The circuit mode is simple and low consumption.
该电路模式结构简单且功耗低。
An improved equivalent circuit mode more suitable for micro inductor with magnet - IC films is proposed.
提出了磁性薄膜电感器的改进型等效电路模型。
The purpose of the SSCS is to convey narrow-band calls consisting of voice, voiceband data, or circuit mode data.
SSCS的目的在于传递由语音、语音带宽数据或电路模式数据构成的窄带呼叫。
A average circuit mode control chip UC3854B is used to control each phase, thus the circuit and parameters are easy to design.
每个单相电路采用一片平均电流模式控制芯片uc 3854 B作为控制核心，电路简单，参数设计方便。
First, we analyse the power amplifier in theory in the circuit mode, biasing point linearity, thermal stability, input and output matching circuit.
论文首先从理论的方面对放大器的设计进行分析，对放大器的电路模型、偏置点、线性、热稳定性、输入输出匹配进行理论上的分析。
The ATM synthesize the advantage of circuit mode and package mode and base technology foundation for synthetic access of various multimedia service and high transport of information.
ATM技术综合了电路模式和分组模式的优点，为各种业务的综合接入和信息的高速传输提供了技术基础。
During the testing of the integrated circuit (404), it communicates in the wafer test mode.
在集成电路(404)的测试过程中，它在晶片测试模式下通信。
Placing the electrometer in the volts mode and then enabling external feedback switches the feedback circuit from an internal network to a feedback circuit connected to the preamp output.
将静电计置于电压模式，然后打开外部反馈，就把反馈电路从内部网络切换到连在前置放大器输出端的外部反馈网络上。
The operation mode of the circuit is analyzed and the condition of how to achieve soft switch is discussed, how to design the parameters of the snubber is presented as well.
对电路进行了工作模态分析，对于软开关的实现条件进行了讨论，给出了无源无损软开关环节参数的设计原则。
The conditions of voltage between contactors and current in main circuit under different using types are analyzed in detail, then designed the control sequences with working mode AC1-AC4.
详细分析了交流接触器在不同使用条件下的闭合与分断时触点两端电压与回路电流情况，并研究了AC1～AC4工作制下的控制时序。
It features with simple circuit, accurate position detection, immunity from noise and common mode disturbance and wide speed scope.
该控制系统的优点是电路简单，位置检测准确，免受噪声和共模干扰影响，调速范围增加。
The symmetric ternary current-mode CMOS circuits designed by using this theory not only have simpler circuit structures and correct logic functions, but also can process two-way signal.
应用该理论设计的对称三值电流型CMOS电路不仅具有简单的电路结构和正确的逻辑功能，而且能处理具有双向特性的信号。
Equipment designers can minimize the effects of these mismatches or "unbalances" through judicious choices of input and output stage circuit topologies and common-mode impedances.
设备设计师能通过审慎地选择输入输出级电路的拓扑和共模阻抗来最小化失配或“非平衡”的效应。
Introduces the circuit, program flow and operation sequence of the serial-scan mode static locking display.
介绍一种串行扫描方式静态锁存显示的电路、程序流程和工作时序。
The paper discussed the hardware, software and the pretreated circuitry of the system, expatiated the interface circuit and communication mode between AD and DSP.
论述了该系统的软硬件设计以及预处理电路，详细阐述了AD和DSP的接口电路以及通信方式。
It introduces the working theory of AC manostat of compensated transformer mode, the design of the hardware circuit and the function of the software.
介绍了补偿变压器方式的交流稳压器的工作原理、硬件电路的设计和软件的功能。
The intermittent control of wipers is related to the control switch, control relay and its control mode of the wipers operating circuit.
刮水器间歇控制与刮水器控制开关、刮水间歇控制继电器及其在刮水器工作电路中的控制方式有关。
Details of the sensor's structure, its working principle, the selection of working mode as well as the signal processing circuit is presented.
详细介绍了传感器的结构、工作原理、工作模式的选择以及信号检测电路。
The protect range is relational to short circuit type and phase when phase differential current connection mode is adopted.
当采用两相电流差接线方式时，保护范围与短路类型和短路相别有关。
Designs on motor field and structure, controller main circuit current commuting mode design, TMS320F240 least system and system program consider system normal operation under fault condition fully.
电机场路结构设计、控制器主回路换流模式设计、TMS320F 240最小系统设计、程序设计充分考虑了故障应急状态下系统正常运行必要条件。
The principle of active power factor correction circuit operated in critical inductor current mode is analyzed in this paper in detail.
文中详细分析了电感电流准连续模式的有源功率因数预校正电路的工作原理。
This paper introduces the theory of slope compensation and presents a piecewise linear slope compensation circuit for peak current mode boost DC-DC converter.
结合一款升压型直流-直流变换器，介绍了峰值电流模式中的斜坡补偿基本原理，提出了一种分段线性斜坡补偿电路。
The communication of substation secondary circuit is being transformed from metal cable analog mode to optic-electric digital mode.
变电站二次回路通信从金属电缆模拟通信方式逐步转变为光电数字化通信方式。
This paper introduces the functioning of crow bar circuit and its realization method, introduces different kinds of crowbar circuit and different working mode.
介绍了雷达发射机中撬棒电路的作用和实现方法，以及撬棒电路的种类和不同的工作方式。
The high-reactive mode of intensify EAF , is chief circuit frame of only economically advisable, which is preached to carry out, so far.
前言：强化电弧炉的“高阻抗”模式，是至今被倡导实现“超高功率化”唯一经济合理的主电路供电结构。
Introduces the theory basis, structure, circuit principle, working mode and characteristics of ultrasonic flowmeter we designed.
介绍了生产测井超声流量计设计的理论基础以及仪器结构、电路原理、工作方式和特点。
In this paper, by the use of dual-current control mode and intelligent UC3842 chip as the core, a single-chip switching power supply circuit are presented.
本文使用双电流控制模式，以智能芯片uc 3842为核心，设计了单片开关电源的实用电路。
In the case of repetition mode of the pulse power supply, Fast charging circuit is designed to enhance the stabilize and charging efficiency of the DC power supply.
为满足脉冲电源重复频率运行时直流电源的稳压性问题，设计了晶闸管快速充电自停自补单元，同时也提高了整个电源系统的效率。
Two main problems in designing the main circuit of switching mode excitation controller are peek voltage and over current of switching device.
开关式励磁调节器主回路设计中需要考虑的两个主要问题是开关器件的尖峰电压和冲击电流。
Two main problems in designing the main circuit of switching mode excitation controller are peek voltage and over current of switching device.
开关式励磁调节器主回路设计中需要考虑的两个主要问题是开关器件的尖峰电压和冲击电流。
应用推荐