This thesis does research on the key module of Q-switch driver—high efficiency Class-E power amplifier, including the design and implement of the prototype.
本文主要研究了声光Q开关驱动器的关键模块——高效率E类功率放大器，设计实现了工程样机。
The controller combines parallel amplification and drain modulation of the CMOS class-E power amplifier to provide high efficiency over a broad range of output powers.
结合射频E类功率放大器的结构特点，采用CMOS工艺，达到了在大的输出功率范围内保持持续稳定高效率的目的。
Class E amplifier is a new kind of high-efficiency power amplifier.
类功率放大器是一种新型高效率放大器。
Combining the secondary circuit, we have proposed the design methodology of transcutaneous power transmission system with a class-E amplifier.
结合次级电路，提出了基于E类放大器的经皮能量传输系统的参数设计方法。
According to the design equations of class-E amplifier, we have analyzed the relationships between the output power and the input voltage.
根据E类放大器的设计方程，分析了E类放大器输出功率与输入电压的特性。
The class E power amplifier hasn't widely used because of a variety of problems, one of which is the difficulty of adjustment.
高效率E类放大器的提出是功率电子学研究方向的重大突破，但它由于受到各种因素的限制，还未能得到广泛应用。
Based on the conventional Class-E resonant high-frequency power amplifier, a new control scheme used in Active-clamped Class-E inverter for ultra-high frequency induction heating is proposed.
以传统的E类高频功率放大电路为基础，提出了应用于高频感应加热电源的有源箝位E类逆变电源的一种新型控制方法。
Based on the conventional Class-E resonant high-frequency power amplifier, a new control scheme used in Active-clamped Class-E inverter for ultra-high frequency induction heating is proposed.
以传统的E类高频功率放大电路为基础，提出了应用于高频感应加热电源的有源箝位E类逆变电源的一种新型控制方法。
应用推荐