Control of the hardware design part of the main controller, sensors and motor control circuits.
控制部分的硬件设计主要有控制器，传感器和电机控制电路。
To drive motion components, the thesis examines the controlling principle of DC motor and the methods and circuits of using the DSP chip and DC motor control modules to realize the DC motor control.
为驱动运动部件，本文研究了直流电机控制原理以及利用DSP芯片结合直流电机控制模块实现直流电机控制的方法和电路。
Finally, designs brushless DC motor control system hardware circuits based on TI's DSP chip TMS320F2812 and ir's IR2133, and compose the corresponding software.
最后，基于TI公司的DSP芯片TMS320F 2812和IR公司的驱动芯片IR 2133设计了直流无刷电动机控制系统的硬件电路，并编写了相应的软件。
After the block diagram discussed, the hardware and software structure are demonstrated, the designs of the circuits based on the motor control chip.
论文在给出整体的结构框架后，详细介绍了控制卡的硬件软件组成。
The step motor controller composed of buffer register, the circular allotter, the control logic, the positive run and back run control circuits is replaced by computer software.
由缓冲寄存器、环形分配器、控制逻辑及正反转控制门组成的步进电机控制器则用计算机软件替代。
The system bandwidth of conventional voltage-control-mode motor driver circuits is limited by the intrinsic frequency of the load, and its phase lag is also load-dependent.
传统电压控制模式的电机驱动电路系统频率都受电机的本征频率制约，其相位延迟会随负载的变化而变化。
This paper describes a vector control system scheme of an induction motor drive with multimicroprocessor, The system hardware circuits and their principles are introduced.
本文讨论了一种采用多微处理机实现的感应电动机矢量控制调速方案。
This paper describes a vector control system scheme of an induction motor drive with multimicroprocessor, The system hardware circuits and their principles are introduced.
本文讨论了一种采用多微处理机实现的感应电动机矢量控制调速方案。
应用推荐