class a amplifier that operates in push-pull mode.
您可以，确实有一个真正的A级放大器，工作在推挽模式。
For audio amplification, a class a amplifier can be either single-ended or push-pull.
对于音频放大，一个A类放大器可单端或推挽。
The true class a amplifier will have no crossover distortion, while the class AB amplifier will.
真正的A级放大器，也没有交越失真，而AB类放大器将。
Also, the efficiency will be greater than is theoretically possible with a class a amplifier at these levels.
此外，效率将大于理论上是可能的A类放大器在这些级别。
Second, a push-pull class A amplifier output stage will have inherent rejection of power supply ripple and noise.
第二，推挽A级放大器输出阶段将拥有固有拒绝电源纹波和噪声。
As one side reaches saturation, the other side reaches cutoff, just as they would in a single-ended class a amplifier.
作为一方达到饱和，另一方达到临界，就像他们将在一个单端A类放大器。
This will lead to "sag" in the power supply that doesn't exist in the true class a amplifier, which again results in a tonal change.
这将导致“凹陷”的电源供应，不存在真正的A类放大器，而这又产生一个音调的变化。
This thin-style high-power amplifier with versatile charm featured the definitive high-efficiency class A amplifier, the HCA circuit.
这款是全能高效率的A类放大，薄型高功率功放。
The current in a true class a amplifier is constant, so it doesn't exhibit this bias shift, unless driven to clipping, where all bets are off.
目前在一个真正的A级放大器不断，因此它不具有这种偏见的转变，除非驱动剪报，所有的赌注都赶走。
A current-driven common source amplifier which is biased on class AB constitute the output stage.
由偏置在AB类的电流驱动的共源放大器构成输出级；
The new algorithm is applied to the simulation of a class C amplifier, current waveforms at drain and source show good agreement with those obtained by MEDICI transient analysis.
采用该算法仿真典型的C类功率放大器得到电流波形和工业界公认标准器件仿真器MEDICI瞬态模拟得到电流波形比较，显示出很好的一致性。
Driver deadtime control is a popular scheme used to prevent the occurrence of the shoot-through issue in a Class-D APA (audio power amplifier).
在D类音频功率放大器中，驱动死区时间控制是一个很流行的术语。
什么是B类放大器？
Technically speaking, you can have a a class AB single-ended amplifier, which was biased away from the linear portion of the curves, but that amplifier would hopefully!
从技术上讲，你可以机管局A B类单端放大器，这是有偏见的距离线性部分的曲线，但放大器将希望！
Class E amplifier is a new kind of high-efficiency power amplifier.
类功率放大器是一种新型高效率放大器。
In order to analyze the nonlinear characteristic presented in the subharmonic load pull experiment theoretically, a class a MESFET power amplifier is researched on in this paper.
为了从理论上解释副谐波负载牵引实验中的各种非线性现象，对一个A类MESFET功放进行了研究。
The controller combines parallel amplification and drain modulation of the CMOS class-E power amplifier to provide high efficiency over a broad range of output powers.
结合射频E类功率放大器的结构特点，采用CMOS工艺，达到了在大的输出功率范围内保持持续稳定高效率的目的。
As long as the manufacturer isn't rating the amplifier for its output power in this clipped state, the amplifier would normally be called class a, single-ended.
只要制造商不是评价的放大器，其输出功率在此截断的国家，放大器通常被称为A级，单端。
In order to improve both charge current and transfer efficiency via a lower coupling coefficient inductive link, class E power amplifier based on primary leakage inductance and compensat.
在低耦合系数条件下 ，通过基于初级漏感的E类功率放大器和次级漏感的补偿方法 ，提高电容充电电流和传输效率。
Ten years ago, I planned to build a class A power amplifier, but I shelved it due to my limit in knowledge and ability then.
早在十几年前，我就计划做一台单端A类的放大器，但这个计划一直没有实现，直接的原因就是技术不充分。
Now, you might be thinking, how can a push-pull amplifier be class A?
现在，你可能会想，怎么能推挽放大器是A类？
This occurs because the plate current in a class AB amplifier is not continuous for the entire AC cycle.
这是因为该板块目前在AB类放大器是不连续的整个交流周期。
Based on the conventional Class-E resonant high-frequency power amplifier, a new control scheme used in Active-clamped Class-E inverter for ultra-high frequency induction heating is proposed.
以传统的E类高频功率放大电路为基础，提出了应用于高频感应加热电源的有源箝位E类逆变电源的一种新型控制方法。
It is still a class AB amplifier, no matter what you choose to call it.
它仍然是一个AB类放大器，无论您选择调用它。
This paper introduces design of the circuit which uses a class-D amplifier to converse and enlarge the audio signal.
介绍了采用D类放大器来完成音频信号变换与放大的电路设计。
Combining the secondary circuit, we have proposed the design methodology of transcutaneous power transmission system with a class-E amplifier.
结合次级电路，提出了基于E类放大器的经皮能量传输系统的参数设计方法。
The class E power amplifier hasn't widely used because of a variety of problems, one of which is the difficulty of adjustment.
高效率E类放大器的提出是功率电子学研究方向的重大突破，但它由于受到各种因素的限制，还未能得到广泛应用。
There is a very real difference in tone and operating conditions between a true class A 10W amplifier running at say, 1W, and a 10W class AB amplifier running at 1W.
有一个非常现实的差异，语气和操作条件之间的一个真正的A级10W的放大器运行也就是说，1W的，和一个10W的AB类放大器在1W的运行。
Integrated circuit of a class-D audio power amplifier with very high efficiency using CMOS technology is presented in this paper.
分析了高频开关电源的特点及将其应用到音频功率放大器中所遇到的主要问题，以及解决这些问题的基本方法。
Integrated circuit of a class-D audio power amplifier with very high efficiency using CMOS technology is presented in this paper.
分析了高频开关电源的特点及将其应用到音频功率放大器中所遇到的主要问题，以及解决这些问题的基本方法。
应用推荐